收藏 分享(赏)

ASTM_D_5798_-_15.pdf

上传人:益****师 文档编号:174881 上传时间:2023-03-04 格式:PDF 页数:10 大小:322.12KB
下载 相关 举报
ASTM_D_5798_-_15.pdf_第1页
第1页 / 共10页
ASTM_D_5798_-_15.pdf_第2页
第2页 / 共10页
ASTM_D_5798_-_15.pdf_第3页
第3页 / 共10页
ASTM_D_5798_-_15.pdf_第4页
第4页 / 共10页
ASTM_D_5798_-_15.pdf_第5页
第5页 / 共10页
ASTM_D_5798_-_15.pdf_第6页
第6页 / 共10页
亲,该文档总共10页,到这儿已超出免费预览范围,如果喜欢就下载吧!
资源描述

1、Designation:D579815Standard Specification forEthanol Fuel Blends for Flexible-Fuel Automotive Spark-Ignition Engines1This standard is issued under the fixed designation D5798;the number immediately following the designation indicates the year oforiginal adoption or,in the case of revision,the year o

2、f last revision.A number in parentheses indicates the year of last reapproval.Asuperscript epsilon()indicates an editorial change since the last revision or reapproval.This standard has been approved for use by agencies of the U.S.Department of Defense.1.Scope*1.1 This specification covers the requi

3、rements for automo-tive fuel blends of ethanol and gasoline for use in groundvehicles equipped with ethanol fuel blend flexible-fuel spark-ignition engines.Fuel produced to this specification contains51 to 83 volume%ethanol.This fuel is for use in flexible-fuelvehicles and is sometimes referred to a

4、t retail as“EthanolFlex-Fuel.”Appendix X1 discusses the significance of theproperties specified.1.2 The vapor pressure of ethanol fuel blends is varied forseasonal climatic changes.Vapor pressure is increased at lowertemperatures to ensure adequate flexible-fuel vehicle operabil-ity.Ethanol content

5、and selection of hydrocarbon blendstockare adjusted by the blender to meet these vapor pressurerequirements.1.3 This specification formerly covered Fuel Ethanol(Ed70-Ed85)for Automotive Spark-Ignition Engines,also knowncommercially as E85.The nomenclature“fuel ethanol”hasbeen changed to“ethanol fuel

6、 blends”to distinguish thisproduct from denatured fuel ethanol Specification D4806.Tofacilitate blending of ethanol fuel blends that meet seasonalvapor pressure requirements,a new lower minimum ethanolcontent has been established.1.4 The United States government has established variousprograms for a

7、lternative fuels.Many of the definitions ofalternative fuel used by these programs may be more restrictivethan the requirements of this specification.See 4.1.2.1 foradditional information on alternative fuels containing ethanol.1.5 The values stated in SI units are to be regarded as thestandard.The

8、values given in parentheses are for informationonly.1.6 The following safety hazard caveat pertains only to thetest method portion,8.1.8,of this specification.This standarddoes not purport to address all of the safety concerns,if any,associated with its use.It is the responsibility of the user of th

9、isstandard to establish appropriate safety and health practicesand determine the applicability of regulatory limitations priorto use.2.Referenced Documents2.1 ASTM Standards:2D86 Test Method for Distillation of Petroleum Products atAtmospheric PressureD130 Test Method for Corrosiveness to Copper fro

10、m Petro-leum Products by Copper Strip TestD381 Test Method for Gum Content in Fuels by Jet Evapo-rationD525 Test Method for Oxidation Stability of Gasoline(In-duction Period Method)D1613 Test Method for Acidity in Volatile Solvents andChemical Intermediates Used in Paint,Varnish,Lacquer,and Related

11、ProductsD1688 Test Methods for Copper in WaterD3231 Test Method for Phosphorus in GasolineD4057 Practice for Manual Sampling of Petroleum andPetroleum ProductsD4175 Terminology Relating to Petroleum,PetroleumProducts,and LubricantsD4177 Practice for Automatic Sampling of Petroleum andPetroleum Produ

12、ctsD4306 Practice for Aviation Fuel Sample Containers forTests Affected by Trace ContaminationD4806 Specification for Denatured Fuel Ethanol for Blend-ing with Gasolines for Use as Automotive Spark-IgnitionEngine FuelD4814 Specification for Automotive Spark-Ignition EngineFuelD4953 Test Method for V

13、apor Pressure of Gasoline andGasoline-Oxygenate Blends(Dry Method)1This specification is under the jurisdiction of ASTM Committee D02 onPetroleum Products,Liquid Fuels,and Lubricants and is under the direct responsi-bility of Subcommittee D02.A0.02 on Oxygenated Fuels and Components.Current edition

14、approved Oct.1,2015.Published October 2015.Originallyapproved in 1996.Last previous edition approved in 2014 as D5798 14.DOI:10.1520/D5798-15.2For referenced ASTM standards,visit the ASTM website,www.astm.org,orcontact ASTM Customer Service at serviceastm.org.For Annual Book of ASTMStandards volume

15、information,refer to the standards Document Summary page onthe ASTM website.*A Summary of Changes section appears at the end of this standardCopyright ASTM International,100 Barr Harbor Drive,PO Box C700,West Conshohocken,PA 19428-2959.United States1 D5191 Test Method for Vapor Pressure of Petroleum

16、 Prod-ucts(Mini Method)D5453 Test Method for Determination of Total Sulfur inLight Hydrocarbons,Spark Ignition Engine Fuel,DieselEngine Fuel,and Engine Oil by Ultraviolet FluorescenceD5501 Test Method for Determination of Ethanol andMethanol Content in Fuels Containing Greater than 20%Ethanol by Gas ChromatographyD5854 Practice for Mixing and Handling of Liquid Samplesof Petroleum and Petroleum ProductsD6423 Test Method for Determination of pHe of DenaturedFuel Ethanol and Ethanol Fuel BlendsD70

展开阅读全文
相关资源
猜你喜欢
相关搜索

当前位置:首页 > 专业资料 > 国外标准

copyright@ 2008-2023 wnwk.com网站版权所有

经营许可证编号:浙ICP备2024059924号-2