1、 INTERNATIONAL STANDARD IEC60371-3-4 1992AMENDMENT 12006-09 Amendment 1 Specification for insulating materials based on mica Part 3:Specifications for individual materials Sheet 4:Polyester film-backed mica paper with a B-stage epoxy resin binder PRICE CODE IEC 2006 Droits de reproduction rservs Cop
2、yright-all rights reserved International Electrotechnical Commission,3,rue de Varemb,PO Box 131,CH-1211 Geneva 20,SwitzerlandTelephone:+41 22 919 02 11 Telefax:+41 22 919 03 00 E-mail:inmailiec.ch Web:www.iec.ch E For price,see current catalogueCommission Electrotechnique InternationaleInternational
3、 Electrotechnical Commission LICENSED TO MECON Limited.-RANCHI/BANGALORE,FOR INTERNAL USE AT THIS LOCATION ONLY,SUPPLIED BY BOOK SUPPLY BUREAU.2 60371-3-4 Amend.1 IEC:2006(E)FOREWORD This amendment has been prepared by IEC technical committee 15:Standards on specifications for electrical insulating
4、materials.The text of this amendment is based on the following documents:FDIS Report on voting 15/332/FDIS 15/347/RVD Full information on the voting for the approval of this amendment can be found in the report on voting indicated in the above table.The committee has decided that the contents of thi
5、s amendment and the base publication will remain unchanged until the maintenance result date indicated on the IEC web site under http:/webstore.iec.ch in the data related to the specific publication.At this date,the publication will be reconfirmed,withdrawn,replaced by a revised edition,or amended._
6、 Page 7 INTRODUCTION Replace the existing text by the following new text:This International Standard is one of a series which deals with insulating materials for use in electrical equipment built up from mica splittings or mica paper,with or without reinforcement,and with mica paper in its pure stat
7、e.The series consists of the following three parts:Part 1:Definitions and general requirements(IEC 60371-1)Part 2:Methods of test(IEC 60371-2)Part 3:Specifications for individual materials(IEC 60371-3)This standard contains one of the sheets comprising part 3,as follows:Sheet 4:Polyester film-backed
8、 mica paper with a B-stage epoxy resin binder.LICENSED TO MECON Limited.-RANCHI/BANGALORE,FOR INTERNAL USE AT THIS LOCATION ONLY,SUPPLIED BY BOOK SUPPLY BUREAU.60371-3-4 Amend.1 IEC:2006(E)3 Page 9 1 Scope Insert the following two paragraphs after the existing paragraphs:Materials which conform to t
9、his specification meet established levels of performance.However,the selection of materials by a user for a specific application should be based on the actual requirements necessary for adequate performance in that application and not based on this specification alone.Safety warning:It is the respon
10、sibility of the user of the methods contained or referred to in this document to ensure that they are used in a safe manner.2 Normative references Replace the existing references by the following:IEC 60243-1:1998,Electric strength of insulating materials Test methods-Part 1:Tests at power frequencie
11、s IEC 60371-2:2004,Specification for insulating materials based on mica Part 2:Methods of test IEC 60371-3-2:2005,Insulating materials based on mica Part 3:Specifications for individual materials Sheet 2:Mica paper IEC 60674-3-2:1992,Specification for plastic films for electrical purposes Part 3:Spe
12、cifications for individual materials Sheet 2:Requirements for balanced biaxially oriented polyethylene terephthalate(PET)films used for electrical insulation 3 Designation Replace the existing first two paragraphs by the following new paragraphs:When ordering materials to this specification,only the
13、 specification and type numbers need be quoted(see Table 1).Example:IEC 60371-3-4:type 4.1.01 The type number is derived from:the specification sheet number 4 followed by the sheet table number 1 followed by the number of the product in the sheet table 01 Thus giving type number 4.1.01.The final par
14、agraph and table remain unchanged.LICENSED TO MECON Limited.-RANCHI/BANGALORE,FOR INTERNAL USE AT THIS LOCATION ONLY,SUPPLIED BY BOOK SUPPLY BUREAU.4 60371-3-4 Amend.1 IEC:2006(E)Page 11 4 Requirements:raw materials 4.1 Mica paper Replace the existing text of this subclause by the following new text
15、:Mica paper referred to in this specification shall comply with the requirements of IEC 60371-3-2.4.2 Polyester film Replace the existing text of this subclause by the following new text:Plastic films used as backing material shall be PET and shall comply with the requirements of IEC 60674-3-2.Page
16、13 5 Requirements:compositions and tolerances Replace the existing text of this clause by the following new text:When tested by the method of Clause 7 of IEC 60371-2,the composition of the products shall lie within the limits of Table 1.Page 15 6.3 Thickness Replace the first sentence by the following new sentence:Measure the thickness in accordance with Clause 4 of IEC 60371-2,using the apparatus given in 4.1.1 of that standard,making 10 measurements of one thickness of material.6.7 Stiffness R