1、Designation:D5090(Reapproved 2019)Standard Test Methods forChemical Analysis of Yellow,Orange,Red,and BrownPigments Containing Iron and Manganese1This standard is issued under the fixed designation D50;the number immediately following the designation indicates the year of originaladoption or,in the
2、case of revision,the year of last revision.Anumber in parentheses indicates the year of last reapproval.Asuperscriptepsilon()indicates an editorial change since the last revision or reapproval.This standard has been approved for use by agencies of the U.S.Department of Defense.1.Scope1.1 These test
3、methods cover procedures for the chemicalanalysis of yellow,orange,red,and brown pigments containingiron and manganese.The test methods apply specifically to thefollowing pigments:synthetic hydrated yellow iron oxide,yellow ocher,red and brown iron oxides,raw and burnt umber,raw and burnt sienna,and
4、 venetian red.1.2 The analytical procedures appear in the following order:ASTMMethodRefer-Dry PigmentsSectionsencesMoisture and Other Volatile Matter6D280Loss on Ignition7Coarse Particles8D185Matter Soluble in Water9D1208Organic Coloring Matter10Iron Oxide11 and 12Calcium Compounds(Reported as CaO)1
5、3 and 14Sulfates Soluble in Hydrochloric Acid15 and 16Lead Chromate(in Ochers)17Calcium Carbonate(in Venetian Red)18C25Manganese(in Siennas and Umbers)19 and 20Pigment Pastes in OilPigment Content21D1208Moisture and Other Volatile Matter22D1208Nonvolatile Matter in Vehicle23Moisture by Distillation2
6、4D1208Coarse Particles and Skins25D185Consistency(Stormer)26D5621.3 The values stated in SI units are to be regarded asstandard.No other units of measurement are included in thisstandard.1.4 This standard does not purport to address all of thesafety concerns,if any,associated with its use.It is ther
7、esponsibility of the user of this standard to establish appro-priate safety,health,and environmental practices and deter-mine the applicability of regulatory limitations prior to us.1.5 This international standard was developed in accor-dance with internationally recognized principles on standard-iz
8、ation established in the Decision on Principles for theDevelopment of International Standards,Guides and Recom-mendations issued by the World Trade Organization TechnicalBarriers to Trade(TBT)Committee.2.Referenced Documents2.1 ASTM Standards:2C25 Test Methods for Chemical Analysis of Limestone,Quic
9、klime,and Hydrated LimeD185 Test Methods for Coarse Particles in PigmentsD280 Test Methods for Hygroscopic Moisture(and OtherMatter Volatile Under the Test Conditions)in PigmentsD562 Test Method for Consistency of Paints MeasuringKrebs Unit(KU)Viscosity Using a Stormer-Type Viscom-eterD1193 Specific
10、ation for Reagent WaterD1208 Test Methods for Common Properties of CertainPigmentsE11 Specification for Woven Wire Test Sieve Cloth and TestSieves3.Significance and Use3.1 These test methods compile in one place,recommendedprocedures for analyzing inorganic colored pigments.Thesepigments are used ex
11、tensively in paints,and for this reasontheir compositions are important to the formulators and user.4.Preparation of Sample4.1 Mix the sample thoroughly and take a representativeportion for analysis.Reduce any lumps or coarse particles to afine powder by grinding.Grind extracted pigments to pass aNo
12、.80(180-m)sieve(see Specification E11 for detailed1These test methods are under the jurisdiction of ASTM Committee D01 onPaint and Related Coatings,Materials,and Applications and are the directresponsibility of Subcommittee D01.31 on Pigment Specifications.Current edition approved May 1,2019.Publish
13、ed May 2019.Originallyapproved in 1917.Last previous edition approved in 2011 as D50 90(2011).DOI:10.1520/D0050-90R19.2For referenced ASTM standards,visit the ASTM website,www.astm.org,orcontact ASTM Customer Service at serviceastm.org.For Annual Book of ASTMStandards volume information,refer to the
14、 standards Document Summary page onthe ASTM website.Copyright ASTM International,100 Barr Harbor Drive,PO Box C700,West Conshohocken,PA 19428-2959.United StatesThis international standard was developed in accordance with internationally recognized principles on standardization established in the Dec
15、ision on Principles for theDevelopment of International Standards,Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade(TBT)Committee.1 requirements).Discard any skins that do not pass through thesieve.Mix the finely ground pigment thoroughly.5.Purity of Reage
16、nts5.1 Purity of ReagentsUnless otherwise indicated,it isintended that all reagents shall conform to the specifications ofthe Committee onAnalytical Reagents of theAmerican Chemi-cal Society,where such specifications are available.3Othergrades may be used,provided it is first ascertained that thereagent is of sufficiently high purity to permit its use withoutlessening the accuracy of the determination.5.2 Purity of WaterUnless otherwise indicated,referencesto water shall be understood to mean Ty