1、ASTM D2833 89 Rl 0759530 0027426 4,r-Designation:D 2833-89 AMERICAN SOCIETY FOR TESTINQ AND MATERIALS 1916 Race S I.,Philadelphia,Pa.19103 Aeprinled from the Annual Llook d ASTM Standafdr,CopyngM ASTM II not lisfed in the current combined index,will p p a u in lh nt Odilion.Standard Index of Methods
2、 for Testing Architectural Paints and Coatings This standard is issued under the fixed designation D 2833;the number immediately following the designation indicates the year of original adoption or,in the case of revision,the year of last revision.A number in parentheses indicates the year of last r
3、eapproval.A superscript epsilon(e)indicates an editorial change since the last revision or reapproval.1.Scope 1.1 This index is provided for reference in the selection of procedures,test methods,and specifications to be used in the evaluation of architectural paints and coatings designed for applica
4、tion in the field.Composition specifications and analytical methods in general,also tests on raw materials,are not included,the scope being limited to procedures required in the evaluation of finished coatings.1.2 Methods suitable for both interior and exterior coat-ings of either the water-thinned
5、or solvent-thinned type are listed by ASTM designation primarily.Where comparable(but not necessarily identical)methods exist in U.S.Federal Test Method Standard No.141,the Federal Method num-bers are also listed.1.3 Where more then one test method is listed for the same characteristic in this index
6、,no attempt is made to indicate superiority of one test method over another.Selec-tion of the test methods to be followed must be governed by experience and the requirements in each individual case,This index is under the jurisdiction of ASTM Committee Dl on Paint and Related Coatings and Materials
7、and is the direct responsibility of Subcommittee W1.42 on Architectural Finishes.Current edition approved March 31,1989.Published May 1988.Originally published as D 2833-69.Last previous edition D 2833-83.together with agreement between the purchaser and the seller.2.Precision and Bias 2.1 If availa
8、ble,precision for any procedure or test method selected is given in the latest issue of the subject standard.3.Test Categories 3.1 For convenience in selection,the procedures,methods,and specifications listed in this index are classified into three groups and three classes.The category of each listi
9、ng is indicated in a column preceding the reference.The classifications are as follows:3.1.1 Group I-Applicable to Either Water-or Solvent-Reducible Coatings:Class A-For both interior and exterior products.Class B-For interior products only.Class C-For exterior products only.3.1.2 Group II-Water-Thi
10、nned Coatings:Class A-For both interior and exterior products.Class B-For interior products only,Class C-For exterior products oniy.3.1.3 Group III-Solvent-Thinned Coatings:Class A-For both interior and exterior products.Class B-For interior products only,Class C-For exterior products only.NOTICE:Th
11、is standard has either been superseded and replaced by a new version or discontinued.Contact ASTM International(www.astm.org)for the latest information.-.a-ASTM D2833 89 I 0759510 0027q27 b I D2833 INDEX OF METHODS ASTM ASTM Federal Standard Designation No.141 Category Vdurne No.IA IA IA IB IIA IIA
12、1 1 8 llB IIC IIC IIIA HIA IIIA 1 1 1 8 1 1 1 8 1 1 1 8 1 1 1 8 IIIC IA IA IA IA IA IA IIA IIA H A IIA IIIA IIIA IIIA IIIA IA IA IA IA IA IA IIIA IIIA IA IA IA IA IC IC IIIA IIIA IA IA IA IA IA IA Definitions of Terms Relating to Paints,Varnishes,Lacquers and Related Products.06.01 D 16 Examination
13、of Paint Products Primers and Primer Surfacers over Preformed Metal Sampling Llquld Paints and Related Pigmented Coatings Testing High-Performance Interior Architectural Wall Coatings Resistance of Emulsion Paints in the Container to Attack by Microorganisms Water-Borne Floor Paints Latex Flat Wall
14、Paints Interior Latex Semigloss and Gloss Paints Testing Asphalt Emulslons for Use as Protective Coatings for Metal Exterior Latex House Paints Testing Varnishes Clear and Pigmented Lacquers Solvent-Reducible Floor Paints Performance Tests of Clear Floor Sealers Sampling and Testing Shellac Varnish
15、Interior Solvent-Reducible Flat Wall Paints Solvent-Reducible Interior Semigloss Wall and Trim Enamels Exterior Solvent-Reducible House and Trim Paints Physical Tests Density of Paint,Varnish,Lacquer and Related Products Evaluatlng the Degree of Settling of Traffic Paint Flash Point of Liquids by Se
16、taflash Closed-Cup Apparatus Flash Point by Pensky-Martens Closed Tester Coarse Particles In Pigments,Pastes,and Paints Fineness of Dispersion of Pigment-Vehicle Systems Package Stability of Latex Paint Freeze-Thaw Reslstance of Water-Borne Paints Freeze-Thaw Stability of Multicolor Lacquers Partlcle Size of Multicolor Lacquers Flash Point by Tag Closed Tester Flash Point and Fire Points of Uquids by Tag Open-Cup Apparatus Specific Gravity of Drying Oils,Varnishes,Resins,and Related Materials at
