1、Designation:D44488(Reapproved 2020)Standard Test Methods forChemical Analysis of Zinc Yellow Pigment(Zinc ChromateYellow)1This standard is issued under the fixed designation D444;the number immediately following the designation indicates the year oforiginal adoption or,in the case of revision,the ye
2、ar of last revision.A number in parentheses indicates the year of last reapproval.Asuperscript epsilon()indicates an editorial change since the last revision or reapproval.This standard has been approved for use by agencies of the U.S.Department of Defense.1.Scope1.1 These test methods cover procedu
3、res for the chemicalanalysis of the pigment known commercially as“zinc yellow”or“zinc chromate yellow.”1.2 The analytical procedures appear in the following order:SectionsMoisture and Other Volatile Matter7Combined Water8Chromium:Dichromate Method9 11Thiosulfate Method9,12,and 13Zinc:Hydroxyquinolin
4、e Method9,14,and 15Ferrocyanide Method9,16,and 17Alkaline Salts18 and 19Sulfates20 and 21Chlorides22 and 23Matter Insoluble in Dilute AceticAcid24Coarse Particles251.3 The values stated in SI units are to be considered thestandard.The values given in parentheses are for informationonly.1.4 This stan
5、dard does not purport to address all of thesafety concerns,if any,associated with its use.It is theresponsibility of the user of this standard to establish appro-priate safety,health,and environmental practices and deter-mine the applicability of regulatory limitations prior to use.1.5 This internat
6、ional standard was developed in accor-dance with internationally recognized principles on standard-ization established in the Decision on Principles for theDevelopment of International Standards,Guides and Recom-mendations issued by the World Trade Organization TechnicalBarriers to Trade(TBT)Committ
7、ee.2.Referenced Documents2.1 ASTM Standards:2D185 Test Methods for Coarse Particles in PigmentsD280 Test Methods for Hygroscopic Moisture(and OtherMatter Volatile Under the Test Conditions)in PigmentsD478 Specification for Zinc Yellow(Zinc Chromate)Pig-mentsD1193 Specification for Reagent WaterE11 S
8、pecification for Woven Wire Test Sieve Cloth and TestSievesE50 Practices for Apparatus,Reagents,and Safety Consid-erations for Chemical Analysis of Metals,Ores,andRelated Materials3.Significance and Use3.1 This test method has been developed to standardize thechemical analysis of zinc chromate yello
9、w pigment and toprovide alternate methods of analysis for chromium and zinc.4.Preparation of Sample4.1 Mix the laboratory sample thoroughly.Take a sufficientquantity for the chemical analyses and pass it through a180-m(No.80)sieve,grinding in a mortar if necessary.NOTE1Detailed requirements for this
10、 sieve are given in SpecificationE11.5.Reagents5.1 Purity of ReagentsUnless otherwise indicated,it isintended that all reagents shall conform to the specifications of1These test methods are under the jurisdiction of ASTM Committee D01 onPaint and Related Coatings,Materials,and Applications and are t
11、he directresponsibility of Subcommittee D01.31 on Pigment Specifications.Current edition approved June 1,2020.Published June 2020.Originallyapproved in 1937.Last previous edition approved in 2014 as D444 88(2014).DOI:10.1520/D0444-88R20.2For referenced ASTM standards,visit the ASTM website,www.astm.
12、org,orcontact ASTM Customer Service at serviceastm.org.For Annual Book of ASTMStandards volume information,refer to the standards Document Summary page onthe ASTM website.Copyright ASTM International,100 Barr Harbor Drive,PO Box C700,West Conshohocken,PA 19428-2959.United StatesThis international st
13、andard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for theDevelopment of International Standards,Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade(TBT)Committee.the Com
14、mittee onAnalytical Reagents of theAmerican Chemi-cal Society,where such specifications are available.3Othergrades may be used,provided it is first ascertained that thereagent is of sufficiently high purity to permit its use withoutlessening the accuracy of the determination.5.2 Purity of WaterUnles
15、s otherwise indicated,referencesto water for use in the preparation of reagents and in analyticalprocedures shall conform to Type II reagent water,in Specifi-cation D1193.6.Precision6.1 Precision statements have not been established.MOISTURE AND OTHER VOLATILE MATTER7.Procedure7.1 Determine moisture
16、 and other volatile matter in accor-dance with Test Method A of Test Methods D280.COMBINED WATER8.Procedure8.1 Weigh to 0.1 mg 3 g of the oven-dried material from thedetermination of moisture and other volatile matter(Note 2 andNote 3),and place in a porcelain boat.Introduce the boat withthe charge into a refractory combustion tube in an electrically-heated combustion furnace of the type used for the determina-tion of carbon in steel by direct combustion(Note 4).Place theboat at the center of th
