1、Designation:D2172/D2172M171Standard Test Methods forQuantitative Extraction of Asphalt Binder from AsphaltMixtures1This standard is issued under the fixed designation D2172/D2172M;the number immediately following the designation indicates theyear of original adoption or,in the case of revision,the y
2、ear of last revision.A number in parentheses indicates the year of lastreapproval.A superscript epsilon()indicates an editorial change since the last revision or reapproval.1NOTE11.2.5.1 was corrected editorially in May 2018.1.Scope1.1 These test methods cover the quantitative determinationof asphal
3、t binder content in asphalt mixtures and pavementsamples.Aggregate obtained by these methods may be used forsieve analysis using Test Method D5444.This test is notappropriate for testing asphalt mixtures containing coal tar.1.2 Asphalt binder may be recovered using Test MethodD1856,Practice D5404/D5
4、404M,or Practice D7906.1.3 UnitsThe values stated in either SI units or inch-pound units are to be regarded separately as standard.Thevalues stated in each system may not be exact equivalents;therefore,each system shall be used independently of the other.Combining values from the two systems may res
5、ult in noncon-formance with the standard.1.4 The text of this standard references notes and footnoteswhich provide explanatory material.These notes and footnotes(excluding those in tables and figures)shall not be consideredas requirements of the standard.1.5 This standard does not purport to address
6、 all of thesafety concerns,if any,associated with its use.It is theresponsibility of the user of this standard to establish appro-priate safety,health,and environmental practices and deter-mine the applicability of regulatory limitations prior to use.Specific hazards are given in Section 7.NOTE1The
7、results obtained by these test methods may be affected bythe age of the material tested,with older samples tending to yield slightlylower asphalt binder content.Best quantitative results are obtained whenthe test is made on mixtures and pavements shortly after their preparation.It is difficult to re
8、move all the asphalt when some aggregates are used andsome chlorides may remain within the mineral matter affecting themeasured asphalt content.1.6 This international standard was developed in accor-dance with internationally recognized principles on standard-ization established in the Decision on P
9、rinciples for theDevelopment of International Standards,Guides and Recom-mendations issued by the World Trade Organization TechnicalBarriers to Trade(TBT)Committee.2.Referenced Documents2.1 ASTM Standards:2C128 Test Method for Relative Density(Specific Gravity)and Absorption of Fine AggregateC670 Pr
10、actice for Preparing Precision and Bias Statementsfor Test Methods for Construction MaterialsD70 Test Method for Density of Semi-Solid Asphalt Binder(Pycnometer Method)D604 Specification for Diatomaceous Silica Pigment(With-drawn 2003)3D979/D979M Practice for Sampling Bituminous PavingMixturesD1461
11、Test Method for Moisture or Volatile Distillates inAsphalt MixturesD1856 Test Method for Recovery of Asphalt From Solutionby Abson MethodD2111 Test Methods for Specific Gravity and Density ofHalogenated Organic Solvents and Their AdmixturesD3666 Specification for Minimum Requirements for Agen-cies T
12、esting and Inspecting Road and Paving MaterialsD4753 Guide for Evaluating,Selecting,and Specifying Bal-ances and Standard Masses for Use in Soil,Rock,andConstruction Materials TestingD5404/D5404M Practice for Recovery of Asphalt from So-lution Using the Rotary EvaporatorD5444 Test Method for Mechani
13、cal Size Analysis of Ex-tracted AggregateD6368 Specification for Vapor-Degreasing Solvents Basedon normal-Propyl Bromide and Technical Grade normal-Propyl Bromide1These test methods are under the jurisdiction of ASTM Committee D04 onRoad and Paving Materials and are the direct responsibilities of Su
14、bcommitteeD04.25 on Analysis of Asphalt Mixtures.Current edition approved April 1,2017.Published April 2017.Originallyapproved in 1963.Last previous edition approved in 2011 as D2172/D2172M 11.DOI:10.1520/D2172_D2172M-17E01.2For referenced ASTM standards,visit the ASTM website,www.astm.org,orcontact
15、 ASTM Customer Service at serviceastm.org.For Annual Book of ASTMStandards volume information,refer to the standards Document Summary page onthe ASTM website.3The last approved version of this historical standard is referenced onwww.astm.org.Copyright ASTM International,100 Barr Harbor Drive,PO Box
16、C700,West Conshohocken,PA 19428-2959.United StatesThis international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for theDevelopment of International Standards,Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade(TBT)Committee.1 D7906 Practice for Recovery of Asphalt from SolutionUsing Toluene and the Rotary Evaporator2.2 AASHTO Standards:R47 Practice for Reduc
