1、Designation:D126718Standard Test Method forGauge Vapor Pressure of Liquefied Petroleum(LP)Gases(LP-Gas Method)1This standard is issued under the fixed designation D1267;the number immediately following the designation indicates the year oforiginal adoption or,in the case of revision,the year of last
2、 revision.A number in parentheses indicates the year of last reapproval.Asuperscript epsilon()indicates an editorial change since the last revision or reapproval.1.Scope*1.1 This test method covers the determination of the gaugevapor pressures of liquefied petroleum gas products at tem-peratures of
3、37.8 C(100 F)up to and including a testtemperature of 70 C(158 F).(WarningExtremely flam-mable gas.May be harmful when inhaled.)NOTE1An alternative method for measurement of vapor pressure ofliquefied petroleum gases is Test Method D6897.1.2 The values stated in SI units are to be regarded asstandar
4、d.The values given in parentheses after SI units areprovided for information only and are not considered standard.1.3 This standard does not purport to address all of thesafety concerns,if any,associated with its use.It is theresponsibility of the user of this standard to establish appro-priate safe
5、ty,health,and environmental practices and deter-mine the applicability of regulatory limitations prior to use.For specific warning statements,see 1.1 and Annex A2.1.4 This international standard was developed in accor-dance with internationally recognized principles on standard-ization established i
6、n the Decision on Principles for theDevelopment of International Standards,Guides and Recom-mendations issued by the World Trade Organization TechnicalBarriers to Trade(TBT)Committee.2.Referenced Documents2.1 ASTM Standards:2D323 Test Method for Vapor Pressure of Petroleum Products(Reid Method)D1265
7、 Practice for Sampling Liquefied Petroleum(LP)Gases,Manual MethodD6897 Test Method for Vapor Pressure of Liquefied Petro-leum Gases(LPG)(Expansion Method)3.Terminology3.1 Definitions:3.1.1 liquefied petroleum gas(LP gas,LPG),na nar-row boiling range mixture of hydrocarbons consisting ofpropane,propy
8、lene,butanes,and butylenes,individually or inspecified combinations,with limited amounts of other hydro-carbons(such as ethane)and naturally occurring,petroleum-derived non-hydrocarbons.3.1.2 vapor pressure,nthe pressure exerted by the vaporof a liquid when in equilibrium with the liquid.4.Summary o
9、f Test Method4.1 The test apparatus,consisting of two interconnectedchambers and equipped with a suitable pressure gauge,ispurged with a portion of the sample which is then discarded.The apparatus is then filled completely with the portion of thesample to be tested.Thirty-three and one-third to fort
10、y volumepercent of the sample content of the apparatus is immediatelywithdrawn to provide adequate free space for product expan-sion.The apparatus is then immersed in a water bath main-tained at the standard test temperature of 37.8 C(100 F)or,optionally,at some higher test temperature up to and inc
11、ludinga test temperature of 70 C(158 F).4.2 The observed gauge pressure at equilibrium,after cor-recting for gauge error and correcting to a standard barometricpressure,is reported as the LPG Vapor Pressure at the selectedtest temperature.5.Significance and Use5.1 Information on the vapor pressures
12、of liquefied petro-leum gas products under temperature conditions from 37.8 Cto 70 C(100 F to 158 F)is pertinent to selection of properlydesigned storage vessels,shipping containers,and customerutilization equipment to ensure safe handling of these products.5.2 Determination of the vapor pressure of
13、 liquefied petro-leum gas is important for safety reasons to ensure that themaximum operating design pressures of storage,handling,andfuel systems will not be exceeded under normal operatingtemperature conditions.5.3 For liquefied petroleum gases,vapor pressure can beconsidered a semi-quantitative m
14、easure of the amount of the1This test method is under the jurisdiction of ASTM Committee D02 onPetroleum Products,Liquid Fuels,and Lubricants and is the direct responsibility ofSubcommittee D02.H0 on Liquefied Petroleum Gas.Current edition approved July 1,2018.Published August 2018.Originallyapprove
15、d in 1953.Last previous edition approved in 2012 as D1267 12.DOI:10.1520/D1267-18.2For referenced ASTM standards,visit the ASTM website,www.astm.org,orcontact ASTM Customer Service at serviceastm.org.For Annual Book of ASTMStandards volume information,refer to the standards Document Summary page ont
16、he ASTM website.*A Summary of Changes section appears at the end of this standardCopyright ASTM International,100 Barr Harbor Drive,PO Box C700,West Conshohocken,PA 19428-2959.United StatesThis international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for theDevelopment of International Standards,Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade(TBT)Committ
