1、Designation:D697003(Reapproved 2019)Standard Practice forCollection of Calcined Petroleum Coke Samples forAnalysis1This standard is issued under the fixed designation D6970;the number immediately following the designation indicates the year oforiginal adoption or,in the case of revision,the year of
2、last revision.A number in parentheses indicates the year of last reapproval.Asuperscript epsilon()indicates an editorial change since the last revision or reapproval.1.Scope1.1 This practice covers procedures for the collection ofcalcined petroleum coke samples from conveyor belts ortransfer points.
3、These samples may be used for physical andchemical analyses.1.2 The values stated in SI units are to be regarded asstandard.The values given in parentheses are for informationonly.1.3 This standard does not purport to address all of thesafety concerns,if any,associated with its use.It is theresponsi
4、bility of the user of this standard to establish appro-priate safety,health,and environmental practices and deter-mine the applicability of regulatory limitations prior to use.1.4 This international standard was developed in accor-dance with internationally recognized principles on standard-ization
5、established in the Decision on Principles for theDevelopment of International Standards,Guides and Recom-mendations issued by the World Trade Organization TechnicalBarriers to Trade(TBT)Committee.2.Referenced Documents2.1 ASTM Standards:2D4702 Practice for Quality Management of MechanicalCoal Sampli
6、ng Systems(Withdrawn 2008)3D5709 Test Method for Sieve Analysis of Petroleum CokeD6969 Practice for Preparation of Calcined Petroleum CokeSamples for Analysis3.Terminology3.1 Definitions of Terms Specific to This Standard:3.1.1 accuracy,ngenerally,a term used to indicate thereliability of a sample,a
7、 measurement,or an observation.Specifically,a measure of closeness of agreement between anexperimental result and the true value.3.1.1.1 DiscussionExample:the observed and true sulfurcontent of a calcined petroleum coke consignment.Thismeasure is affected by chance errors as well as by bias.3.1.2 an
8、alysis sample,nthe reduced and divided represen-tative portion of the bulk sample,prepared for use in thelaboratory.3.1.3 gross sample,na sample representing one lot ofpetroleum coke and composed of a number of increments onwhich no reduction or division has been performed.3.1.4 increment,na small p
9、ortion of a lot collected by oneoperation of a sampling device and normally combined withother increments from the lot to make a gross sample.3.1.5 lot,na quantity of coke represented by a grosssample.3.1.6 representative sample,na sample collected in such amanner that the size consist is the same a
10、s the lot.3.1.7 sample,na quantity of petroleum coke taken from alarger quantity for the purpose of estimating properties orcomposition of the larger quantity.3.1.8 sample preparation,nthe process that may includedrying,crushing,division,and mixing of a gross sample for thepurpose of obtaining an un
11、biased analysis sample.3.1.9 size consist,nthe particle size distribution of amaterial;for example,petroleum coke.3.1.10 top size,nthe size of the smallest opening of onesieve of a series upon which is cumulatively retained a total ofless than 5%of the sample.This defined top size is not to beconfus
12、ed with the size of the largest particle in a lot.4.Significance and Use4.1 Data obtained from calcined petroleum coke samplesare used in commercial transactions,controlling plantoperations,and allocating production costs.Use of standardsampling procedures facilitates the task of obtaining a samplet
13、o represent an entire lot of calcined petroleum coke.1This practice is under the jurisdiction of ASTM Committee D02 on PetroleumProducts,Liquid Fuels,and Lubricants and is the direct responsibility of Subcom-mittee D02.05 on Properties of Fuels,Petroleum Coke and Carbon Material.Current edition appr
14、oved Dec.1,2019.Published December 2019.Originallyapproved in 2003.Last previous edition approved in 2013 as D6970 03(2013)1.DOI:10.1520/D6970-03R19.2For referenced ASTM standards,visit the ASTM website,www.astm.org,orcontact ASTM Customer Service at serviceastm.org.For Annual Book of ASTMStandards
15、volume information,refer to the standards Document Summary page onthe ASTM website.3The last approved version of this historical standard is referenced onwww.astm.org.Copyright ASTM International,100 Barr Harbor Drive,PO Box C700,West Conshohocken,PA 19428-2959.United StatesThis international standa
16、rd was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for theDevelopment of International Standards,Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade(TBT)Committee.1 4.2 This practice gives general procedures for the collectionof calcined petroleum coke samples and is intended to provideuseful methodology for the collection of a sample to representa lot of calcined petrole
