收藏 分享(赏)

ASTM_D_2692_-_D_2692M_-_15.pdf

上传人:益****师 文档编号:180497 上传时间:2023-03-04 格式:PDF 页数:5 大小:183.88KB
下载 相关 举报
ASTM_D_2692_-_D_2692M_-_15.pdf_第1页
第1页 / 共5页
ASTM_D_2692_-_D_2692M_-_15.pdf_第2页
第2页 / 共5页
ASTM_D_2692_-_D_2692M_-_15.pdf_第3页
第3页 / 共5页
ASTM_D_2692_-_D_2692M_-_15.pdf_第4页
第4页 / 共5页
ASTM_D_2692_-_D_2692M_-_15.pdf_第5页
第5页 / 共5页
亲,该文档总共5页,全部预览完了,如果喜欢就下载吧!
资源描述

1、Designation:D2692/D2692M15Standard Test Method forAir Permeability of Tire Fabrics,Tire Cord Fabrics,TireCord,and Yarns1This standard is issued under the fixed designation D2692/D2692M;the number immediately following the designation indicates theyear of original adoption or,in the case of revision,

2、the year of last revision.A number in parentheses indicates the year of lastreapproval.A superscript epsilon()indicates an editorial change since the last revision or reapproval.1.Scope1.1 This test method covers the determination of longitudi-nal air permeability for tire fabrics,tire cord fabrics,

3、tire cords,or yarns embedded in cured rubber compound.This testmethod is designed to demonstrate the effectiveness of fabrictreatments intended to prevent air permeability.This testmethod is applicable to fabrics made from all types of fiberswith all types of rubber compound.1.2 The values stated in

4、 either SI units or inch-pound unitsare to be regarded separately as standard.The values stated ineach system may not be exact equivalents;therefore,eachsystem shall be used independently of the other.Combiningvalues from the two systems may result in non-conformancewith the standard.1.3 This standa

5、rd does not purport to address all of thesafety concerns,if any,associated with its use.It is theresponsibility of the user of this standard to establish appro-priate safety and health practices and determine the applica-bility of regulatory limitations prior to use.See the Note in11.1.2.Referenced

6、Documents2.1 ASTM Standards:2D123 Terminology Relating to TextilesD3182 Practice for RubberMaterials,Equipment,and Pro-cedures for Mixing Standard Compounds and PreparingStandard Vulcanized SheetsD6477 Terminology Relating to Tire Cord,Bead Wire,HoseReinforcing Wire,and Fabrics3.Terminology3.1 Defin

7、itions:3.1.1 For definitions of terms relating to tire cord,bead wire,hose wire,and tire cord fabrics,refer to Terminology D6477.3.1.1.1 The following terms are relevant to this standard:airpermeability,chafer fabric,test panel,in air permeability test,tire cord,tire cord fabric,tire fabric,vulcaniz

8、ation,wickproof,in tire fabric,tire cord fabric,tire cord,or yarn.3.1.2 For definitions of other terms related to textiles,referto Terminology D123.3.1.2.1 The following terms are relevant to this standard:skein and yarn.4.Summary of Test Method4.1 Fabric specimens are embedded in a rubber compounda

9、nd air pressure is applied to freshly exposed yarn ends.Detergent solution is applied to the opposite end of the yarnswhich have also been freshly exposed.Air permeability isindicated by continuous formation of air bubbles in thedetergent solution due to air passing along the axis of a yarn.5.Signif

10、icance and Use5.1 This test method is considered satisfactory for theacceptance testing of commercial shipments of tire fabricssince this test method has been used extensively in the trade foracceptance testing.This test method is also considered satis-factory for quality control.5.1.1 In case of a

11、dispute arising from differences inreported test results when using this test method for acceptancetesting of commercial shipments,the purchaser and the sup-plier should conduct comparative tests to determine if there isa statistical bias between their laboratories.Competent statis-tical assistance

12、is recommended for the investigation of bias.As a minimum,the two parties should take a group of testspecimens that are as homogeneous as possible and that arefrom a lot of material of the type in question.The testspecimens should then be randomly assigned in equal numbersto each laboratory for test

13、ing.The average results from the twolaboratories may be compared using appropriate statisticalanalysis and an acceptable probability level chosen by the twoparties before the testing is begun.If a bias is found,either itscause must be found and corrected or the purchaser and thesupplier must agree t

14、o interpret future test results with consid-eration to the known bias.1This test method is under the jurisdiction ofASTM Committee D13 on Textilesand is the direct responsibility of Subcommittee D13.19 on Industrial Fibers andMetallic Reinforcements.Current edition approved Feb.1,2015.Published Apri

15、l 2015.Originallyapproved in 1968.Last previous edition approved in 2014 as D2692 10(2014).DOI:10.1520/D2692_D2692M-15.2For referenced ASTM standards,visit the ASTM website,www.astm.org,orcontact ASTM Customer Service at serviceastm.org.For Annual Book of ASTMStandards volume information,refer to th

16、e standards Document Summary page onthe ASTM website.Copyright ASTM International,100 Barr Harbor Drive,PO Box C700,West Conshohocken,PA 19428-2959.United States1 5.2 This test method is applicable for testing the air perme-ability of any fabric that is embedded in a rubber compound,but is particularly useful when testing chafer fabrics to be usedin a tubeless tire construction.In tubeless tires,chafer fabricyarns that are air permeable represent potential channels for airto pass through,and thu

展开阅读全文
相关资源
猜你喜欢
相关搜索

当前位置:首页 > 专业资料 > 国外标准

copyright@ 2008-2023 wnwk.com网站版权所有

经营许可证编号:浙ICP备2024059924号-2