1、Designation:D411414Standard Performance Specification forWoven Flat Lining Fabrics for Womens and Girls Apparel1This standard is issued under the fixed designation D4114;the number immediately following the designation indicates the year oforiginal adoption or,in the case of revision,the year of las
2、t revision.A number in parentheses indicates the year of last reapproval.Asuperscript epsilon()indicates an editorial change since the last revision or reapproval.1.Scope1.1 This performance specification covers woven flat fabricscomprised of any textile fiber or mixture of fibers to be used aslinin
3、gs for womens and girls apparel.1.2 This performance specification is not applicable towoven pile,woven fusible,fire-bonded fusible,sliver-knit pile,and sheepskin lining fabrics.1.3 These requirements apply to the length and widthdirections for those properties where fabric direction is perti-nent.1
4、.4 The following precautionary statement pertains only tothe test methods portion,Section 7,of this performancespecification.This standard does not purport to address all ofthe safety concerns,if any,associated with its use.It is theresponsibility of the user of this standard to establish appro-pria
5、te safety and health practices and determine the applica-bility of regulatory limitations prior to use.2.Referenced Documents2.1 ASTM Standards:2D123 Terminology Relating to TextilesD434 Test Method for Resistance to Slippage of Yarns inWoven Fabrics Using a Standard Seam(Withdrawn2003)3D1336 Test M
6、ethod for Distortion of Yarn in Woven FabricsD1424 Test Method for Tearing Strength of Fabrics byFalling-Pendulum(Elmendorf-Type)ApparatusD2261 Test Method for Tearing Strength of Fabrics by theTongue(Single Rip)Procedure(Constant-Rate-of-Extension Tensile Testing Machine)D2262 Test Method for Teari
7、ng Strength of Woven Fabricsby the Tongue(Single Rip)Method(Constant-Rate-of-Traverse Tensile Testing Machine)(Withdrawn 1995)3D2724 Test Methods for Bonded,Fused,and LaminatedApparel FabricsD5034 Test Method for Breaking Strength and Elongation ofTextile Fabrics(Grab Test)D7022 Terminology Relating
8、 to Apparel2.2 AATCC Test Methods:48 Colorfastness to Crocking:Crockmeter Method15 Colorfastness to Perspiration16.2 Colorfastness to Light:Carbon-Arc16.3 Colorfastness to Light:Xenon-Arc23 Colorfastness to Burnt Gas Fumes61 Colorfastness to Laundering:Accelerated116 Colorfastness to Crocking:Rotary
9、 Vertical CrockmeterMethod124 Smoothness Appearance of Fabrics After RepeatedHome Laundering132 Colorfastness to Drycleaning135 Dimensional Changes of Fabrics after Home Launder-ing172 Colorfastness to Powdered Non-Chlorine Bleach inHome Laundering188 Colorfastness to Sodium Hypochlorite Bleach in H
10、omeLaunderingEvaluation Procedure No.1 Gray Scale for Color ChangeEvaluation Procedure No.2 Gray Scale for StainingEvaluation Procedure No.8 AATCC 9-Step ChromaticTransference ScaleA Glossary of AATCC Standard Terminology2.3 Federal Standard:516 CFR,Chapter IIConsumer Product Safety CommissionSubcha
11、pter DFlammable Fabrics Act Regulations2.4 Military Standard:6MIL-STD-105D Sampling Procedures and Tables for In-spection by AttributesNOTE1Reference to test methods in this performance specificationgive only the permanent part of the designation of ASTM,AATCC,or1This performance specification is un
12、der the jurisdiction of ASTM CommitteeD13 on Textiles and is the direct responsibility of Subcommittee D13.61 onApparel.Current edition approved July 1,2014.Published August 2014.Originallyapproved in 1982.Last previous edition approved in 2008 as D4114 02(2008).DOI:10.1520/D4114-14.2For referenced
13、ASTM standards,visit the ASTM website,www.astm.org,orcontact ASTM Customer Service at serviceastm.org.For Annual Book of ASTMStandards volume information,refer to the standards Document Summary page onthe ASTM website.3The last approved version of this historical standard is referenced onwww.astm.or
14、g.4Available from American Association of Textile Chemists and Colorists(AATCC),P.O.Box 12215,Research Triangle Park,NC 27709,http:/www.aatcc.org.5Available from Superintendent of Documents,Government Printing Office,Washington,DC 20402.6Available from Standardization Documents Order Desk,Bldg.4 Sec
15、tion D,700Robbins Ave.,Philadelphia,PA 19111-5094,Attn:NPODS.Copyright ASTM International,100 Barr Harbor Drive,PO Box C700,West Conshohocken,PA 19428-2959.United States1 other test methods.The current editions of each test method cited shallprevail.3.Terminology3.1 Definitions:3.1.1 For terminology
16、 related to apparel see TerminologyD7022.3.1.2 For definitions of textile terms used in this perfor-mance specification,refer to the individualASTM andAATCCmethods and to Terminology D123.3.2 Definitions found in a dictionary of common terms aresuitable for this performance specification.4.Specification Requirements4.1 The properties of woven flat fabrics,to be used aslinings in womens and girls apparel,shall conform to thespecification requirements in Table 1.5.Significance and Use5.1 Upon agre
