1、 IEC 61606-2Edition 2.0 2009-07INTERNATIONAL STANDARD Audio and audiovisual equipment Digital audio parts Basic measurement methods of audio characteristics Part 2:Consumer use IEC 61606-2:2009(E)LICENSED TO MECON Limited.-RANCHI/BANGALOREFOR INTERNAL USE AT THIS LOCATION ONLY,SUPPLIED BY BOOK SUPPL
2、Y BUREAU.THIS PUBLICATION IS COPYRIGHT PROTECTED Copyright 2009 IEC,Geneva,Switzerland All rights reserved.Unless otherwise specified,no part of this publication may be reproduced or utilized in any form or by any means,electronic or mechanical,including photocopying and microfilm,without permission
3、 in writing from either IEC or IECs member National Committee in the country of the requester.If you have any questions about IEC copyright or have an enquiry about obtaining additional rights to this publication,please contact the address below or your local IEC member National Committee for furthe
4、r information.IEC Central Office 3,rue de Varemb CH-1211 Geneva 20 Switzerland Email:inmailiec.ch Web:www.iec.ch About the IEC The International Electrotechnical Commission(IEC)is the leading global organization that prepares and publishes International Standards for all electrical,electronic and re
5、lated technologies.About IEC publications The technical content of IEC publications is kept under constant review by the IEC.Please make sure that you have the latest edition,a corrigenda or an amendment might have been published.?Catalogue of IEC publications:www.iec.ch/searchpub The IEC on-line Ca
6、talogue enables you to search by a variety of criteria(reference number,text,technical committee,).It also gives information on projects,withdrawn and replaced publications.?IEC Just Published:www.iec.ch/online_news/justpub Stay up to date on all new IEC publications.Just Published details twice a m
7、onth all new publications released.Available on-line and also by email.?Electropedia:www.electropedia.org The worlds leading online dictionary of electronic and electrical terms containing more than 20 000 terms and definitions in English and French,with equivalent terms in additional languages.Also
8、 known as the International Electrotechnical Vocabulary online.?Customer Service Centre:www.iec.ch/webstore/custserv If you wish to give us your feedback on this publication or need further assistance,please visit the Customer Service Centre FAQ or contact us:Email:csciec.ch Tel.:+41 22 919 02 11 Fa
9、x:+41 22 919 03 00 LICENSED TO MECON Limited.-RANCHI/BANGALOREFOR INTERNAL USE AT THIS LOCATION ONLY,SUPPLIED BY BOOK SUPPLY BUREAU.IEC 61606-2Edition 2.0 2009-07INTERNATIONAL STANDARD Audio and audiovisual equipment Digital audio parts Basic measurement methods of audio characteristics Part 2:Consu
10、mer use INTERNATIONAL ELECTROTECHNICAL COMMISSION WICS 33.160.01 PRICE CODEISBN 2-8318-1051-7 Registered trademark of the International Electrotechnical Commission LICENSED TO MECON Limited.-RANCHI/BANGALOREFOR INTERNAL USE AT THIS LOCATION ONLY,SUPPLIED BY BOOK SUPPLY BUREAU.2 61606-2 IEC:2009(E)CO
11、NTENTS FOREWORD.5 1 Scope.7 2 Normative references.7 3 Terms,definitions,explanations and rated values.7 3.1 Terms and definitions.7 3.2 Explanation of terms“jitter”.8 3.3 Digital interface for measurement.8 3.4 Rated values.8 4 Measuring conditions.8 4.1 General.8 4.2 Environmental conditions.8 4.3
12、 Power supply.8 4.4 Test signal frequencies.8 4.5 Standard setting.8 4.6 Preconditioning.9 4.7 Measuring instruments.9 4.7.1 General.9 4.7.2 Digital level meter.9 4.7.3 Distortion meter.9 4.7.4 Analogue weighting filter.10 4.7.5 Digital weighting filter.10 4.7.6 Digital spectrum analyzer.10 5 Method
13、s of measurement(digital-in/analogue-out).10 5.1 General.10 5.2 Input/output characteristics.10 5.2.1 Maximum output amplitude.10 5.2.2 Gain difference between channels.11 5.3 Frequency characteristics.11 5.3.1 Frequency response.11 5.3.2 Group delay(phase linearity).12 5.4 Noise characteristics.13
14、5.4.1 Signal-to-noise ratio.13 5.4.2 Dynamic range.13 5.4.3 Out-of-band noise ratio.14 5.4.4 Channel separation.15 5.5 Distortion characteristics.16 5.5.1 Level non-linearity.16 5.5.2 Distortion and noise.17 5.5.3 Intermodulation.17 6 Methods of measurement(analogue-in/digital-out).18 6.1 General.18
15、 6.2 Input/output characteristics.18 6.2.1 Analogue to digital level calibration.18 6.2.2 Maximum allowable input amplitude.20 6.2.3 Gain difference between channel and tracking error.21 6.3 Frequency characteristics.23 LICENSED TO MECON Limited.-RANCHI/BANGALOREFOR INTERNAL USE AT THIS LOCATION ONL
16、Y,SUPPLIED BY BOOK SUPPLY BUREAU.61606-2 IEC:2009(E)3 6.3.1 Frequency response.23 6.3.2 Group delay.24 6.4 Noise characteristics.25 6.4.1 Signal-to-noise ratio(idle channel noise).25 6.4.2 Dynamic range.27 6.4.3 Folded noise.28 6.4.4 Cross-talk.29 6.4.5 Channel separation.31 6.5 Distortion characteristics.33 6.5.1 Level non-linearity.33 6.5.2 Distortion and noise.34 6.5.3 Intermodulation.35 Figure 1 Connection diagram of equipment.11 Figure 2 Connection diagram of equipment.11 Figure 3 Connectio
