1、Designation:D536213Standard Test Method forSnagging Resistance of Fabrics(Bean Bag)1This standard is issued under the fixed designation D5362;the number immediately following the designation indicates the year oforiginal adoption or,in the case of revision,the year of last revision.A number in paren
2、theses indicates the year of last reapproval.Asuperscript epsilon()indicates an editorial change since the last revision or reapproval.1.Scope1.1 This test method determines the snagging resistance of afabric.1.2 Studies of fabric snagging have shown that this testmethod is suitable for a range of w
3、oven and knitted fabricsmade from textured or untextured filament yarns or spun yarnsor combinations of these yarns.2,3This test method is notsuitable for(1)open construction fabrics(such as a net)because the pins in the test chamber will snag the bean bagrather than the specimen,(2)heavy or stiff f
4、abrics that cannotbe made into a cover for the bean bag,and(3)tufted ornonwoven fabrics because the apparatus is designed for wovenand knitted fabrics.1.3 The values stated in either acceptable metric units or inother units shall be regarded separately as standard.The valuesstated in each system may
5、 not be the exact equivalents;therefore,each system must be used independently of the other,without combining values in any way.In case of refereedecisions the metric units will prevail.1.4 This standard does not purport to address all of thesafety concerns,if any,associated with its use.It is there
6、sponsibility of the user of this standard to establish appro-priate safety and health practices and determine the applica-bility of regulatory limitations prior to use.Specific precau-tionary statements are given in Section 7.2.Referenced Documents2.1 ASTM Standards:4D123 Terminology Relating to Tex
7、tilesD1335 Test Method for Tuft Bind of Pile Yarn FloorCoveringsD1776 Practice for Conditioning and Testing TextilesD2724 Test Methods for Bonded,Fused,and LaminatedApparel FabricsD3136 Terminology Relating to Care Labeling for Apparel,Textile,Home Furnishing,and Leather ProductsD3939 Test Method fo
8、r Snagging Resistance of Fabrics(Mace)D4467 Practice for Interlaboratory Testing of a Textile TestMethod That Produces Non-Normally Distributed Data(Withdrawn 2010)5D4850 Terminology Relating to Fabrics and Fabric TestMethods2.2 AATCC Standards:665 Test Method for Snag Resistance of Womens NylonHosi
9、ery(see Note 1)135 Test Method for Dimensional Changes in AutomaticHome Laundering of Woven and Knit FabricsNOTE1In 1988 the AATCC voted to withdraw this test method fromtheir technical manual;however,theASTM task group on fabric snaggingdecided it should be listed as an alternative for testing open
10、 constructionfabrics.3.Terminology3.1 Definitions:3.1.1 For definitions of textile terms used in this testmethod:color contrast,in textiles;distortion in fabrics;protrusion,in fabrics;snag,in fabrics;snagging resistance,infabrics;refer to Terminology D4850.3.1.2 For definitions of other textile term
11、s used in this testmethod,refer to Terminology D123.4.Summary of Test Method4.1 A fabric specimen is made into a cover for a bean bag.Then the specimen and bean bag unit is tumbled for 100revolutions in a cylindrical test chamber fitted on its innersurface with rows of pins.The degree of fabric snag
12、ging is1This test method is under the jurisdiction ofASTM Committee D13 on Textilesand is the direct responsibility of Subcommittee D13.59 on Fabric Test Methods,General.Current edition approved July 1,2013.Published August 2013.Originallyapproved in 1993.Last previous edition approved in 2012 as D5
13、362 03(2012).DOI:10.1520/D5362-13.2Stuckey,W.C.,and El Shiekh,A.,“Snags in Snag Testing of Knits”,in Senseand Nonsense in Knit Testing,American Association of Textile Chemists andColorists,1975,pp.4553.3Cary,R.T.,“Bean Bag Snag Tester:A System of Evaluation,”Textile ResearchJournal,Vol 51,No.2,1981,
14、pp.6163.4For referenced ASTM standards,visist the ASTM Web Site,www.astm.org,orcontact ASTM Customer Service at serviceastm.org.For Annual Book of ASTMStandards volume information,refer to the standards Document Summary page onthe ASTM web site.5The last approved version of this historical standard
15、is referenced onwww.astm.org.6Available from American Association of Textile Chemists and Colorists(AATCC),P.O.Box 12215,Research Triangle Park,NC 27709,http:/www.aatcc.org.Copyright ASTM International,100 Barr Harbor Drive,PO Box C700,West Conshohocken,PA 19428-2959.United States1 evaluated by(1)co
16、mparison of the tested specimens withvisual rating standards that may be either snagged fabrics orphotographs of snagged fabrics,or(2)using a point system.The resistance to snagging is rated on a numerical scaleranging from 5(no or insignificant snagging)to 1(very severesnagging).5.Significance and Use5.1 Acceptance TestingThis test method may be used foracceptance testing of commercial shipments of fabrics becausethe precision is acceptable(see 15.1).5.1.1 If there are differences of practical