1、Designation:D386709Standard Test Methods forNitrite-Nitrate in Water1This standard is issued under the fixed designation D3867;the number immediately following the designation indicates the year oforiginal adoption or,in the case of revision,the year of last revision.A number in parentheses indicate
2、s the year of last reapproval.Asuperscript epsilon()indicates an editorial change since the last revision or reapproval.1.Scope*1.1 These test methods cover the determination of nitritenitrogen,nitrate nitrogen,and combined nitrite-nitrate nitrogenin water and wastewater in the range from 0.05 to 1.
3、0 mg/Lnitrogen.Two test methods2are given as follows:SectionsTest Method AAutomated Cadmium Reduction9 to 18Test Method BManual Cadmium Reduction19 to 281.2 These test methods are applicable to surface,saline,waste,and ground waters.It is the users responsibility toensure the validity of these test
4、methods for waters of untestedmatrices.1.3 The values stated in either SI or inch-pound units are tobe regarded as the standard.The values given in parenthesesare for information only.1.4 This standard does not purport to address all of thesafety concerns,if any,associated with its use.It is theresp
5、onsibility of the user of this standard to establish appro-priate safety and health practices and determine the applica-bility of regulatory limitations prior to use.For specific hazardstatements,see Note 1 and Note 2.2.Referenced Documents2.1 ASTM Standards:3D1129 Terminology Relating to WaterD1141
6、 Practice for the Preparation of Substitute OceanWaterD1193 Specification for Reagent WaterD2777 Practice for Determination of Precision and Bias ofApplicable Test Methods of Committee D19 on WaterD3370 Practices for Sampling Water from Closed ConduitsD5810 Guide for Spiking into Aqueous SamplesD584
7、7 Practice for Writing Quality Control Specificationsfor Standard Test Methods for Water AnalysisE60 Practice for Analysis of Metals,Ores,and RelatedMaterials by SpectrophotometryE275 Practice for Describing and Measuring Performance ofUltraviolet and Visible Spectrophotometers3.Terminology3.1 Defin
8、itions:For definitions of terms used in these testmethods,refer to Terminology D1129.4.Summary of Test Methods4.1 Total Oxidized Nitrogena filtered sample is passedthrough a column containing copper-coated cadmium granulesto reduce nitrate ion to nitrite ion.The combined nitrite-nitratenitrogen is d
9、etermined by diazotizing the total nitrite ion withsulfanilamideandcouplingwithN-(1-naphthyl)ethylenediamine dihydrochloride to form a highlycolored azo dye that is measured spectrophotometrically.4.2 Nitritethe nitrite ion originally present in the samplecan be determined separately by carrying out
10、 the procedure andomitting the cadmium reduction step.4.3 Nitratethe nitrate ion can be calculated as the differ-ence between the combined nitrite-nitrate nitrogen and thenitrite nitrogen.5.Significance and Use5.1 Both test methods use identical reagents and sampleprocessing.The only difference betw
11、een the two methods isthat one test method is automated and the other is manual.Theranges and interferences are identical.5.2 The automated test method is preferred when largenumbers of samples are to be analyzed.The manual testmethod is used for fewer samples or when automated instru-mentation is n
12、ot available.5.3 These test methods replace Test Methods D1254(Ni-trite)and D992(Nitrate).The nitrite test method(Test MethodD1254)used a reagent that is considered to be a potentialcarcinogen.The nitrate test method(Test Method D992)hasbeen shown to have relatively large errors when used inwastewat
13、ers and also has greater manipulative difficulties thanthe test method described herein.1These test methods are under the jurisdiction of ASTM Committee D19 onWater and are the responsibility of Subcommittee D19.05 on Inorganic Constituentsin Water.Current edition approved May 15,2009.Published May
14、2009.Originallyapproved in 1979.Last previous edition approved in 2004 as D3867 04.DOI:10.1520/D3867-09.2Methods similar to these appear in Methods of Chemical Analysis of Water andWastes,2nd edition,U.S.Environmental Protection Agency.3For referenced ASTM standards,visit the ASTM website,www.astm.o
15、rg,orcontact ASTM Customer Service at serviceastm.org.For Annual Book of ASTMStandards volume information,refer to the standards Document Summary page onthe ASTM website.*A Summary of Changes section appears at the end of this standardCopyright ASTM International,100 Barr Harbor Drive,PO Box C700,We
16、st Conshohocken,PA 19428-2959.United States1 6.Interferences6.1 Turbid samples must be filtered prior to analysis toeliminate particulate interference.Furthermore,sample turbid-ity results in a buildup on the reduction column that restrictssample flow.6.2 Sample color that absorbs at wavelengths between 520and 540 nm interferes with the absorbance measurements.When color is suspect,analyze a sample blank,omitting theN-(1-naphthyl)ethylenediamine dihydrochloride from the colorreagent.6.3 Oil and
