1、 Reference numberISO/IEC 23290:2004(E)ISO/IEC 2004 INTERNATIONAL STANDARD ISO/IEC23290Second edition2004-10-01 Information technology Telecommunications and information exchange between systems Private Integrated Services Network(PISN)Mapping functions for the tunnelling of QSIG through H.323 networ
2、ks Technologies de linformation Tlcommunications et change dinformation entre systmes Rseau priv avec intgration de services(PISN)Fonctions dapplication pour lemploi de laction tunnel de QSIG travers les rseaux H.323 ISO/IEC 23290:2004(E)PDF disclaimer This PDF file may contain embedded typefaces.In
3、 accordance with Adobes licensing policy,this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing.In downloading this file,parties accept therein the responsibility of not infringing Adobes
4、 licensing policy.The ISO Central Secretariat accepts no liability in this area.Adobe is a trademark of Adobe Systems Incorporated.Details of the software products used to create this PDF file can be found in the General Info relative to the file;the PDF-creation parameters were optimized for printi
5、ng.Every care has been taken to ensure that the file is suitable for use by ISO member bodies.In the unlikely event that a problem relating to it is found,please inform the Central Secretariat at the address given below.ISO/IEC 2004 All rights reserved.Unless otherwise specified,no part of this publ
6、ication may be reproduced or utilized in any form or by any means,electronic or mechanical,including photocopying and microfilm,without permission in writing from either ISO at the address below or ISOs member body in the country of the requester.ISO copyright office Case postale 56 CH-1211 Geneva 2
7、0 Tel.+41 22 749 01 11 Fax +41 22 749 09 47 E-mail copyrightiso.org Web www.iso.org Published in Switzerland ii ISO/IEC 2004 All rights reserved ISO/IEC 23290:2004(E)ISO/IEC 2004 All rights reserved iii Contents Page Foreword.iv Introduction.v 1 Scope.1 2 Conformance.1 3 Normative references.1 4 Ter
8、ms and definitions.2 4.1 External definitions.2 4.2 Other definitions.2 4.2.1 Call.2 4.2.2 Channel.3 4.2.3 Inter-PINX Connection(IPC).3 4.2.4 Inter-PINX Link(IPL).3 4.2.5 PINX roles.3 5 List of acronyms.3 6 Introduction.4 6.1 Reference configuration.4 6.2 Specific scenarios.4 6.3 Relationship with H
9、.323 gateways.5 7 Capabilities at the Q reference point.6 8 Capabilities at the C reference point.6 9 Mapping functions.7 9.1 General requirements.7 9.2 Mapping of the DQ-channel.7 9.3 Mapping of the UQ-channel(s).7 9.3.1 On-demand scenario.7 9.3.2 Semi-permanent scenario.7 10 IPC control procedures
10、.8 10.1 Protocol identification.8 10.2 Registration with gatekeeper.8 10.3 Systems without gatekeeper.8 10.4 H.323 call establishment.8 10.4.1 Call admission.8 10.4.2 Outgoing call establishment.9 10.4.3 Incoming call establishment.9 10.5 Transfer of inter-PINX signalling information.10 10.6 H.323 c
11、all clearing.10 11 Scenario specific procedures.10 11.1 On-demand scenario.10 11.2 Semi-permanent scenario.11 Annex A(normative)Implementation Conformance Statement(ICS)Proforma.13 Annex B(informative)Examples of message sequences.20 ISO/IEC 23290:2004(E)iv ISO/IEC 2004 All rights reserved Foreword
12、ISO(the International Organization for Standardization)and IEC(the International Electrotechnical Commission)form the specialized system for worldwide standardization.National bodies that are members of ISO or IEC participate in the development of International Standards through technical committees
13、 established by the respective organization to deal with particular fields of technical activity.ISO and IEC technical committees collaborate in fields of mutual interest.Other international organizations,governmental and non-governmental,in liaison with ISO and IEC,also take part in the work.In the
14、 field of information technology,ISO and IEC have established a joint technical committee,ISO/IEC JTC 1.International Standards are drafted in accordance with the rules given in the ISO/IEC Directives,Part 2.The main task of the joint technical committee is to prepare International Standards.Draft I
15、nternational Standards adopted by the joint technical committee are circulated to national bodies for voting.Publication as an International Standard requires approval by at least 75%of the national bodies casting a vote.Attention is drawn to the possibility that some of the elements of this documen
16、t may be the subject of patent rights.ISO and IEC shall not be held responsible for identifying any or all such patent rights.ISO/IEC 23290 was prepared by Ecma International(as ECMA-333)and was adopted,under a special“fast-track procedure”,by Joint Technical Committee ISO/IEC JTC 1,Information technology,Subcommittee SC 6,Telecommunications and information exchange between systems,in parallel with its approval by national bodies of ISO and IEC.This second edition cancels and replaces the first
