1、Designation:D369595(Reapproved 2021)1Standard Test Method forVolatile Alcohols in Water by Direct Aqueous-Injection GasChromatography1This standard is issued under the fixed designation D3695;the number immediately following the designation indicates the year oforiginal adoption or,in the case of re
2、vision,the year of last revision.A number in parentheses indicates the year of last reapproval.Asuperscript epsilon()indicates an editorial change since the last revision or reapproval.1NOTEThe WTO caveat was editorially added in November 2021.1.Scope1.1 This test method covers a wide range of alcoh
3、ols withvarious structures and boiling points that can be separated anddetected quantitatively in water and waste water at a minimumdetection limit of approximately 1 mg/L by aqueous-injectiongas-liquid chromatography.2This test method can also be usedto detect other volatile organic compounds quali
4、tatively.Or-ganic acids,amines,and high boiling,highly polar compoundsare not readily detectable under this set of conditions.Foranalysis of organics with similar functionalities,refer to othertest methods in Volumes 11.01 and 11.02 of the Annual Bookof ASTM Standards.1.2 This test method utilizes t
5、he procedures and precautionsas described in Practice D2908.Utilize the procedures andprecautions as described therein.1.3 This test method has been used successfully withreagent grade Type II and natural chlorinated tap waters.It isthe users responsibility to assure the validity of this testmethod
6、for any untested matrices.1.4 The values stated in SI units are to be regarded asstandard.No other units of measurement are included in thisstandard.1.5 This standard does not purport to address all of thesafety concerns,if any,associated with its use.It is theresponsibility of the user of this stan
7、dard to establish appro-priate safety,health,and environmental practices and deter-mine the applicability of regulatory limitations prior to use.1.6 This international standard was developed in accor-dance with internationally recognized principles on standard-ization established in the Decision on
8、Principles for theDevelopment of International Standards,Guides and Recom-mendations issued by the World Trade Organization TechnicalBarriers to Trade(TBT)Committee.2.Referenced Documents2.1 ASTM Standards:3D1129 Terminology Relating to WaterD1193 Specification for Reagent WaterD2908 Practice for Me
9、asuring Volatile Organic Matter inWater by Aqueous-Injection Gas ChromatographyD3856 Guide for Management Systems in LaboratoriesEngaged in Analysis of WaterD4210 Practice for Intralaboratory Quality Control Proce-dures and a Discussion on Reporting Low-Level Data(Withdrawn 2002)4E355 Practice for G
10、as Chromatography Terms and Relation-ships3.Terminology3.1 DefinitionsFor definitions of terms used in this testmethod,refer to Terminology D1129 and Practice E355.4.Summary of Test Method4.1 An aliquot of an aqueous sample is directly injected intoa gas chromatograph by means of a microlitre syring
11、e.Theorganic compounds in the sample are separated and elutedfrom a chromatographic column into a flame ionization detec-tor.The compounds are identified by relative retention time orKovats Index,and measured by direct comparison with corre-sponding standard responses.5.Significance and Use5.1 The m
12、ajor organic constituents in industrial waste waterneed to be identified for support of effective in-plant or1This test method is under the jurisdiction of ASTM Committee D19 on Waterand is the direct responsibility of Subcommittee D19.06 on Methods forAnalysis forOrganic Substances in Water.Current
13、 edition approved Nov.1,2021.Published December 2021.Originallyapproved in 1978.Last previous edition approved in 2013 as D3695 95(2013).DOI:10.1520/D3695-95R21E01.2Sugar,J.W.,and Conway,R.A.,“Gas-Liquid Chromatographic Techniques forPetrochemical Waste Water Analysis,”Journal of the Water Pollution
14、 ControlFederation,Vol 40,1968,pp.16221631.3For referenced ASTM standards,visit the ASTM website,www.astm.org,orcontact ASTM Customer Service at serviceastm.org.For Annual Book of ASTMStandards volume information,refer to the standards Document Summary page onthe ASTM website.4The last approved vers
15、ion of this historical standard is referenced onwww.astm.org.Copyright ASTM International,100 Barr Harbor Drive,PO Box C700,West Conshohocken,PA 19428-2959.United StatesThis international standard was developed in accordance with internationally recognized principles on standardization established i
16、n the Decision on Principles for theDevelopment of International Standards,Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade(TBT)Committee.1?pollution control programs.Currently,the most practical meansfor tentatively identifying and measuring a range of volatileorganic compounds is gas-liquid chromatography.6.Interferences6.1 Since the specified column and conditions are applicableto numerous organics,the possibility of one or more compo-nents having
