1、Designation:D291320Standard Test Method forMercaptan Content of the Atmosphere1This standard is issued under the fixed designation D2913;the number immediately following the designation indicates the year oforiginal adoption or,in the case of revision,the year of last revision.A number in parenthese
2、s indicates the year of last reapproval.Asuperscript epsilon()indicates an editorial change since the last revision or reapproval.1.Scope1.1 This test method is for the measurement of mercaptans(organic thiols)in the atmosphere at concentrations below 100parts per billion(ppb(v)=195 g/m3).For concen
3、trationsabove 100 ppb(v),the sampling period can be reduced or thetrapping liquid volume increased either before or after aspirat-ing.(See Practice D1357 for sampling guidance.)The mini-mum detectable amount of methyl mercaptan is 0.04 g/mL(1)2in a final liquid volume of 25 mL.When sampling air atth
4、e maximum recommended rate of 2 L/min for 2 h,theminimum detectable mercaptan concentration is 1.0 ppb(v)(1.95 g methyl mercaptan/m3at 101.3 kPa(760 mm Hg)and25C).This test method determines total mercaptans and doesnot differentiate among individual mercaptans,although it ismost sensitive to the lo
5、wer molecular weight alkanethiols.1.2 The values stated in SI units are to be regarded asstandard.No other units of measurement are included in thisstandard.1.3 This standard does not purport to address all of thesafety concerns,if any,associated with its use.It is theresponsibility of the user of t
6、his standard to establish appro-priate safety,health,and environmental practices and deter-mine the applicability of regulatory limitations prior to use.Specific precautionary statements are given in 8.7,8.8,andSection 9.1.4 This international standard was developed in accor-dance with international
7、ly recognized principles on standard-ization established in the Decision on Principles for theDevelopment of International Standards,Guides and Recom-mendations issued by the World Trade Organization TechnicalBarriers to Trade(TBT)Committee.2.Referenced Documents2.1 ASTM Standards:3D1193 Specificati
8、on for Reagent WaterD1356 Terminology Relating to Sampling and Analysis ofAtmospheresD1357 Practice for Planning the Sampling of the AmbientAtmosphereD1914 Practice for Conversion Units and Factors Relating toSampling and Analysis of AtmospheresD2914 Test Methods for Sulfur Dioxide Content of theAtm
9、osphere(West-Gaeke Method)D3195 Practice for Rotameter CalibrationD3249 Practice for General Ambient Air Analyzer Proce-duresD3609 Practice for Calibration Techniques Using Perme-ation TubesD3631 Test Methods for Measuring Surface AtmosphericPressureE2251 Specification for Liquid-in-Glass ASTM Therm
10、om-eters with Low-Hazard Precision Liquids3.Terminology3.1 DefinitionsFor definitions of terms used in this testmethod,refer to Terminology D1356.4.Summary of Test Method4.1 This test method is intended for obtaining an integratedsample over a selected time span(such as 2 h)either manuallyor in an a
11、utomatic sequential sampler using 10 mL of absorp-tion liquid in a bubbler.4.2 The absorption liquid is delivered to the laboratory forcolorimetric analysis by reaction between the collected mer-captan and N,N-dimethyl-p-phenylenediamine.1This test method is under the jurisdiction of ASTM Committee
12、D22 on AirQuality and is the direct responsibility of Subcommittee D22.03 on AmbientAtmospheres and Source Emissions.Current edition approved Sept.1,2020.Published September 2020.Originallyapproved in 1970.Last previous edition approved in 2014 as D2913 14.DOI:10.1520/D2913-20.2The boldface numbers
13、in parentheses refer to a list of references at the end ofthis standard.3For referenced ASTM standards,visit the ASTM website,www.astm.org,orcontact ASTM Customer Service at serviceastm.org.For Annual Book of ASTMStandards volume information,refer to the standards Document Summary page onthe ASTM we
14、bsite.Copyright ASTM International,100 Barr Harbor Drive,PO Box C700,West Conshohocken,PA 19428-2959.United StatesThis international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for theDevelopment of Inte
15、rnational Standards,Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade(TBT)Committee.15.Significance and Use5.1 Mercaptans are odorous substances offensive at lowconcentrations and toxic at higher levels.They are emittedfrom geothermal sources,industrial pr
16、ocesses,and food pro-cessing facilities.Mercaptans at low concentrations are com-monly added to natural gas and LP gases for safety purposes aswell.6.Interferences6.1 The N,N-dimethyl-p-phenylenediamine reaction is alsoused in the determination of other sulfur-containing com-pounds including hydrogen sulfide and dimethyl disulfide(2).The potential for interference from these latter compounds isespecially important,since all of these compounds commonlycoexist in certain industrial emissions.Appro