1、STP 1058 Fatigue and Fracture Testing of Weldments McHenry/Potter,editors ASTM 1916 Race Street Philadelphia,PA 19103 Copyright by ASTM Intl(all rights reserved);Wed Dec 23 18:43:30 EST 2015Downloaded/printed byUniversity of Washington(University of Washington)pursuant to License Agreement.No furthe
2、r reproductions authorized.Library of Congress Cataloging-in-Publication Data Fatigue and fracture testing of weldments/McHenry/Potter,editors.(STP;1058)Papers from a symposium held 25 April 1988,Sparks,Nev.;sponsored by ASTM Committees E-9 on Fatigue and E-24 on Fracture Testing.ASTM publications c
3、ode number(PCN)04-010580-30-T.p.verso.Includes bibliographical references.ISBN 0-8031-1277-7 1.Welded joints-Fatigue-Congresses.2.Welded joints-Testing-Congresses.3.Welded joints-Cracking-Congresses.I.McHenry,Harry I.II.Potter,John M.,1943-.III.ASTM Committee E-9 on Fatigue.IV.ASTM Committee E-24 on
4、 Fracture Testing.V.Series:ASTM special technical publication;1058.TA492.W4F37 1990 671.520422-dc20 90-251 CIP Copyright?9 by AMERICAN SOCIETY FOR TESTING AND MATERIALS 1990 All rights reserved.No part of this publication may be reproduced,stored in a retrieval system,or transmitted,in any form or b
5、y any means,electronic,mechanical,photocopying,recording,or otherwise,without the prior written permission of the publisher.NOTE The Society is not responsible,as a body,for the statements and opinions advanced in this publication.Peer Review Policy Each paper published in this volume was evaluated
6、by three peer reviewers.The authors addressed all of the reviewers comments to the satisfaction of both the technical editor(s)and the ASTM Committee on Publications.The quality of the papers in this publication reflects not only the obvious efforts of the authors and the technical editor(s),but als
7、o the work of these peer reviewers.The ASTM Committee on Publications acknowledges with appreciation their dedication and contribution of time and effort on behalf of ASTM.Printed in Baltimore,MD June 1990 Copyright by ASTM Intl(all rights reserved);Wed Dec 23 18:43:30 EST 2015Downloaded/printed byU
8、niversity of Washington(University of Washington)pursuant to License Agreement.No further reproductions authorized.Foreword The symposium on Fatigue and Fracture Testing of Weldments was held on 25 April 1988 in Sparks,Nevada.The event was sponsored by ASTM Committees E-9 on Fatigue and E-24 on Frac
9、ture Testing.The symposium chairmen were John M.Potter,U.S.Air Force,and Harry I.McHenry,National Institute of Standards and Technology,both of whom also served as editors of this publication.Copyright by ASTM Intl(all rights reserved);Wed Dec 23 18:43:30 EST 2015Downloaded/printed byUniversity of W
10、ashington(University of Washington)pursuant to License Agreement.No further reproductions authorized.Contents Overview vii FATIGUE Procedural Considerations Relating to the Fatigue Testing of Steel Weldments-G.S.BOOTH AND J.G.WYLDE 3 Fatigue Crack Growth of Weldments-LINDA R.LINK 16 Assessing Transv
11、erse Fillet Weld Fatigue Behavior in Aluminum from Full-Size and Small-Specimen Data-D.ERICKSON AND D.KOSTEAS 34 Fatigue Crack Initiation and Growth in Tensile-Shear Spot Weldments-J.C.MCMAHON,G.A.SMITH,AND F.V.LAWRENCE 47 Fatigue of Welded Structural and High-Strength Steel Plate Specimens in Seawa
12、ter-ANIL K.SABLOK AND WILLIAM H.HARTT 78 Corrosion Fatigue Testing of Welded Tubular Joints Under Realistic Service Stress Histories-s.DHARMAVASAN,J.C.P.KAM,AND W.D.DOVER 96 FRACTURE Fracture Toughness Testing of Weld Heat-Affected Zones in Structural Steel-D.P,FAIRCHILD Study of Methods for CTOD Te
13、sting of Weldments-susuMu MACHIDA,TAKASHI MIYATA,MASAHIRO TOYOSADA,AND YUKITO HAGWARA Wide-Plate Testing of Weldments:Introduction-RUDI M DENYS Wide-Plate Testing of Weldments:Part l-Wide-Plate Testing in Perspective-RUDI M.DENYS Wide-Plate Testing of Weldments:Part ll-Wide-Plate Evaluation of Notch
14、 Toughness-RUDt M.OENYS 117 142 157 160 175 Copyright by ASTM Intl(all rights reserved);Wed Dec 23 18:43:30 EST 2015Downloaded/printed byUniversity of Washington(University of Washington)pursuant to License Agreement.No further reproductions authorized.Wide-Plate Testing of Weldments:Part Ill-Heat-A
15、ffected Zone Wide-Plate Studies-RUDI M.DENYS Stress Effect on Post-Weld Heat Treatment Embrittlement-JAE-KYOO LIM AND SE-HI CHUNG Fracture Toughness of Underwater Wet Welds-ROBERT J.DEXTER Fracture Toughness of Manual Metal-Arc and Submerged-Arc Welded Joints in Normalized Carbon-Manganese Steels-WO
16、LFGANG BURGET AND JOHANN G.BLAUEL 204 229 256 272 Author Index Subject Index INDEXES 303 305 Copyright by ASTM Intl(all rights reserved);Wed Dec 23 18:43:30 EST 2015Downloaded/printed byUniversity of Washington(University of Washington)pursuant to License Agreement.No further reproductions authorized.Overview The symposium on Fatigue and Fracture Testing of Weldments was organized to define the state of the art in weldments and welded structures and to give direction to future standards activiti
