1、Information technology Telecommunications and information exchange between systems NFCIP-2 test methodsTechnologies de linformation Tlinformatique Mthodes dessai NFCIP-2 ISO/IEC 2014INTERNATIONAL STANDARDISO/IEC19369First edition2014-08-15Reference numberISO/IEC 19369:2014(E)ISO/IEC 19369:2014(E)ii
2、ISO/IEC 2014 All rights reservedCOPYRIGHT PROTECTED DOCUMENT ISO/IEC 2014All rights reserved.Unless otherwise specified,no part of this publication may be reproduced or utilized otherwise in any form or by any means,electronic or mechanical,including photocopying,or posting on the internet or an int
3、ranet,without prior written permission.Permission can be requested from either ISO at the address below or ISOs member body in the country of the requester.ISO copyright officeCase postale 56 CH-1211 Geneva 20Tel.+41 22 749 01 11Fax+41 22 749 09 47E-mail copyrightiso.orgWeb www.iso.orgPublished in S
4、witzerland ISO/IEC 19369:2014(E)ISO/IEC 2014 All rights reserved iiiContents PageForeword.ivIntroduction.v1 Scope.12 Conformance.13 Normative references.14 Acronyms.25 Test environment and apparatus.26 Tests.36.1 Test External RF Field detection.36.2 Test Mode selection and switching.3 ISO/IEC 19369
5、:2014(E)ForewordISO(the International Organization for Standardization)and IEC(the International Electrotechnical Commission)form the specialized system for worldwide standardization.National bodies that are members of ISO or IEC participate in the development of International Standards through tech
6、nical committees established by the respective organization to deal with particular fields of technical activity.ISO and IEC technical committees collaborate in fields of mutual interest.Other international organizations,governmental and non-governmental,in liaison with ISO and IEC,also take part in
7、 the work.In the field of information technology,ISO and IEC have established a joint technical committee,ISO/IEC JTC 1.The procedures used to develop this document and those intended for its further maintenance are described in the ISO/IEC Directives,Part 1.In particular the different approval crit
8、eria needed for the different types of document should be noted.This document was drafted in accordance with the editorial rules of the ISO/IEC Directives,Part 2(see www.iso.org/directives).Attention is drawn to the possibility that some of the elements of this document may be the subject of patent
9、rights.ISO and IEC shall not be held responsible for identifying any or all such patent rights.Details of any patent rights identified during the development of the document will be in the Introduction and/or on the ISO list of patent declarations received(see www.iso.org/patents).Any trade name use
10、d in this document is information given for the convenience of users and does not constitute an endorsement.For an explanation on the meaning of ISO specific terms and expressions related to conformity assessment,as well as information about ISOs adherence to the WTO principles in the Technical Barr
11、iers to Trade(TBT)see the following URL:Foreword-Supplementary informationISO/IEC 19369 was prepared by Ecma International(as ECMA-403)and was adopted,under a special“fast-track procedure”,by Joint Technical Committee ISO/IEC JTC 1,Information technology,in parallel with its approval by national bod
12、ies of ISO and IEC.iv ISO/IEC 2014 All rights reserved ISO/IEC 19369:2014(E)IntroductionThis International Standard specifies test methods for ISO/IEC 21481 in addition to those specified in the referenced standards.ISO/IEC 2014 All rights reserved v Information technology Telecommunications and inf
13、ormation exchange between systems NFCIP-2 test methods1 ScopeThis International Standard specifies requirements to verify NFCIP-2 mode selection and initial communication in the selected modes.The Test Management Service Data Units and the interface over which they are exchanged are out of scope.2 C
14、onformanceConforming implementations pass the tests in Clause 6 using the test environment and apparatus as specified in Clause 5.3 Normative referencesThe following documents,in whole or in part,are normatively referenced in this document and are indispensable for its application.For dated referenc
15、es,only the edition cited applies.For undated references,the latest edition of the referenced document(including any amendments)applies.ISO/IEC 9646,Information technology Open Systems Interconnection Conformance testing methodology and frameworkISO/IEC 10373-6,Identification cards Test methods Part
16、 6:Proximity cardsISO/IEC 10373-7,Identification cards Test methods Part 7:Vicinity cardsISO/IEC 14443-3,Identification cards Contactless integrated circuit cards Proximity cards Part 3:Initialization and anticollisionISO/IEC 18092:2013,Information technology Telecommunications and information exchange between systems Near Field Communication Interface and Protocol(NFCIP-1)(also published by Ecma as Standard ECMA-340)ISO/IEC 21481:2012,Information technology Telecommunications and information ex
