1、Designation:D550514Standard Practice forClassifying Emulsified Recycling Agents1This standard is issued under the fixed designation D5505;the number immediately following the designation indicates the year oforiginal adoption or,in the case of revision,the year of last revision.A number in parenthes
2、es indicates the year of last reapproval.Asuperscript epsilon()indicates an editorial change since the last revision or reapproval.1.Scope1.1 This practice identifies emulsified petroleum productsthat may be used as recycling agents in recycled mixes.Thesematerials are classified by viscosity or by
3、low temperaturepenetration after aging.1.2 This practice addresses emulsified materials designedspecifically for use in recycling.The use of emulsified mate-rials for recycling shall not be limited to this practice.Forinstance,the emulsified asphalts specified in SpecificationsD977 and D2397 may be
4、used.1.3 The values stated in SI units are to be regarded asstandard.No other units of measurement are included in thisstandard.1.4 This standard does not purport to address all of thesafety concerns,if any,associated with its use.It is theresponsibility of the user of this standard to consult andes
5、tablish appropriate safety and health practices and deter-mine the applicability of regulatory limitations prior to use.2.Referenced Documents2.1 ASTM Standards:2D5 Test Method for Penetration of Bituminous MaterialsD140 Practice for Sampling Bituminous MaterialsD977 Specification for Emulsified Asp
6、haltD1754 Test Method for Effects of Heat and Air on AsphalticMaterials(Thin-Film Oven Test)D2042 Test Method for Solubility of Asphalt Materials inTrichloroethyleneD2170 Test Method for Kinematic Viscosity of Asphalts(Bitumens)D2397 Specification for Cationic Emulsified AsphaltD2872 Test Method for
7、 Effect of Heat and Air on a MovingFilm of Asphalt(Rolling Thin-Film Oven Test)D4124 Test Method for Separation of Asphalt into FourFractionsD6930 Test Method for Settlement and Storage Stability ofEmulsified AsphaltsD6933 Test Method for Oversized Particles in EmulsifiedAsphalts(Sieve Test)D6937 Te
8、st Method for Determining Density of EmulsifiedAsphaltD6997 Test Method for Distillation of Emulsified AsphaltD7402 Practice for Identifying Cationic Emulsified AsphaltsD7496 Test Method for Viscosity of Emulsified Asphalt bySaybolt Furol ViscometerD7553 Test Method for Solubility of Asphalt Materia
9、ls inN-Propyl Bromide3.Significance and Use3.1 Recycling of deteriorated asphalt pavements is beingused as a routine method of maintenance and rehabilitation.Utilization of existing materials as the major component of thisprocedure may yield benefits in quality,economy,and preser-vation of natural r
10、esources.Recycling takes many forms;hot,cold,in-situ,central plant and surface.This practice may beused for various recycling methods.3.2 This practice describes emulsified recycling(ER)agentsas belonging to three groups;ER-1,ER-2,and ER-3 as shownin Table 1.The range of recycling methods demands se
11、veralemulsified recycling agents.The groups should provide ad-equate freedom of selection for most recycling methods.3.2.1 ER-1 is a material whose main function is to rejuve-nate aged asphalt.The material is a petroleum derivative,andhighly compatible with asphalts.It is classified by viscosity.3.2
12、.2 ER-2 and ER-3 are materials that combine rejuvena-tors and asphalt components in one emulsified asphalt.Thesesoft residues are classified by low temperature penetration afteraging.They are typically used in recycling where there is anincreased demand for asphalt as when new aggregates areadded,or
13、 where immediate cohesiveness is desired.3.3 The choice of ER will be determined by the propertiesof the asphalt binder in the aged pavement,the methods ofrecycling planned,the amount,if any,of new aggregates,andother design needs.1This practice is under the jurisdiction of ASTM Committee D04 on Roa
14、d andPaving Materials and is the direct responsibility of Subcommittee D04.41 onEmulsified Asphalt Specifications.Current edition approved June 1,2014.Published July 2014.Originally approvedin 1994.Last previous edition approved in 2006 as D5505 06.DOI:10.1520/D5505-14.2For referenced ASTM standards
15、,visit the ASTM website,www.astm.org,orcontact ASTM Customer Service at serviceastm.org.For Annual Book of ASTMStandards volume information,refer to the standards Document Summary page onthe ASTM website.Copyright ASTM International,100 Barr Harbor Drive,PO Box C700,West Conshohocken,PA 19428-2959.U
16、nited States1 4.Properties4.1 All emulsified recycling agents shall be homogenous,free flowing at pumping temperature,and shall conform to therequirements of Table 1.4.2 Emulsified recycling agent residue should be combinedwith aged asphalts and evaluated to determine proper ERselection and to determine quantity of treatment.Resultingasphalt binder properties shall be judged suitable for theintended use.5.Sampling5.1 Carry out sampling in accordance with Practice D140.5.2 Store samples in new,cl
