ImageVerifierCode 换一换
格式:PDF , 页数:5 ,大小:108.25KB ,
资源ID:175161      下载积分:11 积分
快捷下载
登录下载
邮箱/手机:
温馨提示:
快捷下载时,用户名和密码都是您填写的邮箱或者手机号,方便查询和重复下载(系统自动生成)。 如填写123,账号就是123,密码也是123。
特别说明:
请自助下载,系统不会自动发送文件的哦; 如果您已付费,想二次下载,请登录后访问:我的下载记录
支付方式: 支付宝扫码支付 微信扫码支付   
验证码:   换一换

加入VIP,免费下载
 

温馨提示:由于个人手机设置不同,如果发现不能下载,请复制以下地址【https://www.wnwk.com/docdown/175161.html】到电脑端继续下载(重复下载不扣费)。

已注册用户请登录:
账号:
密码:
验证码:   换一换
  忘记密码?
三方登录: QQ登录  

下载须知

1: 本站所有资源如无特殊说明,都需要本地电脑安装OFFICE2007和PDF阅读器。
2: 试题试卷类文档,如果标题没有明确说明有答案则都视为没有答案,请知晓。
3: 文件的所有权益归上传用户所有。
4. 未经权益所有人同意不得将文件中的内容挪作商业或盈利用途。
5. 本站仅提供交流平台,并不能对任何下载内容负责。
6. 下载文件中如有侵权或不适当内容,请与我们联系,我们立即纠正。
7. 本站不保证下载资源的准确性、安全性和完整性, 同时也不承担用户因使用这些下载资源对自己和他人造成任何形式的伤害或损失。

版权提示 | 免责声明

本文(ASTM_D_6035_-_D_6035M_-_13.pdf)为本站会员(益****师)主动上传,蜗牛文库仅提供信息存储空间,仅对用户上传内容的表现方式做保护处理,对上载内容本身不做任何修改或编辑。 若此文所含内容侵犯了您的版权或隐私,请立即通知蜗牛文库(发送邮件至admin@wnwk.com或直接QQ联系客服),我们立即给予删除!

ASTM_D_6035_-_D_6035M_-_13.pdf

1、Designation:D6035/D6035M13Standard Test Method forDetermining the Effect of Freeze-Thaw on HydraulicConductivity of Compacted or Intact Soil Specimens Usinga Flexible Wall Permeameter1This standard is issued under the fixed designation D6035/D6035M;the number immediately following the designation in

2、dicates theyear of original adoption or,in the case of revision,the year of last revision.A number in parentheses indicates the year of lastreapproval.A superscript epsilon()indicates an editorial change since the last revision or reapproval.1.Scope*1.1 This test method covers laboratory measurement

3、 of theeffect of freeze-thaw on the hydraulic conductivity of com-pacted or intact soil specimens using Test Method D5084 anda flexible wall permeameter to determine hydraulic conductiv-ity.This test method does not provide steps to performsampling of,or testing of,in situ soils that have already be

4、ensubjected to freeze-thaw conditions.1.2 This test method may be used with intact specimens(block or thin-walled)or laboratory compacted specimens andshall be used for soils that have an initial hydraulic conduc-tivity less than or equal to 1E-5 m/s 3.94 E-4 in./s(1E-3 cm/s)(Note 1).NOTE1The maximu

5、m initial hydraulic conductivity is given as 1 E-5m/s 3.94 E-4 in./s.This should also apply to the final hydraulicconductivity.It is expected that if the initial hydraulic conductivity is 1E-5 m/s(3.94 E-4 in./s),then the final hydraulic conductivity will notchange(increase)significantly(that is,gre

6、ater than 1 E-5 m/s)(3.94 E-4in./s).1.3 Soil specimens tested using this test method can besubjected to three-dimensional freeze-thaw(herein referred toas 3-d)or one-dimensional freeze-thaw(herein referred to as1-d).(For a discussion of one-dimensional freezing versusthree-dimensional freezing,refer

7、 to Zimmie2or Othman.3)1.4 Soil specimens tested using this test method can betested in a closed system(that is,no access to an externalsupply of water during freezing)or an open system.1.5 All observed and calculated values shall conform to theguidelines for significant digits and rounding establis

8、hed inPractice D6026.1.6 The values stated in SI units or inch-pound units(presented in brackets)are to be regarded separately asstandard.The values stated in each system may not be exactequivalents;therefore,each system shall be used independentlyof the other.Combining values from the two systems m

9、ayresult in non-conformance with the standard.Reporting of testresults in units other than SI shall not be regarded as concon-formance with this test method.1.7 This standard does not purport to address all of thesafety concerns,if any,associated with its use.It is theresponsibility of the user of t

10、his standard to establish appro-priate safety and health practices and determine the applica-bility of regulatory limitations prior to use.2.Referenced Documents2.1 ASTM Standards:4D653 Terminology Relating to Soil,Rock,and ContainedFluidsD1587 Practice for Thin-Walled Tube Sampling of Soils forGeot

11、echnical PurposesD2113 Practice for Rock Core Drilling and Sampling ofRock for Site ExplorationD2216 Test Methods for Laboratory Determination of Water(Moisture)Content of Soil and Rock by MassD3740 Practice for Minimum Requirements for AgenciesEngaged in Testing and/or Inspection of Soil and Rock a

12、sUsed in Engineering Design and ConstructionD4220 Practices for Preserving and Transporting SoilSamples1This test method is under the jurisdiction ofASTM Committee D18 on Soil andRock and is the direct responsibility of Subcommittee D18.19 on Frozen Soils andRock.Current edition approved Aug.15,2013

13、.Published September 2013.Originallyapproved in 1996.Last previous edition approved in 2008 as D6035 08.DOI:10.1520/D6035_D6035M-13.2Zimmie,T.F.,and La Plante,C.,“The Effect of Freeze/Thaw Cycles on thePermeability of a Fine-Grained Soil,”Hazardous and Industrial Wastes,Proceed-ings of the Twenty-Se

14、cond Mid-Atlantic Industrial Waste Conference,Joseph P.Martin,Shi-Chieh Cheng,and Mary Ann Susavidge,eds.,Drexel University,1990,pp.580593.3Othman,M.A.,Benson,C.H.,Chamberlain,E.J.,and Zimmie,T.F.,“Laboratory Testing to Evaluate Changes in Hydraulic Conductivity of CompactedClays Caused by Freeze-Th

15、aw:State-of-the-Art,”Hydraulic Conductivity andWaste Contaminant Transport in Soils,ASTM STP 1142,David E.Daniel,andStephen J.Trautwein,eds.,American Society for Testing and Materials,Conshohocken,PA,pp.227254.4For referenced ASTM standards,visit the ASTM website,www.astm.org,orcontact ASTM Customer

16、 Service at serviceastm.org.For Annual Book of ASTMStandards volume information,refer to the standards Document Summary page onthe ASTM website.*A Summary of Changes section appears at the end of this standardCopyright ASTM International,100 Barr Harbor Drive,PO Box C700,West Conshohocken,PA 19428-2959.United States1 D5084 Test Methods for Measurement of Hydraulic Con-ductivity of Saturated Porous Materials Using a FlexibleWall PermeameterD6026 Practice for Using Significant Digits in Geotechnic

copyright@ 2008-2023 wnwk.com网站版权所有

经营许可证编号:浙ICP备2024059924号-2