1、Designation:D 1807 00(Reapproved 2005)Standard Test Methods forRefractive Index and Specific Optical Dispersion ofElectrical Insulating Liquids1This standard is issued under the fixed designation D 1807;the number immediately following the designation indicates the year oforiginal adoption or,in the
2、 case of revision,the year of last revision.A number in parentheses indicates the year of last reapproval.Asuperscript epsilon(e)indicates an editorial change since the last revision or reapproval.1.Scope1.1 These test methods cover the determination of therefractive index and the specific optical d
3、ispersion of electricalinsulating liquids such as are used in capacitors,transformers,circuit breakers,and oil-filled cables.1.2 Two test methods are described,a routine method and amore precise referee method.Both methods are applicable totransparent,light-colored,insulating liquids.1.2.1 The routi
4、ne method is used to determine refractiveindex and specific optical dispersion as described in these testmethods.1.2.2 The referee method is used when a test of highaccuracy is desired.These methods are described in TestMethod D 1218.Specific optical dispersion is calculated bydividing the refractiv
5、e dispersion value determined in TestMethod D 1218 by the relative density(specific gravity)(seeTest Method D 1298)of the liquid under test.1.3 The values stated in SI units are to be regarded as thestandard.The values given in parentheses are for informationonly.1.4 This standard does not purport t
6、o address all of thesafety concerns,if any,associated with its use.It is theresponsibility of the user of this standard to establish appro-priate safety and health practices and determine the applica-bility of regulatory limitations prior to use.2.Referenced Documents2.1 ASTM Standards:2D 1218 Test
7、Method for Refractive Index and RefractiveDispersion of Hydrocarbon LiquidsD 1298 Test Method for Density,Relative Density(SpecificGravity),or API Gravity of Crude Petroleum and LiquidPetroleum Products by Hydrometer Method3.Terminology3.1 Definitions:3.1.1 refractive index,nthe ratio of the velocit
8、y of light inair to its velocity in the substance under test.3.1.2 relative density(specific gravity),nthe ratio of themass of a given volume of liquid at 15C(60F)to mass of anequal volume of pure water at the same temperature.3.1.3 specific optical dispersion,nthe difference betweenthe refractive i
9、ndexes of light of two different wavelengths,both indexes measured at the same temperature,and divided bythe relative density(specific gravity),also measured at the testtemperature.4.Significance and Use4.1 Refractive IndexThe refractive index of an insulatingliquid varies with its composition and w
10、ith the nature andamount of contaminants held in solution.Changes of refractiveindex with time and service may form a basis for estimatingany change in composition or the degree of containmentacquired in service.For electrical insulating mineral oils,thewavelength of 5893 Afor the spectral line of s
11、odium iscommonly used.The test temperature is 25C.4.2 Specific Optical DispersionSpecific optical dispersionserves as a quick index to the amount of unsaturated com-pounds present in an oil.Dispersion values for paraffinic andnaphthenic compounds are nearly the same and are essentiallyindependent of
12、 molecular weight and structural differences.Values above 97 bear a direct relationship to the amount ofaromatic compounds present in insulating oil.For convenience,the specific dispersion value is multiplied by 104.For electri-cal insulating mineral oils,the wavelengths of 6563 and 48611These test
13、methods are under the jurisdiction of ASTM Committee D27 onElectrical Insulating Liquids and Gases and are the direct responsibility ofSubcommittee D27.07 on Physical Tests.Current edition approved Oct.1,2005.Published November 2005.Originallyapproved in 1960.Last previous edition approved in 2000 a
14、s D 1807 00.2For referenced ASTM standards,visit the ASTM website,www.astm.org,orcontact ASTM Customer Service at serviceastm.org.For Annual Book of ASTMStandards volume information,refer to the standards Document Summary page onthe ASTM website.1Copyright ASTM International,100 Barr Harbor Drive,PO
15、 Box C700,West Conshohocken,PA 19428-2959,United States.Acorresponding to the spectral lines of hydrogen are com-monly used.Alternatively,the wavelengths of 6678 and 5016Acorresponding to the spectral lines of helium may be used.5.Apparatus5.1 RefractometerThe refractometer to be used in theroutine
16、method shall have an index range of approximately1.33 to 1.5 and be readable to 60.0002 units.The refractome-ter used in the referee method is described in Test MethodD 1218.5.2 Light SourceA suitable incandescent illuminator shallbe used as a light source for determinations made by theroutine method;suitable light sources for the referee methodare described in Test Method D 1218.5.3 ThermostatA thermostat capable of supplying waterto the jacketed prisms of the refractometer shall be capable ofm
