1、 SHEAR STABILITY OF MULTIGRADE ENGINE OILS Institute of Petroleum Fleet Tests Prepared by the Data Analysis Panel of ASTM Committee D-2 Research and Development Division VIIB on the Shear Stability of Fluids ASTM DATA SERIES PUBLICATION DS 49 S-l List price$4.00 05-049001-12*AMERICAN SOCIETY FOR TES
2、TING AND MATERIALS 1916 Race Street,Philadelphia,Pa.19103 BY AMERICAN SOCIETY FOR TESTING AND MATERIALS Library of Congress Catalog Card Number:74-80697 NOTE The Society is not responsible,as a body,for the statements and opinions advanced in this publication.Printed in Gibbsboro,N.J.June 1974 -1-I.
3、SUMMARY Two car fleet programs sponsored by the Institute of Petroleum(I.P.)were conducted on ten ASTM Reference Oils as part of an ASTM program to study methods of evaluating the shear stability characteristics of polymer containing oils.The results obtained from one fleet consisting of conventiona
4、l cars,i.e.,cars having separate oil charges for their engines and their gear boxes,agreed well with the average results from six U.S.car fleets.A second fleet,made up of cars having a common oil charge for the gear boxes and the engine crankcases,sheared the reference oils substantially more than t
5、he other fleets.Viscosity loss results from the second fleet correlated poorly with those from all shear stability bench tests and with results from the other fleets.II.INTRODUCTION AND BACKGROUND In 1969,ASTM R&D Div.VII B-l Subsection on the shear stability of crankcase oils initiated a program to
6、 study ways of evaluating the shear stability of polymer-containing oils under conditions closely related to service.Since then,13 ASTM Reference Oils(AROs)were formulated and evaluated in six United States car fleets and in a variety of bench tests.These results are summarized in ASTM data series r
7、eport,DS49,published in early 1973.*The current report summarizes data from two fleets which were used in tests conducted by the Institute of Petroleum members recently.One fleet was made up of cars which used the same oil charge in both the engine and the trans-mission(hereafter referred to as inte
8、gral gear box cars).The other fleet was of conventional design.Both fleets had seven cars and each fleet evaluated seven of the 13 AROs although the seven were not the same oils in each case.*Numbers in parentheses designate references at the end of report.DS49S1-EB/Jun.1974Copyright 1974 by ASTM In
9、ternational www.astm.org-2-Regression analyses were conducted to determine how well the various fleets agreed and to see if any of the bench tests could satisfactorily predict an oils shear stability as determined with the integral gear box car fleet.III.PROGRAM Test Oils-The ten SAE 10W/40 AROs use
10、d in the two European fleets are shown in Table 1 along with their V.I.improver type.The average 210 and 100 F new oil viscosities determined by seven participants(six I.P.participants plus laboratory P)are compared to those determined by laboratory P,which was the only laboratory that determined th
11、e viscosities of both the base oils and the finished blend.In addition,the viscosities with and without the V.I.improvers are shown along with the 0 F Cold Cranking Simulator viscosities of the finished blends.Car Fleets-The data on the two car fleets are summarized in Table 2.The test lab which ran
12、 each car is listed along with the vehicle make,model,number of cylinders,cubic inch displacement(CID),mileage at start of test,test date and estimated oil consumption rate.Test Designs-The two fleet tests were conducted using the two 7X4(2)Incomplete Latin(Youden)Square test designs shown in Table
13、3.Although each car evaluated only four oils,this design allows each viscosity loss to be corrected for car severity effect as was done with the U.S.fleet data.These calculations are shown in Appendix Tables B-l through B-4.IV.EXPERIMENTAL DATA Fleet Viscosity Data-The field viscosity data submitted
14、 by each sample processor are shown in Appendix Tables A-l through A-4.Each oil sample was stripped in accordance with the revised*procedure.In most cases at least two different laboratories stripped the used oil samples taken from each car and reported the results.An oil(ARO-100)containing 5%minera
15、l spirits was supplied to each oil sample processor to check their stripping procedures.If the processor could not strip all of the diluent out of the sample without removing the light ends of the oil,their data were questioned and,if not satisfactorily re-run,discarded.The average viscosity losses
16、obtained for each oil in each phase of the program are shown in Tables 4 and 5 at both 210 and 100 F.Appendix Tables B-l through B-4 show the statistical treatment of field data for each I.P.fleet and the viscosity losses for each temperature.Section 1 of each table shows the average viscosity losses for each car in each phase of the program.Section 2 shows the average viscosity losses obtained for each oil in each car.Section 3 shows the steps in calculating the correction for car effects.The c
