1、Designation:C125413Standard Test Method forDetermination of Uranium in Mineral Acids by X-RayFluorescence1This standard is issued under the fixed designation C1254;the number immediately following the designation indicates the year oforiginal adoption or,in the case of revision,the year of last revi
2、sion.A number in parentheses indicates the year of last reapproval.Asuperscript epsilon()indicates an editorial change since the last revision or reapproval.1.Scope1.1 This test method covers the steps necessary for thepreparation and analysis by X-ray fluorescence(XRF)ofmineral acid solutions conta
3、ining uranium.1.2 This test method is valid for those solutions containing0.05 to 20 g uranium/L as presented to the spectrometer.Higher concentrations may be covered by appropriate dilu-tions.1.3 The values stated in SI units are to be regarded as thestandard.1.4 This standard does not purport to a
4、ddress all of thesafety concerns,if any,associated with its use.It is theresponsibility of the user of this standard to establish appro-priate safety and health practices and determine the applica-bility of regulatory limitations prior to use.Specific precau-tionary statements are given in Section 9
5、 and Note 1.2.Referenced Documents2.1 ASTM Standards:2C859 Terminology Relating to Nuclear MaterialsC982 Guide for Selecting Components for Energy-Dispersive X-Ray Fluorescence(XRF)Systems(With-drawn 2008)3C1118 Guide for Selecting Components for Wavelength-Dispersive X-Ray Fluorescence(XRF)Systems(
6、With-drawn 2011)3D1193 Specification for Reagent WaterE135 Terminology Relating to Analytical Chemistry forMetals,Ores,and Related Materials2.2 Other Document:ANSI/HPS N43.22001 Radiation Safety for X-ray Diffrac-tion and Fluorescence Analysis Equipment43.Terminology3.1 Definitions:3.1.1 See Termino
7、logies E135 and C859 for definitions ofterms applicable to this test method.4.Summary of Test Method4.1 Solution standards containing 0.025 g uranium/L to 20 guranium/L and an appropriate internal standard(usually eitheryttrium or strontium),unless a scatter line is used in lieu of,areplaced in a li
8、quid sample holder of an X-ray spectrometer andexposed to an X-ray beam capable of exciting the uraniumL-alpha emission line and the appropriate emission line for theinternal standard(usually the K-alpha line).The intensitiesgenerated are measured by an appropriate detector.The inten-sity ratio valu
9、es obtained from this data are used to calibratethe X-ray analyzer.5.Significance and Use5.1 This test method is applicable to aqueous solutions ofuranium containing 0.05 to 20 g uranium per litre of solutionpresented to the spectrometer.5.2 Either wavelength-dispersive or energy-dispersiveX-ray flu
10、orescence systems may be used provided the softwareaccompanying the system is able to accommodate the use ofinternal standards.6.Interferences6.1 This test method requires the use of an appropriateinternal standard.Care must be taken to ascertain that samplesanalyzed by this test method do not conta
11、in the internalstandard element or that this contamination has been correctedfor mathematically whenever present.Such corrections are notaddressed in this test method.6.2 Alternatively a scatter line may be used as internalstandard in which case the preparation of internal standard1This test method
12、is under the jurisdiction ofASTM Committee C26 on NuclearFuel Cycle and is the direct responsibility of Subcommittee C26.05 on Methods ofTest.Current edition approved Jan.1,2013.Published January 2013.Originallyapproved in 1993.Last previous edition approved in 1999 as C1254 99(2005).DOI:10.1520/C12
13、54-13.2For referenced ASTM standards,visit the ASTM website,www.astm.org,orcontact ASTM Customer Service at serviceastm.org.For Annual Book of ASTMStandards volume information,refer to the standards Document Summary page onthe ASTM website.3The last approved version of this historical standard is re
14、ferenced onwww.astm.org.4Available from the Health Physics Society,McLean,Virginia,22101.Copyright ASTM International,100 Barr Harbor Drive,PO Box C700,West Conshohocken,PA 19428-2959.United States1 solutions and subsequent doping of samples and calibrationstandards is unnecessary.56.3 Sample must n
15、ot contain significant concentration ofany elements that have mass absorption edges that fall betweenthe energies of the uranium L-alpha line and the internalstandard line.6.4 Care must also be taken that the choice of internalstandard and sample medium are compatible;that is,do not useyttrium with
16、solutions containing HF or strontium with thosehaving H2SO4.7.Apparatus7.1 X-Ray SpectrometerSee Guide C982 or Guide C1118for the selection of the X-ray spectrometer.This test method isvalid for either energy-dispersive or wavelength-dispersivesystems.7.2 Sample Cups:7.2.1 Prepare liquid sample cups for the X-ray spectrometeras described by the manufacturer.Vented,disposable samplecups with snap-on caps are satisfactory for most such analyses;such cups decrease the likelihood of contamination be
