1、Designation:D365514Standard Performance Specification forMens and Womens Sliver Knitted Overcoat and JacketFabrics1This standard is issued under the fixed designation D3655;the number immediately following the designation indicates the year oforiginal adoption or,in the case of revision,the year of
2、last revision.A number in parentheses indicates the year of last reapproval.Asuperscript epsilon()indicates an editorial change since the last revision or reapproval.1.Scope1.1 This performance specification covers mens and wom-ens sliver knitted overcoat and jacket fabrics composed of anytextile fi
3、ber or mixture of textile fibers.1.2 This performance specification is not applicable toknitted fabrics used for interlinings.1.3 These requirements apply to the length and widthdirections for those properties where fabric direction is perti-nent.1.4 The following safety hazards caveat pertains only
4、 to thetest methods portion,Section 7,of this specification:Thisstandard does not purport to address all of the safety concerns,if any,associated with its use.It is the responsibility of the userof this standard to establish appropriate safety and healthpractices and determine the applicability of r
5、egulatory limita-tions prior to use.2.Referenced Documents2.1 ASTM Standards:2D123 Terminology Relating to TextilesD2724 Test Methods for Bonded,Fused,and LaminatedApparel FabricsD2905 Practice for Statements on Number of Specimens forTextiles(Withdrawn 2008)3D3786 Test Method for Bursting Strength
6、of TextileFabricsDiaphragm Bursting Strength Tester MethodD3787 Test Method for Bursting Strength of TextilesConstant-Rate-of-Traverse(CRT)Ball Burst TestD7022 Terminology Relating to Apparel32.2 AATCC Methods:48 Colorfastness to Crocking:Crockmeter Method15 Colorfastness to Perspiration16.3 Colorfa
7、stness to Light23 Colorfastness to Burnt Gas Fumes61 Colorfastness to Laundering:Accelerated107 Colorfastness to Water116 Colorfastness to Crocking:Rotary Vertical CrockmeterMethod132 Colorfastness to Drycleaning135 Dimensional Changes of Fabrics After Home Launder-ing172 Colorfastness to Powdered N
8、on-Chlorine Bleach inHome Laundering188 Colorfastness to Sodium Hypochlorite Bleach in HomeLaunderingEvaluation Procedure 1 Gray Scale for Color ChangeEvaluation Procedure 2 Gray Scale for StainingEvaluation Procedure 8 AATCC 9-Step Chromatic Trans-ference Scale2.3 Federal Standard:516 CFR,ChapterII
9、ConsumerProductSafetyCommission,Subchapter DFlammable Fabrics ActRegulationsNOTE1Reference to test methods in this specification give only thepermanent part of the designation of ASTM,AATCC,or other testmethods.The current editions of each test method cited shall prevail.3.Terminology3.1 For all ter
10、minology related to Apparel see TerminologyD7022.3.1.1 The following terms are relevant to this standard:fabric,sliver knitted.3.2 For terms relating to chemical or colorfastness testing,refer to specific AATCC methods.For definitions of all othertextile terms see Terminology D123.1This performance
11、specification is under the jurisdiction of ASTM CommitteeD13 on Textiles and is the direct responsibility of Subcommittee D13.61 onApparel.Current edition approved Feb.1,2014.Published March 2014.Originallyapproved in 1978.Last previous edition approved in 2013 as D3655 131.DOI:10.1520/D3655-14.2For
12、 referenced ASTM standards,visit the ASTM website,www.astm.org,orcontact ASTM Customer Service at serviceastm.org.For Annual Book of ASTMStandards volume information,refer to the standards Document Summary page onthe ASTM website.3The last approved version of this historical standard is referenced o
13、nwww.astm.org.4Available from American Association of Textile Chemists and Colorists(AATCC),P.O.Box 12215,Research Triangle Park,NC 27709,http:/www.aatcc.org.5Available from Superintendent of Documents,Government Printing Office,Washington,DC 20402.Copyright ASTM International,100 Barr Harbor Drive,
14、PO Box C700,West Conshohocken,PA 19428-2959.United States1 4.Significance and Use4.1 Upon mutual agreement between the purchaser and theseller,woven fabrics intended for this end use should meet allof the requirements listed in Table 1 of this specification.4.2 It is recognized that for purposes of
15、fashion or aestheticsthe ultimate consumer of articles made from these fabrics mayfind acceptable fabrics that do not conform to all of therequirements in Table 1.Therefore,one or more of therequirements listed in Table 1 may be modified by mutualagreement between the purchaser and the seller.4.2.1
16、In such cases,any references to the specification shallspecify that:This fabric meets ASTM Specification D3655except for the following characteristic(s).4.3 Where no prepurchase agreement has been reachedbetween the purchaser and the seller,and in case ofcontroversy,the requirements listed in Table 1 are intended tobe used as a guide only.As noted in 4.2,ultimate consumerdemands dictate varying performance parameters for anyparticular style of fabric.4.4 The uses and significance of particular p
