1、Designation:D714317Standard Practice forEmission Cells for the Determination of Volatile OrganicEmissions from Indoor Materials/Products1This standard is issued under the fixed designation D7143;the number immediately following the designation indicates the year oforiginal adoption or,in the case of
2、 revision,the year of last revision.A number in parentheses indicates the year of last reapproval.Asuperscript epsilon()indicates an editorial change since the last revision or reapproval.INTRODUCTIONThis practice complements Guide D5116 and Practice D6670.1.Scope1.1 This practice is intended for de
3、termining volatile or-ganic compound(VOC)emissions from materials and productsusing emission cells.It can be applied in principle to mostconstruction materials and many products used indoors.Ob-jectives include:1.1.1 To provide manufacturers,builders,and end userswith emission data useful for evalua
4、ting the impact of buildingproducts,new or old,on indoor air concentrations in a modelroom.1.1.2 To promote the development of products with lowerVOC emissions.1.2 This practice is for identifying emitted VOCs and fordetermining the area specific emission rate of VOCs fromnewly produced building pro
5、ducts under defined climate con-ditions.The method can also be applied to aged products.1.3 In accordance with the definition of an emission cell,itis also possible to perform nondestructive emission measure-ments on building products on-site in buildings.However,theprocedure for such measurements i
6、s not described in thispractice.1.4 This practice describes the design,construction,perfor-mance evaluation and use of emission cells for VOC emissiontesting.Sampling,transport and storage of materials to betested,and preparation of test specimens are also described.1.5 Air sampling and analytical m
7、ethods for the determina-tion of VOCs are described in Practice D6196.Alternativesampling and analytical approaches for formaldehyde andother carbonyls are described in Test Method D5197.NOTE1All volatile(vapor-phase)carbonyls except formaldehyde canbe analyzed by either Practice D6196 or by Test Me
8、thod D5197.NOTE2Direct-reading instruments can also be applied for specificobjectives.NOTE3Some volatile inorganic compounds can,in principle,also beanalyzed(for example,ammonia).1.6 An example of an emission cell is described in Appen-dix X2 of this practice.1.7 The values stated in SI units are to
9、 be regarded asstandard.No other units of measurement are included in thisstandard.1.8 This international standard was developed in accor-dance with internationally recognized principles on standard-ization established in the Decision on Principles for theDevelopment of International Standards,Guide
10、s and Recom-mendations issued by the World Trade Organization TechnicalBarriers to Trade(TBT)Committee.2.Referenced Documents2.1 ASTM Standards:2D1356 Terminology Relating to Sampling and Analysis ofAtmospheresD1914 Practice for Conversion Units and Factors Relating toSampling and Analysis of Atmosp
11、heresD5116 Guide for Small-Scale Environmental Chamber De-terminations of Organic Emissions from Indoor Materials/ProductsD5197 Test Method for Determination of Formaldehyde andOther Carbonyl Compounds inAir(Active Sampler Meth-odology)D5337 Practice for Flow Rate Adjustment of Personal Sam-pling Pu
12、mpsD6196 Practice for Choosing Sorbents,Sampling Param-eters and Thermal Desorption Analytical Conditions forMonitoring Volatile Organic Chemicals in Air1This practice is under the jurisdiction ofASTM Committee D22 on Air Qualityand is the direct responsibility of Subcommittee D22.05 on Indoor Air.C
13、urrent edition approved March 1,2017.Published April 2017.Originallyapproved in 2005.Last previous edition approved in 2016 as D7143 11(2016).DOI:10.1520/D7143-17.2For referenced ASTM standards,visit the ASTM website,www.astm.org,orcontact ASTM Customer Service at serviceastm.org.For Annual Book of
14、ASTMStandards volume information,refer to the standards Document Summary page onthe ASTM website.Copyright ASTM International,100 Barr Harbor Drive,PO Box C700,West Conshohocken,PA 19428-2959.United StatesThis international standard was developed in accordance with internationally recognized princip
15、les on standardization established in the Decision on Principles for theDevelopment of International Standards,Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade(TBT)Committee.1 D6330 Practice for Determination of Volatile Organic Com-pounds(Excluding Forma
16、ldehyde)Emissions from Wood-Based Panels Using Small Environmental Chambers Un-der Defined Test ConditionsD6670 Practice for Full-Scale Chamber Determination ofVolatile Organic Emissions from Indoor Materials/ProductsD7339 Test Method for Determination of Volatile OrganicCompounds Emitted from Carpet using a Specific SorbentTube and Thermal Desorption/Gas Chromatography2.2 Others Standards and Documents:EN 196-1 Methods of Testing CementPart 1:Determina-tion of Strength3EN 428 Resilient Floor Co