收藏 分享(赏)

ASTM_D_8361_-_20.pdf

上传人:益****师 文档编号:171826 上传时间:2023-03-04 格式:PDF 页数:9 大小:156.07KB
下载 相关 举报
ASTM_D_8361_-_20.pdf_第1页
第1页 / 共9页
ASTM_D_8361_-_20.pdf_第2页
第2页 / 共9页
ASTM_D_8361_-_20.pdf_第3页
第3页 / 共9页
ASTM_D_8361_-_20.pdf_第4页
第4页 / 共9页
ASTM_D_8361_-_20.pdf_第5页
第5页 / 共9页
ASTM_D_8361_-_20.pdf_第6页
第6页 / 共9页
亲,该文档总共9页,到这儿已超出免费预览范围,如果喜欢就下载吧!
资源描述

1、Designation:D836120Standard Test Method forTotal Organic Carbon in Water by Two Stage Wet ChemicalCatalyzed Hydroxyl Radical Oxidation with Infra-RedDetection of Resulting Carbon Dioxide1This standard is issued under the fixed designation D8361;the number immediately following the designation indica

2、tes the year oforiginal adoption or,in the case of revision,the year of last revision.A number in parentheses indicates the year of last reapproval.Asuperscript epsilon()indicates an editorial change since the last revision or reapproval.1.Scope1.1 This test method covers the catalyzed hydroxyl radi

3、caloxidation system for the in-stream,online(Guide D5173)orlaboratory analysis of total organic carbon,total carbon andtotal inorganic carbon in drinking water,wastewater,industrialprocess water,and effluent water.It is applicable to bothdissolved and suspended materials.Suspended materials andparti

4、culates up to 2 mm in diameter can be analyzed.1.2 This test method allows for determination of TOC 1mg/L,TC 1 mg/L,and TIC 1 mg/L.The lower and upperworking ranges are restricted by instrument-dependent condi-tions(for example,sample volume,amount of each reactant)and can be adjusted for a wider ra

5、nge.1.3 This test method can be applied for the determination oftotal carbon(TC)and total inorganic carbon(TIC).Volatile orpurgeable organic carbon(VOC,POC)can be determinedseparately by this test method(see Annex A1).1.4 This test method allows the measurement of organic andinorganic carbon concent

6、ration samples,and samples contain-ing dissolved chlorides up to seawater chloride concentrations.1.5 The chemical oxidation process,applied in this testmethod,takes place at ambient pressure and temperature byusing hydroxyl radicals.The advantage of catalytic hydroxylradical oxidation is that it is

7、 free from seawater salinityinterference.1.6 The values stated in SI units are to be regarded asstandard.No other units of measurement are included in thisstandard.1.7 This standard does not purport to address all of thesafety concerns,if any,associated with its use.It is theresponsibility of the us

8、er of this standard to establish appro-priate safety,health,and environmental practices and deter-mine the applicability of regulatory limitations prior to use.For specific hazard statements,see Section 9.1.8 ASTM International takes no position respecting thevalidity of any patent rights asserted i

9、n connection with anyitem mentioned in this standard.Users of this standard areexpressly advised that determination of the validity of any suchpatent rights,and the risk of infringement of such rights,areentirely their own responsibility.1.9 This international standard was developed in accor-dance w

10、ith internationally recognized principles on standard-ization established in the Decision on Principles for theDevelopment of International Standards,Guides and Recom-mendations issued by the World Trade Organization TechnicalBarriers to Trade(TBT)Committee.2.Referenced Documents2.1 ASTM Standards:2

11、D1129 Terminology Relating to WaterD1193 Specification for Reagent WaterD2777 Practice for Determination of Precision and Bias ofApplicable Test Methods of Committee D19 on WaterD3694 Practices for Preparation of Sample Containers andfor Preservation of Organic ConstituentsD4453 Practice for Handlin

12、g of High Purity Water SamplesD5173 Guide for On-Line Monitoring of Total OrganicCarbon in Water by Oxidation and Detection of ResultingCarbon DioxideD5847 Practice for Writing Quality Control Specificationsfor Standard Test Methods for Water Analysis2.2 Other Standard:EN 1484 Water analysis guideli

13、nes for the determination oftotal organic carbon and dissolved organic carbon31This test method is under the jurisdiction of ASTM Committee D19 on Waterand is the direct responsibility of Subcommittee D19.03 on Sampling Water andWater-Formed Deposits,Analysis of Water for Power Generation and Proces

14、s Use,On-Line Water Analysis,and Surveillance of Water.Current edition approved Dec.1,2020.Published December 2020.DOI:10.1520/D8361-20.2For referenced ASTM standards,visit the ASTM website,www.astm.org,orcontact ASTM Customer Service at serviceastm.org.For Annual Book of ASTMStandards volume inform

15、ation,refer to the standards Document Summary page onthe ASTM website.3Water Analysis Guidelines for the Determination of Total Organic Carbon andDissolved Organic Carbon,European Standard EN 1484,European Committee forStandardization,May 1997.Copyright ASTM International,100 Barr Harbor Drive,PO Bo

16、x C700,West Conshohocken,PA 19428-2959.United StatesThis international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for theDevelopment of International Standards,Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade(TBT)Committee.3.Terminology3.1 DefinitionsFor definitions of terms used in this testmethod,refer to Terminology D1129.3.2 Definitions of Terms Speci

展开阅读全文
相关资源
猜你喜欢
相关搜索

当前位置:首页 > 专业资料 > 国外标准

copyright@ 2008-2023 wnwk.com网站版权所有

经营许可证编号:浙ICP备2024059924号-2