1、STP 1461 Fatigue and Fracture Mechanics,34 th Volume Steven R.Daniewicz,James C.Newman,and Karl-Heinz Schwalbe,Editors ASTM Stock Number:STP1461 INTERNATIONAL ASTM International 100 Barr Harbor Drive PO Box C700 West Conshohocken,PA 19428-2959 Printed in the U.S.A.Copyright by ASTM Intl(all rights r
2、eserved);Sun Dec 13 19:13:07 EST 2015Downloaded/printed byUniversity of Washington(University of Washington)pursuant to License Agreement.No further reproductions authorized.ISBN:0-8031-3487-8 ISSN:1040-3094 Copyright 2005 ASTM International,West Conshohocken,PA.All rights reserved.This material may
3、 not be reproduced or copied,in whole or in part,in any printed,mechanical,electronic,film,or other distribution and storage media,without the written consent of the publisher.Photocopy Rights Authorization to photocopy items for internal,personal,or educational classroom use,or the internal,persona
4、l,or educational classroom use of specific clients,is granted by ASTM International(ASTM)provided that the appropriate fee is paid to the Copyright Clearance Center,222 Rosewood Drive,Danvers,MA 01923;Tel:978-750-8400;online:http:l.Peer Review Policy Each paper published in this volume was evaluated
5、 by two peer reviewers and at least one editor.The authors addressed all of the reviewers comments to the satisfaction of both the technical editor(s)and the ASTM International Committee on Publications.To make technical information available as quickly as possible,the peer-reviewed papers in this p
6、ublication were prepared camera-ready as submitted by the authors.The quality of the papers in this publication reflects not only the obvious efforts of the authors and the technical editor(s),but also the work of the peer reviewers.In keeping with long-standing publication practices,ASTM Internatio
7、nal maintains the anonymity of the peer reviewers.The ASTM International Committee on Publications acknowledges with appreciation their dedication and contribution of time and effort on behalf of ASTM International.Printed in Lancaster,PA September 2005 Copyright by ASTM Intl(all rights reserved);Su
8、n Dec 13 19:13:07 EST 2015Downloaded/printed byUniversity of Washington(University of Washington)pursuant to License Agreement.No further reproductions authorized.Foreword The Second International ASTM/ESIS Symposium on Fatigue and Fracture Mechanics(34 th National Symposium on Fatigue and Fracture
9、Mechanics)was held in Tampa,Florida on 19-21 November 2003.ASTM International Committee E08 on Fatigue and Fracture and the European Structural Integrity Society(ESIS)served as sponsors.Symposium chairmen and co-editors of this publication were Steven R.Daniewicz,Mississippi State University,Mississ
10、ippi State,MS;James C.Newman,Mississippi State University,Mississippi State,MS;and Karl-Heinz Schwalbe,GKSS Forschungszentrum,Geesthact,Germany.Copyright by ASTM Intl(all rights reserved);Sun Dec 13 19:13:07 EST 2015Downloaded/printed byUniversity of Washington(University of Washington)pursuant to L
11、icense Agreement.No further reproductions authorized.Contents Overview.ix SESSION 1:SWEDLOW LECTURE AND KEYNOTE ADDRESSES Modeling of Three-Dimensional Effects on Fatigue Crack Closure Processes in Small-Scale Yielding-R.H.DODOS,JR.AND S.ROYCHOWDHURY.3 Fractographic Reassessment of the Significance
12、of Fatigue Crack Closure-R.SUNDER.22 SESSION 2A:FATIGUE CRACK GROWTH THRESHOLDS I Load History Effects Resulting from Compression Precracking-M.A.JAMES,S.C.FORTH,AND J.A.NEWMAN.43 Use of ACR Method to Estimate Closure and Residual Stress Free Small Crack Growth Data-H.R.ZONKER,G.U.BRAY,K.GEORGE,AND
13、M.D.GARRATT.60 Influence of Temperature and Microstructure on the Fatigue Behaviour in the Threshold Regime for a Super Duplex Stainless Steel-c.CrtAI AND S.HANSSON.73 SESSION 2B:FRACTURE FUNDAMENTALS Evaluation of the Effect of Crack Tip Constraint on Fatigue Crack Growth Rate in Ineonel 718-J.A.JO
14、YCE.87 V Copyright by ASTM Intl(all rights reserved);Sun Dec 13 19:13:07 EST 2015Downloaded/printed byUniversity of Washington(University of Washington)pursuant to License Agreement.No further reproductions authorized.vi CONTENTS SESSION 3A:FATIGUE CRACK GROWTH THRESHOLDS II The Effect of Negative S
15、tress Ratio Load History on High Cycle Fatigue Threshold-P.J.GOLDEN AND T.NICHOLAS.107 Fatigue Crack Growth Rate and Stress-Intensity Factor Corrections for Out-of-Plane Crack Growth-s.c.FORTH,D.J.HERMAN,M.A.JAMES,AND W.M.JOHNSTON.124 Assessment for Decrease in Threshold Stress Intensity Factor(SIF)
16、Range Due to High Maximum SIF-T.MESHU,K.iSHIHARA,AND K.WATANABE.138 Environmentally Influenced Fatigue in High Strength Steels-E.U.LEE AND A.K.VASUDEVAN.151 SESSION 3B:INTEGRITY ASSESSMENT I Selection of Material for Welded Steel Structures Based on Fracture Mechanics-ms.HOHLER AND G.SEDLACEK.167 Assessment of Plane Stress Tearing in Terms of Various Crack Driving Parameters-v.P.NAUMENKO AND G.S.VOLKOV.182 Evaluation of Fatigue Crack Thresholds Using Various Experimental Methods-s.c.FORTH,J.C.NE
