1、Designation:F221612An American National StandardStandard Specification forSelectorized Strength Equipment1This standard is issued under the fixed designation F2216;the number immediately following the designation indicates the year oforiginal adoption or,in the case of revision,the year of last revi
2、sion.A number in parentheses indicates the year of last reapproval.Asuperscript epsilon()indicates an editorial change since the last revision or reapproval.INTRODUCTIONThe goal of this specification is to promote proper design and manufacturing practices forselectorized strength training equipment.
3、Through these specifications,this specification aims to assistdesigners and manufactures in reducing the possibility of injury when these products are used inaccordance with the operational instructions.The equipment user must recognize,however,that a standard alone will not necessarily preventinjur
4、ies.Like other physical activities,exercise involving selectorized strength training equipmentinvolves the risk of injury,particularly if the equipment is used improperly or not properly maintained.In addition,users with physical limitations should seek medical advice and instruction from the fitnes
5、sfacility prior to using this equipment.Certain physical conditions or limitations may preclude somepersons from using this equipment properly and without increasing the risk of serious injury.1.Scope1.1 This specification establishes parameters for the designand manufacture of selectorized strength
6、 training equipment asdefined in 3.1.1.2 It is intended that these fitness products be used in anindoor setting or environment.1.3 It is the intent of this standard to specify fitness productsfor use only by individuals age 13 and older.1.4 This standard is to be used in conjunction with Speci-ficat
7、ion F2276,Test Methods F2571,and Test Method F2277.1.5 This standard takes precedence over SpecificationF2276 and Test Methods F2571 in areas that are specific orunique to selectorized strength training equipment.1.6 The values stated in SI units are to be regarded as thestandard.The values in paren
8、theses are for information only.1.7 This standard does not purport to address all of thesafety concerns,if any,associated with its use.It is theresponsibility of the user of this standard to establish appro-priate safety and health practices and determine the applica-bility of regulatory limitations
9、 prior to use.2.Referenced Documents2.1 ASTM Standards:2F1749 Specification for Fitness Equipment and Fitness Fa-cility Safety Signage and LabelsF2276 Specification for Fitness EquipmentF2277 Test Methods for Evaluating Design and PerformanceCharacteristics of Selectorized Strength EquipmentF2571 Te
10、st Methods for Evaluating Design and PerformanceCharacteristics of Fitness Equipment3.Terminology3.1 Definitions:3.1.1 assist means,nmechanism that the user engages onthe machine to assist them in getting into and out of the loadedstarting position.3.1.2 cam,nrotational component controlling the res
11、is-tance to the user.3.1.3 catch point,nlocation at which edges,protrusions,or surfaces allow a body part to become injured.3.1.4 consumerselectorizedstrengthequipment,nselectorized strength equipment intended for home use orfor use in a home environment.3.1.4.1 DiscussionSince significant differenc
12、es can arisebetween consumer and institutional selectorized strengthequipment,the products must be clearly identified as not forcommercial use.1This specification is under the jurisdiction of ASTM Committee F08 on SportsEquipment,Playing Surfaces,and Facilities and is the direct responsibility ofSub
13、committee F08.30 on Fitness Products.Current edition approved March 1,2012.Published March 2012.Originallyapproved in 2003.Last previous edition approved in 2005 as F2216 05.DOI:10.1520/F2216-12.2For referenced ASTM standards,visit the ASTM website,www.astm.org,orcontact ASTM Customer Service at ser
14、viceastm.org.For Annual Book of ASTMStandards volume information,refer to the standards Document Summary page onthe ASTM website.Copyright ASTM International,100 Barr Harbor Drive,PO Box C700,West Conshohocken,PA 19428-2959.United States1 3.1.5 field of view,nfield of view of the user defined by ana
15、rc of 150.Seventy-five degrees on each side of the medianplane.3.1.6 foot support,nmachine component(s)contacting theusers feet during operation,entry,and exit from the machine.3.1.7 institutional strength equipment,nstrength equip-ment intended for use by numerous persons in a commercial orinstitut
16、ional facility,as opposed to home environment.3.1.8 median plane,nplane of reference that divides themidline of the body of the user into equal right and left halves.3.1.9 rope,nfor the purpose of this specification,a cordcomprised of intertwisted synthetic or natural fibers or steelwires used for the transmittal of load from the resistance meansto the user means.3.1.10 selector pin,nthe component used to select resis-tance on weight based selectorized strength equipment.3.1.11 selectorized stre
