1、Designation:E2556/E2556M10Standard Specification forVapor Permeable Flexible Sheet Water-Resistive BarriersIntended for Mechanical Attachment1This standard is issued under the fixed designation E2556/E2556M;the number immediately following the designation indicates the yearof original adoption or,in
2、 the case of revision,the year of last revision.A number in parentheses indicates the year of last reapproval.A superscript epsilon()indicates an editorial change since the last revision or reapproval.1.Scope1.1 This specification is limited to vapor permeable flexiblesheet materials which are inten
3、ded to be mechanically attachedand are generally installed behind the cladding system inexterior walls.1.2 This specification is limited to the evaluation of mate-rials and does not address installed performance.Although thefastening practices(type of fastener,fastening schedule,etc.)may affect the
4、installed function of these materials,they are notincluded in this specification.1.3 This specification does not address integration of thewater-resistive barrier with other wall elements.The topic isaddressed in more detail in Practice E2112 and Guide E2266.1.4 The values stated in either SI units
5、or inch-pound unitsare to be regarded separately as standard.The values stated ineach system may not be exact equivalents;therefore,eachsystem shall be used independently of the other.Combiningvalues from the two systems may result in non-conformancewith the standard.1.5 This standard does not purpo
6、rt to address all of thesafety concerns,if any,associated with its use.It is theresponsibility of the user of this standard to establish appro-priate safety and health practices and determine the applica-bility of regulatory limitations prior to use.2.Referenced Documents2.1 ASTM Standards:2D226 Spe
7、cification for Asphalt-Saturated Organic Felt Usedin Roofing and WaterproofingD779 TestMethodfor WaterResistanceofPaper,Paperboard,and Other Sheet Materials by the Dry Indi-cator Method(Withdrawn 2011)3D828 Test Method for Tensile Properties of Paper andPaperboard Using Constant-Rate-of-ElongationAp
8、paratus(Withdrawn 2009)3D882 Test Method for Tensile Properties of Thin PlasticSheetingD4869 Specification for Asphalt-Saturated Organic Felt Un-derlayment Used in Steep Slope RoofingD5034 Test Method for Breaking Strength and Elongation ofTextile Fabrics(Grab Test)E96/E96M Test Methods for Water Va
9、por Transmission ofMaterialsE631 Terminology of Building ConstructionsE1677 Specification forAir Barrier(AB)Material or Systemfor Low-Rise Framed Building WallsE2112 Practice for Installation of Exterior Windows,Doorsand SkylightsE2128 Guide for Evaluating Water Leakage of BuildingWallsE2136 Guide f
10、or Specifying and Evaluating Performance ofSingle Family Attached and Detached DwellingsDurabilityE2266 Guide for Design and Construction of Low-RiseFrame Building Wall Systems to Resist Water IntrusionG154 Practice for Operating Fluorescent LightApparatus forUV Exposure of Nonmetallic Materials2.2
11、Other Standards:AATCC Test Method 127 Water Resistance:HydrostaticPressure Test4CGSB CAN2-51.32.M77 Sheathing Membrane,BreatherType51This specification is under the jurisdiction of ASTM Committee E06 onPerformance of Buildings and is the direct responsibility of Subcommittee E06.55on Exterior Buildi
12、ng Wall Systems.Current edition approved Oct.15,2010.Published November 2010.Originallyapproved in 2009.Last previous edition approved in 2009 as E2556/E2556M-09.DOI:10.1520/E2556_E2556M-10.2For referenced ASTM standards,visit the ASTM website,www.astm.org,orcontact ASTM Customer Service at servicea
13、stm.org.For Annual Book of ASTMStandards volume information,refer to the standards Document Summary page onthe ASTM website.3The last approved version of this historical standard is referenced onwww.astm.org.4Available from American Association of Textile Chemists and Colorists(AATCC),P.O.Box 12215,
14、Research Triangle Park,NC 27709,http:/www.aatcc.org.5Available from Canadian General Standards Board(CGSB),Gatineau,QuebecK1A 1G6,Canada,http:/www.tpsgc-pwgsc.gc.ca/cgsb.Copyright ASTM International,100 Barr Harbor Drive,PO Box C700,West Conshohocken,PA 19428-2959.United States1 Federal Specificatio
15、n UU-B-790a Federal SpecificationBuilding Paper,Vegetable Fiber(Kraft,Waterproofed,Water Repellent and Fire Resistant)6TAPPI T-410 Test Method for Grammage of Paper andPaperboard(Weight Per Unit Area)7UBC Standard 14-1 Kraft Waterproof Building Paper8UBC Standard 32-1 Asphalt Saturated Rag Felt8ICC-
16、ES Acceptance Criteria AC38 for Water-Resistive Bar-riers93.Terminology3.1 DefinitionsFor definitions of general terms related tobuilding construction used in this specification,refer to Termi-nology E631.3.2 Definitions of Terms Specific to This Standard:3.2.1 felt-based barrier,nasphalt-saturated organic feltsthat comply with Specification D226 and are intended for useas water-resistive barriers.3.2.2 paper-based barrier,nbuilding papers composedpredominantly of sulfate pulp fibers that comply
