1、Designation:D 4947 05Standard Test Method forChlordane and Heptachlor Residues in Indoor Air1This standard is issued under the fixed designation D 4947;the number immediately following the designation indicates the year oforiginal adoption or,in the case of revision,the year of last revision.A numbe
2、r in parentheses indicates the year of last reapproval.Asuperscript epsilon(e)indicates an editorial change since the last revision or reapproval.1.Scope1.1 This test method covers the sampling and analysis ofindoor atmospheres for residues of chlordane and heptachlor.1.2 This test method is based u
3、pon the collection of chlor-dane and heptachlor from air onto polyurethane foam(PUF)and analysis by gas chromatography coupled with electroncapture detection.1.3 This test method is applicable to concentrations ofchlordane varying from 0.1 to 100 g/m3and heptachlorvarying from 0.01 to 80.0 g/m3with
4、sampling periods tocollect at least 0.25 m3of air.Detection limits will dependupon the conditions of the gas chromatography(GC)and thelength of the sampling period.1.4 This standard does not purport to address all of thesafety concerns,if any,associated with its use.It is theresponsibility of the us
5、er of this standard to establish appro-priate safety and health practices and determine the applica-bility of regulatory limitations prior to use.2.Referenced Documents2.1 ASTM Standards:2D 1356 Terminology Relating to Sampling and Analysis ofAtmospheresD 3686 Practice for Sampling Atmospheres to Co
6、llect Or-ganic Compound Vapors(Activated Charcoal Tube Ad-sorption Method)D 3687 Practice for Analysis of Organic Compound VaporsCollected by the Activated Charcoal Tube AdsorptionMethodD 4185 Practice for Measurement of Metals in WorkplaceAtmospheres by Atomic Absorption SpectrophotometryD 4861 Pra
7、ctice for Sampling and Selection of AnalyticalTechniques for Pesticides and Polychlorinated Biphenylsin AirE 355 Practice for Gas Chromatography Terms and Rela-tionships2.2EPA Methods:Compendium of Methods for the Determination to ToxicOrganic Compounds in Ambient Air,EPA 600/R-96/010b32.3Other Docu
8、ments:Indoor Sampling Guidelines for Termiticides43.Terminology3.1 Definitions:3.1.1Refer to Terminology D 1356,Practice E 355,andPractice D 4861 for definitions of terms used in this testmethod.3.1.2 The term“chlordane”refers to a technical-grademixture consisting mostly of chlorinated Diels-Alder
9、additionproducts of cyclopentadiene and hexachlorocyclopentadiene.The mixture consists of 50 or more compounds,10 of whichare major components(1).5The isomers a-(or cis-)and g-(ortrans-)chlordane,heptachlor,and trans-nonachlor are amongthese.3.1.2.1 The terms“chlordane”and“technical”chlordaneare use
10、d interchangeably.3.1.3 Heptachlor is a single chemical compound,which maybe used alone or in formulations with technical chlordane.It isalso a component of technical chlordane.4.Summary of Practice4.1 A low-volume(1 to 5 L/min)sampler is used to collectairborne chlordane and heptachlor on a sorbent
11、 cartridgecontaining PUF.The method is taken from Refs.(2)through(4)and Practice D 4861.4.2 Chlordane and heptachlor are extracted from the sorbentcartridge with 5%diethyl ether in hexane and analyzed on agas chromatograph(GC)equipped with an electron capturedetector(ECD).4.3 Because of the possibil
12、ity of interfering materials hav-ing similar retention times to chlordane and heptachlor peaks,column chromatography or the use of a second chromato-graphic column of a different type is necessary to obtain1This practice is under the jurisdiction of ASTM Committee D22 on Samplingand Analysis of Atmo
13、spheres and is the direct responsibility of SubcommitteeD22.05 on Indoor Air.Current edition approved March 1,2005.Published March 2005.Originallyapproved in 1989.Last previous edition approved in 2000 as D 4947-00.2For referenced ASTM standards,visit the ASTM website,www.astm.org,orcontact ASTM Cus
14、tomer Service at serviceastm.org.For Annual Book of ASTMStandards volume information,refer to the standards Document Summary page onthe ASTM website.3Available from the U.S.Department of Commerce,National Technical Infor-mation Service,Port Royal Road,Springfield,VA 22161.4Available from Wood Protec
15、tion Council,National Institute for BuildingSciences,Washington,DC,1987.5The boldface numbers in parentheses refer to the list of references at the end ofthis standard.1Copyright ASTM International,100 Barr Harbor Drive,PO Box C700,West Conshohocken,PA 19428-2959,United States.accurate identificatio
16、n and quantification.Mass spectrometrymay be required for unambiguous determination.5.Significance and Use5.1 This test method is intended to be used primarily fornon-occupational exposure monitoring in domiciles,publicaccess buildings and offices.5.2 Chlordane has been used widely as a general insecticidefor crops(for example,cotton)and as a termiticide.Heptachloris a major component of technical chlordane and an insecticidein its own right.Although their use in the United States wasdiscontinue
