1、Designation:D675617Standard Test Method forDetermination of the Red Dye Concentration and Estimationof the ASTM Color of Diesel Fuel and Heating Oil Using aPortable Visible Spectrophotometer1This standard is issued under the fixed designation D6756;the number immediately following the designation in
2、dicates the year oforiginal adoption or,in the case of revision,the year of last revision.A number in parentheses indicates the year of last reapproval.Asuperscript epsilon()indicates an editorial change since the last revision or reapproval.1.Scope*1.1 This test method covers the determination of t
3、he red dyeconcentration of diesel fuel and heating oil and the estimationof the ASTM color of undyed and red-dyed diesel fuel andheating oil.The test method is appropriate for use with dieselfuel and heating oil of Grades 1 and 2 described in Specifica-tions D396,D975,D2880,and D3699.Red dye concent
4、rationsare determined at levels equivalent to 0.1 mg L to 20 mg L ofSolvent Red 26 in samples withASTM colors ranging from 0.5to 5.The ASTM color of the base fuel of red-dyed sampleswith concentration levels equivalent to 0.1 mg L to 20 mg L ofSolvent Red 26 is estimated for theASTM color range from
5、 0.5to 5.The ASTM color of undyed samples is estimated over theASTM color range of 0.5 to 5.1.2 The values stated in SI units are to be regarded asstandard.No other units of measurement are included in thisstandard.1.3 This standard does not purport to address all of thesafety concerns,if any,associ
6、ated with its use.It is theresponsibility of the user of this standard to establish appro-priate safety and health practices and determine the applica-bility of regulatory limitations prior to use.1.4 This international standard was developed in accor-dance with internationally recognized principles
7、 on standard-ization established in the Decision on Principles for theDevelopment of International Standards,Guides and Recom-mendations issued by the World Trade Organization TechnicalBarriers to Trade(TBT)Committee.2.Referenced Documents2.1 ASTM Standards:2D396 Specification for Fuel OilsD975 Spec
8、ification for Diesel Fuel OilsD1500 Test Method for ASTM Color of Petroleum Products(ASTM Color Scale)D2880 Specification for Gas Turbine Fuel OilsD3699 Specification for KerosineD4052 Test Method for Density,Relative Density,and APIGravity of Liquids by Digital Density MeterD4057 Practice for Manua
9、l Sampling of Petroleum andPetroleum ProductsD4177 Practice for Automatic Sampling of Petroleum andPetroleum ProductsD6045 Test Method for Color of Petroleum Products by theAutomatic Tristimulus MethodD6708 Practice for Statistical Assessment and Improvementof Expected Agreement Between Two Test Met
10、hods thatPurport to Measure the Same Property of a MaterialE203 Test Method for Water Using Volumetric Karl FischerTitrationE1655 Practices for Infrared Multivariate QuantitativeAnalysisE2056 Practice for Qualifying Spectrometers and Spectro-photometers for Use in Multivariate Analyses,CalibratedUsi
11、ng Surrogate Mixtures3.Terminology3.1 Definitions:3.1.1 ASTM color,nthe name of an empirical scale ofexpressing the color of a petroleum liquid darker than Saybolt1This test method is under the jurisdiction of ASTM Committee D02 onPetroleum Products,Liquid Fuels,and Lubricants and is the direct resp
12、onsibility ofSubcommittee D02.05 on Properties of Fuels,Petroleum Coke and Carbon Material.Current edition approved May 1,2017.Published May 2017.Originallyapproved in 2002.Last previous edition approved in 2015 as D6756 10(2015).DOI:10.1520/D6756-17.2For referenced ASTM standards,visit the ASTM web
13、site,www.astm.org,orcontact ASTM Customer Service at serviceastm.org.For Annual Book of ASTMStandards volume information,refer to the standards Document Summary page onthe ASTM website.*A Summary of Changes section appears at the end of this standardCopyright ASTM International,100 Barr Harbor Drive
14、,PO Box C700,West Conshohocken,PA 19428-2959.United StatesThis international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for theDevelopment of International Standards,Guides and Recommendations issued by
15、 the World Trade Organization Technical Barriers to Trade(TBT)Committee.1 color based on a scale of 0.5(lightest)to 8 Dil(darkest)anddetermined by Test Method D1500.3.1.2 surrogate calibration,na multivariate calibrationthat is developed using a calibration set which consists ofmixtures with pre-spe
16、cified and reproducible compositions thatcontain substantially fewer chemical components than thesamples which will ultimately be analyzed.E20563.1.3 surrogate method,na standard test method that isbased on a surrogate calibration.E20563.2 Definitions of Terms Specific to This Standard:3.2.1 red dye,nsubstance that,when added to fuel,absorbs green light and imparts a red color to the product.Forthis test method,red dyes are:3.2.1.1 product dyes,nalkyl derivatives of azobenzene-4-azo-2-naphthol(m
