1、Designation:D640199(Reapproved 2009)Standard Test Method forDetermining Non-Tannins and Tannin in Extracts ofVegetable Tanning Materials1This standard is issued under the fixed designation D6401;the number immediately following the designation indicates the year oforiginal adoption or,in the case of
2、 revision,the year of last revision.A number in parentheses indicates the year of last reapproval.Asuperscript epsilon()indicates an editorial change since the last revision or reapproval.1.Scope1.1 This test method is intended for use in determining thequantity of soluble non-tannins and tannin in
3、solutions oftannin extracts,water extracts of vegetable tanning materials,or tanning liquors.The method is applicable to the analysis ofliquid,solid,pasty,and powdered extracts and to extracts ofraw or spent materials.1.2 The values stated in SI units are to be regarded as thestandard.The inch-pound
4、 units given in parentheses are forinformation only.1.3 This standard does not purport to address all of thesafety concerns,if any,associated with its use.It is theresponsibility of the user of this standard to establish appro-priate safety and health practices and determine the applica-bility of re
5、gulatory limitations prior to use.2.Referenced Documents2.1 ASTM Standards:2D2617 Test Method for Total Ash in LeatherD4901 Practice for Preparation of Solution of Liquid Veg-etable Tannin ExtractsD4902 Test Method for Evaporation and Drying of Analyti-cal SolutionsD4903 Test Method for Total Solids
6、 and Water in VegetableTanning Material ExtractsD4905 Practice for Preparation of Solution of Solid,Pastyand Powdered Vegetable Tannin ExtractsD6402 Test Method for Determining Soluble Solids andInsolubles in Extracts of Vegetable Tanning MaterialsD6405 Practice for Extraction of Tannins from Raw an
7、dSpent Materials2.2 ALCA Method:A22 Non-Tannins and Tannin33.Terminology3.1 Definitions:3.1.1 soluble non-tanninsnon-volatile materials present intannin extracts and raw or spent materials that are dissolved orsuspended in water,are part of the soluble solids determined byTest Method D6402,and do no
8、t react with or bind to hidepowder when mixed as in this test method.3.1.2 tanninsnon-volatile materials present in tannin ex-tracts and raw or spent materials that are dissolved or sus-pended in water,are part of the soluble solids determined byTest Method D6402,and do react with or bind to hide po
9、wderwhen mixed as in this test method.4.Summary of Test Method4.1 An aliquot of the analytical solution prepared fromtannin extracts(Practices D4901 or D4905)or of the waterextract from raw or spent materials(Practice D6405)is driedovernight in a forced-air oven(Test Method D4902)and thesolid residu
10、e remaining is determined and defined as the totalsolids for that sample(Test Method D4903).Another aliquot ofthe same solution is passed through a specified filteringprocedure and the quantity of solid residue remaining in thefiltrate is determined and defined as the soluble solids for thatsample;t
11、he calculated difference between the total solids andthe soluble solids is defined as the insolubles for that sample(Test Method D6402).Another aliquot of the original analyti-cal solution or water extract is mixed with a prepared hidepowder material with the resulting solution being passedthrough t
12、he same filtering procedure as for the soluble solidsanalysis.The quantity of solid residue remaining in the filtrateis determined and defined as the soluble non-tannins for thatsample;the calculated difference between the total solublesolids and the soluble non-tannins is defined as the tanninconte
13、nt for that sample.1This test method is under the jurisdiction of ASTM Committee D31 on Leatherand is the direct responsibility of Subcommittee D31.01 on Vegetable Leather.Thismethod has been adapted from and is a replacement for Method A22 of the OfficialMethods of the American Leather Chemists Ass
14、ociation.Current edition approved April 1,2009.Published July 2009.Originallyapproved in 1999.Last previous edition approved in 2004 as D6401 99(2004).DOI:10.1520/D6401-99R09.2For referenced ASTM standards,visit the ASTM website,www.astm.org,orcontact ASTM Customer Service at serviceastm.org.For Ann
15、ual Book of ASTMStandards volume information,refer to the standards Document Summary page onthe ASTM website.3Official Methods of the American Leather Chemists Association.Availablefrom the American Leather Chemists Association,University of Cincinnati,P.O.Box 210014,Cincinnati,OH 45221-0014.Copyrig
16、ht ASTM International,100 Barr Harbor Drive,PO Box C700,West Conshohocken,PA 19428-2959.United States1 5.Significance and Use5.1 This test method is used to determine the proportion ofthe total soluble solids which are soluble non-tannins and theproportion which are tannins in a solution of tannin extract orin the water extract from raw or spent materials prepared fortannin analysis.5.2 The specimens are aliquots from the analytical solutionsprepared from tannin extracts or the water extract sol