1、Designation:D90914Method 6012.6Federal TestMethod Standard No.791bDesignation:119/96Standard Test Method forSupercharge Rating of Spark-Ignition Aviation Gasoline1This standard is issued under the fixed designation D909;the number immediately following the designation indicates the year oforiginal a
2、doption or,in the case of revision,the year of last revision.A number in parentheses indicates the year of last reapproval.Asuperscript epsilon()indicates an editorial change since the last revision or reapproval.This standard has been approved for use by agencies of the U.S.Department of Defense.1.
3、Scope*1.1 This laboratory test method covers the quantitativedetermination of supercharge ratings of spark-ignition aviationgasoline.The sample fuel is tested using a standardized singlecylinder,four-stroke cycle,indirect injected,liquid cooled,CFR engine run in accordance with a defined set of oper
4、atingconditions.1.2 The supercharge rating is calculated by linear interpo-lation of the knock limited power of the sample compared tothe knock limited power of bracketing reference fuel blends.1.3 The rating scale covers the range from 85 octanenumber to Isooctane+6.0 mL TEL/U.S.gal.1.4 The values
5、of operating conditions are stated in SI unitsand are considered standard.The values in parentheses are thehistorical inch-pound units.The standardized CFR enginemeasurements and reference fuel concentrations continue to bein historical units.1.5 This standard does not purport to address all of thes
6、afety concerns,if any,associated with its use.It is theresponsibility of the user of this standard to establish appro-priate safety and health practices and determine the applica-bility of regulatory limitations prior to use.Specific precau-tionary statements are given in Annex A1.2.Referenced Docum
7、ents2.1 ASTM Standards:2D1193 Specification for Reagent WaterD2268 Test Method for Analysis of High-Purity n-Heptaneand Isooctane by Capillary Gas ChromatographyD3237 Test Method for Lead in Gasoline byAtomicAbsorp-tion SpectroscopyD3341 Test Method for Lead in GasolineIodine Mono-chloride MethodD40
8、57 Practice for Manual Sampling of Petroleum andPetroleum ProductsD4175 Terminology Relating to Petroleum,PetroleumProducts,and LubricantsD5059 Test Methods for Lead in Gasoline by X-Ray Spec-troscopyE344 Terminology Relating to Thermometry and Hydrom-etryE456 Terminology Relating to Quality and Sta
9、tistics2.2 CFR Engine Manuals:3CFR F-4 Form 846 Supercharge Method Aviation GasolineRating Unit Installation ManualCFR F-4 Form 893 Supercharge Method Aviation GasolineRating Unit Operation&Maintenance2.3 Energy Institute Standard:4IP 224/02 Determination of Low Lead Content of LightPetroleum Distil
10、lates by Dithizone Extraction and Colo-rimetric Method2.4 ASTM Adjuncts:Rating Data Sheet5Reference Fuel Framework Graphs63.Terminology3.1 Definitions:3.1.1 accepted reference value,na value that serves as anagreed-upon reference for comparison,and which is derivedas:(1)a theoretical or established
11、value,based on scientificprinciples,or(2)an assigned or certified value,based on1This test method is under the jurisdiction of ASTM Committee D02 onPetroleum Products,Liquid Fuels,and Lubricants and is the direct responsibility ofSubcommittee D02.01 on Combustion Characteristics.Current edition appr
12、oved May 1,2014.Published May 2014.Originallyapproved in 1958.Last previous edition approved in 2012 as D909 07(2012)1.DOI:10.1520/D0909-14.2For referenced ASTM standards,visit the ASTM website,www.astm.org,orcontact ASTM Customer Service at serviceastm.org.For Annual Book of ASTMStandards volume in
13、formation,refer to the standards Document Summary page onthe ASTM website.3Available from Waukesha Engine,Dresser Inc.,1101 West St.Paul Ave.,Waukesha,WI 53188.4Available from Energy Institute,61 New Cavendish St.,London,WIG 7AR,U.K.5Available from ASTM International Headquarters.Order Adjunct No.AD
14、JD090901.Original adjunct produced in 1953.6Available from ASTM International Headquarters.Order Adjunct No.ADJD090902.Original adjunct produced in 1953.*A Summary of Changes section appears at the end of this standardCopyright ASTM International,100 Barr Harbor Drive,PO Box C700,West Conshohocken,P
15、A 19428-2959.United States1 experimental work of some national or internationalorganization,or(3)a consensus or certified value,based oncollaborative experimental work under the auspices of ascientific or engineering group.E4563.1.1.1 DiscussionIn the context of this test method,accepted reference v
16、alue is understood to apply to the Super-charge and octane number ratings of specific reference mate-rials determined empirically under reproducibility conditionsby the National Exchange Group or another recognized ex-change testing organization.3.1.2 check fuel,nfor quality control testing,a spark-ignition aviation gasoline having supercharge rating ARVdetermined by the National Exchange Group.3.1.3 firing,nfor the CFR engine,operation of the CFRengine with fuel and ignition.3.1.4 fuel-air rati
