1、 Reference numberISO/IEC 13560:2009(E)ISO/IEC 2009 INTERNATIONAL STANDARD ISO/IEC13560First edition2009-12-01 Information technology Telecommunications and information exchange between systems Procedure for the registration of assigned numbers for ISO/IEC 26907 and ISO/IEC 26908 Technologies de linf
2、ormation Procdure denregistrement des numros dordre pour lISO/CEI 26907 et lISO/CEI 26908 ISO/IEC 13560:2009(E)PDF disclaimer This PDF file may contain embedded typefaces.In accordance with Adobes licensing policy,this file may be printed or viewed but shall not be edited unless the typefaces which
3、are embedded are licensed to and installed on the computer performing the editing.In downloading this file,parties accept therein the responsibility of not infringing Adobes licensing policy.The ISO Central Secretariat accepts no liability in this area.Adobe is a trademark of Adobe Systems Incorpora
4、ted.Details of the software products used to create this PDF file can be found in the General Info relative to the file;the PDF-creation parameters were optimized for printing.Every care has been taken to ensure that the file is suitable for use by ISO member bodies.In the unlikely event that a prob
5、lem relating to it is found,please inform the Central Secretariat at the address given below.COPYRIGHT PROTECTED DOCUMENT ISO/IEC 2009 All rights reserved.Unless otherwise specified,no part of this publication may be reproduced or utilized in any form or by any means,electronic or mechanical,includi
6、ng photocopying and microfilm,without permission in writing from either ISO at the address below or ISOs member body in the country of the requester.ISO copyright office Case postale 56 CH-1211 Geneva 20 Tel.+41 22 749 01 11 Fax +41 22 749 09 47 E-mail copyrightiso.org Web www.iso.org Published in S
7、witzerland ii ISO/IEC 2009 All rights reserved ISO/IEC 13560:2009(E)ISO/IEC 2009 All rights reserved iii Contents Page Foreword.iv Introduction.v 1 Scope.1 2 Normative references.1 3 Terms and definitions.1 4 International Registers.2 4.1 PHY ID.2 4.2 Specifier ID.2 4.3 Regulatory Domain.2 5 Registr
8、ation Authority.2 5.1 Appointment.2 5.2 Duties.2 5.2.1 Maintenance of International Registers.2 5.2.2 Publication of public content of International Registers.2 5.2.3 Inform the requestor of the decision.2 6 Registration requests.3 7 Registration procedure.3 8 Withdrawal procedure.3 9 Amendment proc
9、edure.3 10 Appeal procedure.3 ISO/IEC 13560:2009(E)iv ISO/IEC 2009 All rights reserved Foreword ISO(the International Organization for Standardization)and IEC(the International Electrotechnical Commission)form the specialized system for worldwide standardization.National bodies that are members of I
10、SO or IEC participate in the development of International Standards through technical committees established by the respective organization to deal with particular fields of technical activity.ISO and IEC technical committees collaborate in fields of mutual interest.Other international organizations
11、,governmental and non-governmental,in liaison with ISO and IEC,also take part in the work.In the field of information technology,ISO and IEC have established a joint technical committee,ISO/IEC JTC 1.International Standards are drafted in accordance with the rules given in the ISO/IEC Directives,Par
12、t 2.The main task of the joint technical committee is to prepare International Standards.Draft International Standards adopted by the joint technical committee are circulated to national bodies for voting.Publication as an International Standard requires approval by at least 75%of the national bodie
13、s casting a vote.Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights.ISO and IEC shall not be held responsible for identifying any or all such patent rights.ISO/IEC 13560 was prepared by Ecma International(as ECMA-381)and was adopted,u
14、nder a special“fast-track procedure”,by Joint Technical Committee ISO/IEC JTC 1,Information technology,in parallel with its approval by national bodies of ISO and IEC.ISO/IEC 13560:2009(E)ISO/IEC 2009 All rights reserved v Introduction This International Standard specifies the registration procedure
15、s for the PHY ID,Specifier ID and Regulatory Domain registers used in ISO/IEC 26907 and ISO/IEC 26908.Entries in these registers are likely to be added over time.Therefore,these contents are implemented as registers rather than as tables in the base standards.INTERNATIONAL STANDARD ISO/IEC 13560:200
16、9(E)ISO/IEC 2009 All rights reserved 1 Information technology Telecommunications and information exchange between systems Procedure for the registration of assigned numbers for ISO/IEC 26907 and ISO/IEC 26908 1 Scope This International Standard specifies the procedure to be followed by a Registration Authority in preparing,maintaining and publishing International Registers of assigned numbers and associated descriptions for entries specified in Clause 4,for use with ISO/IEC 26907 and ISO/IEC 269
