1、Designation:D787520Standard Test Method forDetermination of Butanol and Acetone Content of Butanolfor Blending with Gasoline by Gas Chromatography1This standard is issued under the fixed designation D7875;the number immediately following the designation indicates the year oforiginal adoption or,in t
2、he case of revision,the year of last revision.A number in parentheses indicates the year of last reapproval.Asuperscript epsilon()indicates an editorial change since the last revision or reapproval.1.Scope*1.1 This test method covers the determination of the butanolcontent of butanol for blending wi
3、th gasoline by gas chroma-tography.1.2 Butanol is determined from 95%to 99.9%by mass,acetone is determined from 0.02%to 1.5%by mass,ethanolis determined from 0.02%to 1.5%by mass,and methanol isdetermined from 0.02%to 1.5%by mass.Equations used toconvert these individual components from mass percent
4、tovolume percent are provided.This test method has not beenevaluated for use with the butanol isomer 2-methyl-2-propanol.1.3 This test method identifies and quantifies acetone,ethanol,and methanol,but does not purport to identify allindividual components that may be present in butanol forgasoline bl
5、ending.1.4 Water cannot be determined by this test method andshall be measured by a procedure such as Test Method D1364and the result used to correct the chromatographic values.1.5 This test method is inappropriate for impurities that boilat temperatures higher than 225 C or for impurities that caus
6、epoor or no response in a flame ionization detector,such aswater.1.6 The values stated in SI units are to be regarded asstandard.No other units of measurement are included in thisstandard.1.7 This standard does not purport to address all of thesafety concerns,if any,associated with its use.It is the
7、responsibility of the user of this standard to establish appro-priate safety,health,and environmental practices and deter-mine the applicability of regulatory limitations prior to use.1.8 This international standard was developed in accor-dance with internationally recognized principles on standard-
8、ization established in the Decision on Principles for theDevelopment of International Standards,Guides and Recom-mendations issued by the World Trade Organization TechnicalBarriers to Trade(TBT)Committee.2.Referenced Documents2.1 ASTM Standards:2D1298 Test Method for Density,Relative Density,or APIG
9、ravity of Crude Petroleum and Liquid Petroleum Prod-ucts by Hydrometer MethodD1364 Test Method for Water in Volatile Solvents(KarlFischer Reagent Titration Method)D4052 Test Method for Density,Relative Density,and APIGravity of Liquids by Digital Density MeterD4057 Practice for Manual Sampling of Pe
10、troleum andPetroleum ProductsD4307 Practice for Preparation of Liquid Blends for Use asAnalytical StandardsD4626 Practice for Calculation of Gas ChromatographicResponse FactorsD4806 Specification for Denatured Fuel Ethanol for Blend-ing with Gasolines for Use as Automotive Spark-IgnitionEngine FuelD
11、6299 Practice for Applying Statistical Quality Assuranceand Control Charting Techniques to Evaluate AnalyticalMeasurement System PerformanceD6300 Practice for Determination of Precision and BiasData for Use in Test Methods for Petroleum Products,Liquid Fuels,and LubricantsD7862 Specification for But
12、anol for Blending with Gasolinefor Use as Automotive Spark-Ignition Engine FuelE355 Practice for Gas Chromatography Terms and Relation-shipsE594 Practice for Testing Flame Ionization Detectors Usedin Gas or Supercritical Fluid ChromatographyE1064 Test Method for Water in Organic Liquids by Coulo-met
13、ric Karl Fischer Titration1This test method is under the jurisdiction of ASTM Committee D02 onPetroleum Products,Liquid Fuels,and Lubricants and is the direct responsibility ofSubcommittee D02.04.0L on Gas Chromatography Methods.Current edition approved Dec.1,2020.Published January 2021.Originallyap
14、proved in 2014.Last previous edition approved in 2014 as D7875 14.DOI:10.1520/D7875-20.2For referenced ASTM standards,visit the ASTM website,www.astm.org,orcontact ASTM Customer Service at serviceastm.org.For Annual Book of ASTMStandards volume information,refer to the standards Document Summary pag
15、e onthe ASTM website.*A Summary of Changes section appears at the end of this standardCopyright ASTM International,100 Barr Harbor Drive,PO Box C700,West Conshohocken,PA 19428-2959.United StatesThis international standard was developed in accordance with internationally recognized principles on stan
16、dardization established in the Decision on Principles for theDevelopment of International Standards,Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade(TBT)Committee.13.Terminology3.1 DefinitionsThis test method makes reference to manycommon gas chromatographic procedures,terms,and relation-ships.Detailed definitions can be found in Practices E355 andE594.3.1.1 butanol,nbutyl alcohol refers to:1-butanol orn-butanol(CH3CH2CH2CH2OH),2-butanol or sec-butano
