1、Information technology UPnP Device Architecture Part 26-13:Telephony device control protocol Level 2 Phone management serviceTechnologies de linformation Architecture de dispositif UPnP Partie 26-13:Protocole de contrle de dispositif de tlphonie Niveau 2 Service de gestion du tlphoneINTERNATIONAL ST
2、ANDARDISO/IEC 29341-26-13Reference numberISO/IEC 29341-26-13:2017(E)First edition2017-09 ISO/IEC 2017 ii ISO/IEC 2017 All rights reservedCOPYRIGHT PROTECTED DOCUMENT ISO/IEC 2017,Published in SwitzerlandAll rights reserved.Unless otherwise specified,no part of this publication may be reproduced or u
3、tilized otherwise in any form or by any means,electronic or mechanical,including photocopying,or posting on the internet or an intranet,without prior written permission.Permission can be requested from either ISO at the address below or ISOs member body in the country of the requester.ISO copyright
4、officeCh.de Blandonnet 8 CP 401CH-1214 Vernier,Geneva,SwitzerlandTel.+41 22 749 01 11Fax+41 22 749 09 47copyrightiso.orgwww.iso.orgISO/IEC 29341-26-13:2017(E)ISO/IEC 29341-26-13:2017(E)ISO/IEC 2017 All rights reserved iii CONTENTS 1Scope.iv2Normative references.13Terms,definitions,symbols and abbrev
5、iated terms.24Notations and conventions.34.1Notation.34.1.1Data Types.34.2Vendor-defined Extensions.45ConfigurationManagement Service Profile.45.1Service Type.45.2PhoneManagement Architecture.45.2.1Phone Management.55.2.2Phone Data Model.55.3State Variables.65.4Actions.75.4.1Introduction.75.4.2GetSe
6、lectedValues().85.4.3SetValues().85.4.4CreateInstance().85.4.5DeleteInstance().95.4.6SetAttributes().96XML Service Description.9Annex A(normative)Phone Data Model.10Annex B(informative)Theory of Operation.57Annex C(informative)Bibliography.71 Figure 1 PhoneManagement via CMS and Phone Data Model.4Fi
7、gure A.1 Overview of the Phone Data Model.11 Table 1 State Variables for Eventing.7Table 2 Actions.7Table A.1 The Phone Data Model.12 ISO/IEC 29341-26-13:2017(E)iv ISO/IEC 2017 All rights reserved Foreword ISO(the International Organization for Standardization)and IEC(the InternationalElectrotechnic
8、alCommission)formthespecializedsystemforworldwidestandardization.National bodies that are members of ISO or IEC participate in the development ofInternational Standards through technical committees established by the respectiveorganization to deal with particular fields of technical activity.ISO and
9、 IEC technicalcommittees collaborate in fields of mutual interest.Other international organizations,governmental and nongovernmental,in liaison with ISO and IEC,also take part in thework.Inthefieldofinformationtechnology,ISOandIEChaveestablishedajointtechnicalcommittee,ISO/IECJTC1.The procedures use
10、d to develop this document and those intended for its furthermaintenancearedescribedintheISO/IECDirectives,Part1.Inparticularthedifferentapproval criteria needed for the different types of document should be noted.ThisdocumentwasdraftedinaccordancewiththeeditorialrulesoftheISO/IECDirectives,Part2(se
11、ehttp:/www.iso.org/directives).Attentionisdrawntothepossibilitythatsomeoftheelementsofthisdocumentmaybethesubjectofpatentrights.ISOandIECshallnotbeheldresponsibleforidentifyinganyorallsuchpatentrights.DetailsofanypatentrightsidentifiedduringthedevelopmentofthedocumentwillbeintheIntroductionand/oront
12、heISOlistofpatentdeclarationsreceived(seewww.iso.org/patents).Anytradenameusedinthisdocumentisinformationgivenfortheconvenienceofusersanddoesnotconstituteanendorsement.ForanexplanationonthevoluntarynatureofStandard,themeaningoftheISOspecifictermsandexpressionsrelatedtoconformityassessment,aswellasin
13、formationaboutISOsadherencetotheWTOprinciplesintheTechnicalBarrierstoTrade(TBT)seethefollowingURL:ForewordSupplementaryinformationISO/IEC293412613 was prepared by UPnP Forum and adopted,under the PASprocedure,by joint technical committee ISO/IEC JTC 1,Information technology,inparallelwithitsapproval
14、bynationalbodiesofISOandIEC.ThelistofallcurrentlyavailablepartsofISO/IEC29341series,underthegeneraltitleInformation technology UPnP Device Architecture,canbefoundontheISOwebsite.ISO/IEC 29341-26-13:2017(E)ISO/IEC 2017 All rights reserved v Introduction ISO and IEC draw attention to the fact that it
15、is claimed that compliance with this document may involve the use of patents as indicated below.ISO and IEC take no position concerning the evidence,validity and scope of these patent rights.The holders of-these patent rights have assured ISO and IEC that they are willing to negotiate licenses under
16、 reasonable and non-discriminatory terms and conditions with applicants throughout the world.In this respect,the statements of the holders of these patent rights are registered with ISO and IEC.Intel Corporation has informed IEC and ISO that it has patent applications or granted patents.Information may be obtained from:Intel Corporation Standards Licensing Department 5200 NE Elam Young Parkway MS:JFS-98 USA Hillsboro,Oregon 97124 Microsoft Corporation has informed IEC and ISO that it has patent