1、 Reference numberISO/IEC 13170:2009(E)ISO/IEC 2009 INTERNATIONAL STANDARD ISO/IEC13170First edition2009-11-01Information technology 120 mm(8,54 Gbytes per side)and 80 mm(2,66 Gbytes per side)DVD re-recordable disk for dual layer(DVD-RW for DL)Technologies de linformation Disque DVD renregistrable de
2、 120 mm(8,54 Go par face)et 80 mm(2,66 Go par face)pour double couche(DVD-RW pour DL)ISO/IEC 13170:2009(E)PDF disclaimer This PDF file may contain embedded typefaces.In accordance with Adobes licensing policy,this file may be printed or viewed but shall not be edited unless the typefaces which are e
3、mbedded are licensed to and installed on the computer performing the editing.In downloading this file,parties accept therein the responsibility of not infringing Adobes licensing policy.The ISO Central Secretariat accepts no liability in this area.Adobe is a trademark of Adobe Systems Incorporated.D
4、etails of the software products used to create this PDF file can be found in the General Info relative to the file;the PDF-creation parameters were optimized for printing.Every care has been taken to ensure that the file is suitable for use by ISO member bodies.In the unlikely event that a problem r
5、elating to it is found,please inform the Central Secretariat at the address given below.COPYRIGHT PROTECTED DOCUMENT ISO/IEC 2009 All rights reserved.Unless otherwise specified,no part of this publication may be reproduced or utilized in any form or by any means,electronic or mechanical,including ph
6、otocopying and microfilm,without permission in writing from either ISO at the address below or ISOs member body in the country of the requester.ISO copyright office Case postale 56 CH-1211 Geneva 20 Tel.+41 22 749 01 11 Fax +41 22 749 09 47 E-mail copyrightiso.org Web www.iso.org Published in Switze
7、rland ii ISO/IEC 2009 All rights reserved ISO/IEC 13170:2009(E)ISO/IEC 2009 All rights reserved iii Contents Page Foreword.vii Introduction.viii 1 Scope.12 Conformance.12.1 Optical Disk.12.2 Generating system.22.3 Receiving system.23 Normative references.24 Terms and definitions.25 Conventions and n
8、otations.55.1 Representation of numbers.55.2 Names.66 Acronyms.67 General description of a disk.78 General requirement.88.1 Environments.88.1.1 Test environment.88.1.2 Operating environment.88.1.3 Storage environment.98.1.4 Transportation.98.2 Safety requirements.98.3 Flammability.109 Reference meas
9、urement devices.109.1 Pick-Up Head(PUH).109.1.1 PUH for measuring recorded disks.109.1.2 PUH for measuring unrecorded disks.129.2 Measurement conditions.139.2.1 Recorded and unrecorded disk.139.2.2 Recorded disk.139.2.3 Unrecorded disk.139.3 Normalized servo transfer function.149.4 Reference servo f
10、or axial tracking.149.4.1 Recorded disk.149.4.2 Unrecorded disk.169.5 Reference servo for radial tracking.179.5.1 Recorded disk.179.5.2 Unrecorded disk.1810 Dimensional characteristics.1910.1 Overall dimensions.2110.2 First transition area.2110.3 Second transition area.2210.4 Clamping Zone.2210.5 Th
11、ird transition area.2210.6 R-Information Zone.2310.6.1 Sub-divisions of the R-Information Zone.2310.7 Information Zone.2310.7.1 Sub-divisions of the Information zone.23ISO/IEC 13170:2009(E)iv ISO/IEC 2009 All rights reserved 10.8 Track geometry.2410.8.1 Track Path.2510.9 Channel bit length.2510.10 R
12、im area.2510.11 Remark on tolerances.2610.12 Label.2611 Mechanical parameters.2611.1 Mass.2611.2 Moment of inertia.2611.3 Dynamic imbalance.2611.4 Sense of rotation.2611.5 Runout.2711.5.1 Axial runout.2711.5.2 Radial runout.2712 Optical parameters.2712.1 Recorded and unrecorded disk parameters.2712.
13、1.1 Index of refraction.2712.1.2 Thickness of the transparent substrate.2712.1.3 Angular deviation.2812.1.4 Birefringence of the transparent substrate.2812.2 Recorded disk reflectivity.2912.3 Unrecorded disk parameters.2912.3.1 Polarity of reflectivity modulation.2912.3.2 Recording power sensitivity
14、 variation.2913 Operational signals for recorded disk.2913.1 Measurement conditions.2913.2 Read conditions.2913.3 Recorded disk high frequency(HF)signals.2913.3.1 Modulated amplitude.2913.3.2 Signal asymmetry.3013.3.3 Cross-track signal.3013.4 Quality of signals.3013.4.1 Jitter.3013.4.2 Random error
15、s.3113.4.3 Defects.3113.5 Servo signals.3113.5.1 Differential phase tracking error signal.3113.5.2 Tangential push-pull signal.3213.6 Groove wobble signal.3314 Operational signals for the unrecorded disk.3414.1 Measurement conditions.3414.2 Recording conditions.3414.3 Write strategy for media testin
16、g.3414.3.1 Write strategy for Layer 0.3514.3.2 Write strategy for Layer 1.3514.3.3 Definition of the write pulse.3714.4 Servo signals.3814.4.1 Radial push-pull tracking error signal.3814.4.2 Defects.3914.5 Addressing signals.4014.5.1 Land Pre-Pit signal.4014.5.2 Groove wobble signal.4114.5.3 Relation in phase between wobble and Land Pre-Pit.4215 Operational signals for Embossed Zone.4315.1 Operational signals from the Control data blocks.4315.1.1 Measurement conditions.4315.1.2 Read conditions.4