1、Designation:E122817Standard Test Method forAssay of Peroxy EstersCatalyzed Iodometric Procedure1This standard is issued under the fixed designation E1228;the number immediately following the designation indicates the year oforiginal adoption or,in the case of revision,the year of last revision.A num
2、ber in parentheses indicates the year of last reapproval.Asuperscript epsilon()indicates an editorial change since the last revision or reapproval.1.Scope*1.1 This test method covers the assay of organic peroxidesof the peroxy ester type.NOTE1Other test methods for the assay of organic peroxides are
3、given in Test Methods E298,E475,and E755.1.2 Review the current safety data sheets(SDS)for detailedinformation concerning toxicity,first aid procedures,and safetyprecautions.1.3 The values stated in SI units are to be regarded as thestandard.No other units of measurement are included in thistest met
4、hod.1.4 This standard does not purport to address all of thesafety concerns,if any,associated with its use.It is theresponsibility of the user of this standard to establish appro-priate safety and health practices and determine the applica-bility of regulatory limitations prior to use.Specific hazar
5、dsstatements are given in Section 9.1.5 This international standard was developed in accor-dance with internationally recognized principles on standard-ization established in the Decision on Principles for theDevelopment of International Standards,Guides and Recom-mendations issued by the World Trad
6、e Organization TechnicalBarriers to Trade(TBT)Committee.2.Referenced Documents2.1 ASTM Standards:2D1193 Specification for Reagent WaterD6809 Guide for Quality Control and Quality AssuranceProcedures for Aromatic Hydrocarbons and Related Ma-terialsE180 Practice for Determining the Precision of ASTMMe
7、thods for Analysis and Testing of Industrial and Spe-cialty Chemicals(Withdrawn 2009)3E200 Practice for Preparation,Standardization,and Storageof Standard and Reagent Solutions for Chemical AnalysisE298 Test Methods for Assay of Organic PeroxidesE475 Test Method for Assay of Di-tert-Butyl PeroxideUs
8、ing Gas ChromatographyE755 Test Method for Dicumyl Peroxide,Assay(LiquidChromatography)(Withdrawn 2016)33.Terminology3.1 Definitions:3.1.1 active oxygenthe oxidizing power present in organicperoxides expressed as oxygen(equivalent weight 8.00).4.Summary of Test Method4.1 A sample is dissolved in a m
9、ixture of isopropyl alcohol,acetic acid,and cupric chloride.Asolution of potassium iodideis added and the mixture is briefly heated,then allowed to reactin the dark at room temperature for 30 min.The cupric ioncatalyzes the reduction of the peroxide and the liberated iodineis titrated with standard
10、sodium thiosulfate solution.5.Significance and Use5.1 Peroxyestersarewidelyusedaschemicalintermediates,catalysts,and initiators.This test method pro-vides a procedure for assaying peroxy esters to determine ifthey are suitable for their intended use.6.Interferences6.1 Conjugated diolefins interfere
11、under the conditions ofanalysis by absorbing iodine.7.Apparatus7.1 Iodine Flasks,250-mL capacity,with stoppers.NOTE2All glassware should be cleaned thoroughly with dichromatecleaning solution before use.7.2 Beakers,1-mL capacity,glass or PTFE.7.3 Buret,50-mL capacity,graduated in 0.1-mL subdivi-sion
12、s.1This test method is under the jurisdiction of ASTM Committee D16 onAromatic,Industrial,Specialty and Related Chemicals and is the direct responsi-bility of Subcommittee D16.15 on Industrial and Specialty General Standards.Current edition approved June 1,2017.Published July 2017.Originally approve
13、din 1988.Last previous edition approved in 2009 as E1228 09.DOI:10.1520/E1228-17.2For referenced ASTM standards,visit the ASTM website,www.astm.org,orcontact ASTM Customer Service at serviceastm.org.For Annual Book of ASTMStandards volume information,refer to the standards Document Summary page onth
14、e ASTM website.3The last approved version of this historical standard is referenced onwww.astm.org.*A Summary of Changes section appears at the end of this standardCopyright ASTM International,100 Barr Harbor Drive,PO Box C700,West Conshohocken,PA 19428-2959.United StatesThis international standard
15、was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for theDevelopment of International Standards,Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade(TBT)Committee.1 7.4 Water Ba
16、th,maintained at 60C.8.Reagents8.1 Purity of ReagentsReagent grade chemicals shall beused in all tests.Unless otherwise indicated,it is intended thatall reagents shall conform to the Specifications of the Com-mittee on Analytical Reagents of the American ChemicalSociety,where such specifications are available.4Other gradesmay be used,provided it is first ascertained that the reagent isof sufficiently high purity to permit its use without lesseningthe accuracy of the determination.8.2 Purity of W