1、 Maritime navigation and radiocommunication equipment and systems Digital interfaces Part 101:Single talker and multiple listeners Modified sentences and requirements for IEC 61162-1 P U B L I C L Y A V A I L A B L E S P E C I F I C A T I O N IEC/PAS 61162-101 Edition 1.0 2003-09 Reference number IE
2、C/PAS 61162-101 I N T E R N A T I O N A L E L E C T R O T E C H N I C A L C O M M I S S I O N LICENSED TO MECON Limited.-RANCHI/BANGALOREFOR INTERNAL USE AT THIS LOCATION ONLY,SUPPLIED BY BOOK SUPPLY BUREAU.LICENSED TO MECON Limited.-RANCHI/BANGALOREFOR INTERNAL USE AT THIS LOCATION ONLY,SUPPLIED BY
3、 BOOK SUPPLY BUREAU.Maritime navigation and radiocommunication equipment and systems Digital interfaces Part 101:Single talker and multiple listeners Modified sentences and requirements for IEC 61162-1 P U B L I C L Y A V A I L A B L E S P E C I F I C A T I O N IEC/PAS 61162-101 Edition 1.0 2003-09
4、Reference number IEC/PAS 61162-101 I N T E R N A T I O N A L E L E C T R O T E C H N I C A L C O M M I S S I O N LICENSED TO MECON Limited.-RANCHI/BANGALOREFOR INTERNAL USE AT THIS LOCATION ONLY,SUPPLIED BY BOOK SUPPLY BUREAU.2 Copyright 2003,IEC CONTENTS FOREWORD.3 INTRODUCTION.5 1 Scope.6 2 Normat
5、ive references.6 3 Definitions.6 4 Data format protocol.7 4.1 A new definition for Message is added to Annex B of 61162-1.8 4.2 Editorial correction.8 5 Changes to existing parametric sentences.8 5.1 ABM and BBM are covered in IEC/PAS 61162-100.8 5.2 ACK Acknowledge Alarm.8 5.3 ALR Set Alarm State.9
6、 5.4 ALM GPS almanac data.9 5.5 BWC Bearing and distance to waypoint great circle.9 5.6 DSE,DSI,DSR.9 5.7 GBS GNSS satellite fault detection.9 5.8 GGA Global positioning system(GPS)fix data.9 5.9 GNS GNSS fix data.9 5.10 GRS GNSS range residuals.10 5.11 GSA GNSS DOP and active satellites.10 5.12 GST
7、 GNSS pseudorange noise statistics.10 5.13 GSV GNSS Satellites in View.10 5.14 MLA GLONASS almanac data.10 5.15 MSK MSK receiver interface.11 5.16 RTE Routes.11 5.17 SFI Scanning frequency information.11 5.18 TLB Target label.11 5.19 TXT Text transmission.11 5.20 VTG Course over ground and ground sp
8、eed.11 5.21 XDR Transducer Measurements.11 5.22 XTE correction.12 6 New sentences.12 6.1 CUR Water Current Layer Multi-layer water current data.12 6.2 GMP GNSS Map Projection Fix Data.13 6.3 GSV GNSS Satellites in View.14 6.4 MWV Wind Speed and Angle.15 6.5 TUT Transmission of multi-language text.15
9、 6.6 VLW Dual Ground/Water Distance.17 7 Applications Additions to examples in Section 7 of IEC 61162-1.17 Annex A(normative)Table A.1 Character symbol.19 Annex B(normative)Data content.20 B.1 Character definitions.20 Annex C(normative).22 LICENSED TO MECON Limited.-RANCHI/BANGALOREFOR INTERNAL USE
10、AT THIS LOCATION ONLY,SUPPLIED BY BOOK SUPPLY BUREAU.Copyright 2003,IEC 3 INTERNATIONAL ELECTROTECHNICAL COMMISSION_MARITIME NAVIGATION AND RADIOCOMMUNICATIONEQUIPMENT AND SYSTEMS DIGITAL INTERFACES Part 101:Single talker and multiple listeners Modified sentences and requirements for IEC 61162-1FORE
11、WORD1)The International Electrotechnical Commission(IEC)is a worldwide organization for standardization comprisingall national electrotechnical committees(IEC National Committees).The object of IEC is to promoteinternational co-operation on all questions concerning standardization in the electrical
12、and electronic fields.Tothis end and in addition to other activities,IEC publishes International Standards,Technical Specifications,Technical Reports,Publicly Available Specifications(PAS)and Guides(hereafter referred to as“IECPublication(s)”).Their preparation is entrusted to technical committees;a
13、ny IEC National Committee interestedin the subject dealt with may participate in this preparatory work.International,governmental and non-governmental organizations liaising with the IEC also participate in this preparation.IEC collaborates closelywith the International Organization for Standardizat
14、ion(ISO)in accordance with conditions determined byagreement between the two organizations.2)The formal decisions or agreements of IEC on technical matters express,as nearly as possible,an internationalconsensus of opinion on the relevant subjects since each technical committee has representation fr
15、om allinterested IEC National Committees.3)IEC Publications have the form of recommendations for international use and are accepted by IEC NationalCommittees in that sense.While all reasonable efforts are made to ensure that the technical content of IECPublications is accurate,IEC cannot be held res
16、ponsible for the way in which they are used or for anymisinterpretation by any end user.4)In order to promote international uniformity,IEC National Committees undertake to apply IEC Publicationstransparently to the maximum extent possible in their national and regional publications.Any divergencebetween any IEC Publication and the corresponding national or regional publication shall be clearly indicated inthe latter.5)IEC provides no marking procedure to indicate its approval and cannot be rende