ImageVerifierCode 换一换
格式:PDF , 页数:3 ,大小:77.05KB ,
资源ID:185660      下载积分:13 积分
快捷下载
登录下载
邮箱/手机:
温馨提示:
快捷下载时,用户名和密码都是您填写的邮箱或者手机号,方便查询和重复下载(系统自动生成)。 如填写123,账号就是123,密码也是123。
特别说明:
请自助下载,系统不会自动发送文件的哦; 如果您已付费,想二次下载,请登录后访问:我的下载记录
支付方式: 支付宝扫码支付 微信扫码支付   
验证码:   换一换

加入VIP,免费下载
 

温馨提示:由于个人手机设置不同,如果发现不能下载,请复制以下地址【https://www.wnwk.com/docdown/185660.html】到电脑端继续下载(重复下载不扣费)。

已注册用户请登录:
账号:
密码:
验证码:   换一换
  忘记密码?
三方登录: QQ登录  

下载须知

1: 本站所有资源如无特殊说明,都需要本地电脑安装OFFICE2007和PDF阅读器。
2: 试题试卷类文档,如果标题没有明确说明有答案则都视为没有答案,请知晓。
3: 文件的所有权益归上传用户所有。
4. 未经权益所有人同意不得将文件中的内容挪作商业或盈利用途。
5. 本站仅提供交流平台,并不能对任何下载内容负责。
6. 下载文件中如有侵权或不适当内容,请与我们联系,我们立即纠正。
7. 本站不保证下载资源的准确性、安全性和完整性, 同时也不承担用户因使用这些下载资源对自己和他人造成任何形式的伤害或损失。

版权提示 | 免责声明

本文(ASTM_C_1416_-_04_2009.pdf)为本站会员(益****师)主动上传,蜗牛文库仅提供信息存储空间,仅对用户上传内容的表现方式做保护处理,对上载内容本身不做任何修改或编辑。 若此文所含内容侵犯了您的版权或隐私,请立即通知蜗牛文库(发送邮件至admin@wnwk.com或直接QQ联系客服),我们立即给予删除!

ASTM_C_1416_-_04_2009.pdf

1、Designation:C141604(Reapproved 2009)StandardTest Method forUranium Analysis Waste Water by X-ray Fluorescence1This standard is issued under the fixed designation C1416;the number immediately following the designation indicates the year oforiginal adoption or,in the case of revision,the year of last

2、revision.A number in parentheses indicates the year of last reapproval.Asuperscript epsilon()indicates an editorial change since the last revision or reapproval.1.Scope1.1 This test method applies for the determination of traceuranium content in waste water.It covers concentrations of Ubetween 0.05

3、mg/L and 2 mg/L.1.2 The values stated in SI units are to be regarded asstandard.No other units of measurement are included in thisstandard.1.3 This standard does not purport to address all of thesafety concerns,if any,associated with its use.It is theresponsibility of the user of this standard to es

4、tablish appro-priate safety and health practices and determine the applica-bility of regulatory limitations prior to use.2.Summary of Test Method2.1 Uranyl cations are collected on ion exchange cellulosephosphate papers by circulating the water to be analysedthrough the paper with a peristaltic pump

5、.After drying,theuranium is determined using X-ray fluorescence.3.Significance and Use3.1 Uranium production facilities must control trace ura-nium content in their waste waters.3.2 Colorimetric and fluorimetric methods have been devel-oped but require a tedious separation of interfering elements.Tr

6、ace uranium can also be determined by ICP-MS but not allwater matrices are adapted(for example,waters with high saltcontent).Direct X-ray fluorescence can be done on the liquidbut with a detection limit of;5 mg/L3.3 X-ray fluorescence after collection of uranium offers theadvantages to reach low det

7、ection limits(0.05 mg/L)and toavoid handling a liquid in the spectrometer.4.Interferences4.1 Uranium is collected on the paper by the precipitation ofa uranyl phosphate complex at pH=2.5.Other cations(forexample,Pb,Bi,Sn,Zr,As,.)having a low phosphatesolubility at low pH are also collected and will

8、interfere only atlarge concentration(the maximum capacity of the paper is 8.5eq/cm2).As an example,for a solution containing 1 mg/L ofeach Pb,Bi,Sn,Zr,andAs,and 0.3 mg/L of uranium,a bias of5%was detected on the uranium content.See also 9.2.4.2 Other elements such as Fe,Cu,Ni,Al,Cr.,which havea high

9、er phosphate solubility at low pH were found to have noeffect even at concentration of 10 mg/L.4.3 The excess of anions forming strong complexes with theuranyl cation can also bias the uranium determination.As anexample,for a solution containing 100 mg/L of F(added asNaF)and 0.3 mg/L of uranium,a bi

10、as of 30%was found onthe uranium determination.On the contrary,anions formingweak uranyl complexes(such as SO42-,Cl.)were seen tohave no effect even at concentration of several g/L.5.Apparatus5.1 Wavelength dispersive X-ray fluorescence spectrometerequipped with a LiF(200)crystal,a molybdenum,tungst

11、en orrhodium target tube and a scintillation detector.NOTE1Energy dispersive instruments may be applicable.5.2 Peristaltic pump capable of achieving a flow rate of 50mL/min.5.3 A filtration apparatus which comprises a filter holder,a250 mL flask located on top of the filter,and a pipe on bottomof th

12、e filter connected to the peristaltic pump.The sample to beanalyzed is poured in the flask,flows through the phosphatefilter and the liquid collected on bottom is brought back to theflask through the peristaltic pump.5.4 Pipet0.2 mL,1 mL,5 mL,10 mL,20 mL.25.5 pH-meter.5.6 100 mL volumetric flasks.6.

13、Reagents and Materials6.1 Purity of MaterialsReagent grade chemicals shall beused in all tests.Unless otherwise indicated,it is intended thatall reagents conform to the specification of the Committee onAnalytical Reagents of the American Chemical Society where1This test method is under the jurisdict

14、ion ofASTM Committee C26 on NuclearFuel Cycle and is the direct responsibility of Subcommittee C26.05 on Methods ofTest.Current edition approved June 1,2009.Published July 2009.Originally approvedin 1999.Last previous edition approved in 2004 as C1416 04.DOI:10.1520/C1416-04R09.2Dilution detailed in

15、 6.5 and 6.7 may also be done by weight.In that case,pipetsare not necessary.Copyright ASTM International,100 Barr Harbor Drive,PO Box C700,West Conshohocken,PA 19428-2959.United StatesNOTICE:This standard has either been superseded and replaced by a new version or withdrawn.Contact ASTM Internation

16、al(www.astm.org)for the latest information1 such specifications are available.3Other grades may be usedprovided it is first ascertained that the reagent is of sufficientlyhigh purity to permit its use without lessening the accuracy ofthe determination.6.2 Purity of WaterConventional distilled water is foundacceptable for this analysis.6.3 Phosphate paper filters.46.4 Concentrated hydrochloric acid,12.1 M(sp gr 1.187).6.5 Diluted hydrochloric acid,5 M.Add 41 mL of concen-trated hydrochloric acid(

copyright@ 2008-2023 wnwk.com网站版权所有

经营许可证编号:浙ICP备2024059924号-2