1、Designation:D659111Designation:548/06Standard Test Method forDetermination of Aromatic Hydrocarbon Types in MiddleDistillatesHigh Performance Liquid ChromatographyMethod with Refractive Index Detection1This standard is issued under the fixed designation D6591;the number immediately following the des
2、ignation indicates the year oforiginal adoption or,in the case of revision,the year of last revision.A number in parentheses indicates the year of last reapproval.Asuperscript epsilon()indicates an editorial change since the last revision or reapproval.INTRODUCTIONThis test method has the same title
3、 as IP 548-06 and is intended to be technically equivalent.TheASTM format for test methods has been used,and where possible,equivalent ASTM test methodshave replaced the IP or ISO standards.The test method is intended to be used as one of several possible alternative instrumental testmethods that ar
4、e aimed at quantitative determination of hydrocarbon types in fuels.This does notimply that a correlation necessarily exists between this and any other test method intended to give thisinformation,and it is the responsibility of the user to determine such correlation if necessary.1.Scope*1.1 This te
5、st method covers a high performance liquidchromatographic test method for the determination of mono-aromatic,di-aromatic,tri+-aromatic,and polycyclic aromatichydrocarbon contents in diesel fuels and petroleum distillatesboiling in the range from 150 to 400C.The total aromaticcontent in%m/m is calcul
6、ated from the sum of the corre-sponding individual aromatic hydrocarbon types.NOTE1Aviation fuels and petroleum distillates with a boiling pointrange from 50 to 300C are not determined by this test method and shouldbe analyzed by Test Method,D6379 or other suitable equivalent testmethods.1.2 The pre
7、cision of this test method has been establishedfor diesel fuels and their blending components,containingfrom 4 to 40%(m/m)mono-aromatic hydrocarbons,0 to 20%(m/m)di-aromatic hydrocarbons,0 to 6%(m/m)tri+-aromatichydrocarbons,0 to 26%(m/m)polycyclic aromatichydrocarbons,and 4 to 65%(m/m)total aromati
8、c hydrocar-bons.1.3 Compounds containing sulfur,nitrogen,and oxygen arepossible interferents.Mono-alkenes do not interfere,but con-jugated di-and poly-alkenes,if present,are possible interfer-ents.1.4 By convention,this standard defines the aromatic hy-drocarbon types on the basis of their elution c
9、haracteristicsfrom the specified liquid chromatography column relative tomodel aromatic compounds.Quantification is by externalcalibration using a single aromatic compound,which may ormay not be representative of the aromatics in the sample,foreach aromatic hydrocarbon type.Alternative techniques an
10、dmethods may classify and quantify individual aromatic hydro-carbon types differently.1.5 Fatty Acid Methyl Esters(FAME),if present,interferewith tri+-aromatic hydrocarbons.If this method is used fordiesel containing FAME,the amount of tri+-aromatics will beover estimated.1.6 This standard does not
11、purport to address all of thesafety concerns,if any,associated with its use.It is theresponsibility of the user of this standard to establish appro-priate safety and health practices and determine the applica-bility of regulatory limitations prior to use.1This test method is under the jurisdiction o
12、f ASTM Committee D02 onPetroleum Products,Liquid Fuels,and Lubricants and is the direct responsibility ofSubcommittee D02.04.0C on Liquid Chromatography.This test method is based on material published in IP Standard Methods forAnalysis and Testing of Petroleum and Related Products and British Standa
13、rd 2000Parts,copyright The Institute of Petroleum,61 New Cavendish Street,LondonW1M 8AR.Adapted with permission of The Institute of Petroleum.Current edition approved Dec.1,2011.Published February 2012.Originallyapproved in 2000.Last previous edition approved in 2006 as D659106.DOI:10.1520/D6591-11.
14、*A Summary of Changes section appears at the end of this standardCopyright ASTM International,100 Barr Harbor Drive,PO Box C700,West Conshohocken,PA 19428-2959.United States1 2.Referenced Documents2.1 ASTM Standards:2D1319 Test Method for Hydrocarbon Types in Liquid Petro-leum Products by Fluorescen
15、t Indicator AdsorptionD2425 Test Method for Hydrocarbon Types in Middle Dis-tillates by Mass SpectrometryD4057 Practice for Manual Sampling of Petroleum andPetroleum ProductsD4177 Practice for Automatic Sampling of Petroleum andPetroleum ProductsD5186 Test Method for Determination of the AromaticCon
16、tent and Polynuclear Aromatic Content of DieselFuels and Aviation Turbine Fuels By Supercritical FluidChromatographyD6379 Test Method for Determination of Aromatic Hydro-carbonTypesinAviationFuelsandPetroleumDistillatesHigh Performance Liquid ChromatographyMethod with Refractive Index Detection2.2 Energy Institute Standard:3IP 548 Test Method for Determination of Aromatic Hydro-carbon Types in Middle Distillates High PerformanceLiquid Chromatography Method with Refractive IndexDetection3.Termino
