1、 Reference numberISO/IEC 16353:2011(E)ISO/IEC 2011 INTERNATIONAL STANDARD ISO/IEC16353First edition2011-10-01Information technology Telecommunications and information exchange between systems Front-end configuration command for NFC-WI(NFC-FEC)Technologies de linformation Tlcommunications et change d
2、informations entre systmes Commande configuration frontale pour NFC-WI(NFC-FEC)ISO/IEC 16353:2011(E)COPYRIGHT PROTECTED DOCUMENT ISO/IEC 2011 All rights reserved.Unless otherwise specified,no part of this publication may be reproduced or utilized in any form or by any means,electronic or mechanical,
3、including photocopying and microfilm,without permission in writing from either ISO at the address below or ISOs member body in the country of the requester.ISO copyright office Case postale 56 CH-1211 Geneva 20 Tel.+41 22 749 01 11 Fax +41 22 749 09 47 E-mail copyrightiso.org Web www.iso.org Publish
4、ed in Switzerland ii ISO/IEC 2011 All rights reserved ISO/IEC 16353:2011(E)ISO/IEC 2011 All rights reserved iii Contents Page Foreword.iv Introduction.v 1 Scope.1 2 Conformance.1 3 Normative references.1 4 Terms and definitions.1 5 Conventions and notations.1 6 Acronyms.1 7 States.1 7.1 Escape state
5、.2 7.2 Command Ready state.2 7.3 Command Busy state.2 7.4 Quit state.2 8 Commands and Responses.3 8.1 Command and response Format.3 8.2 Checksum.3 8.3 Commands.3 8.4 Responses.4 9 Information-Transfer.4 9.1 Transceiver Frames.4 9.2 Front-end Frames.4 ISO/IEC 16353:2011(E)iv ISO/IEC 2011 All rights r
6、eserved Foreword ISO(the International Organization for Standardization)and IEC(the International Electrotechnical Commission)form the specialized system for worldwide standardization.National bodies that are members of ISO or IEC participate in the development of International Standards through tec
7、hnical committees established by the respective organization to deal with particular fields of technical activity.ISO and IEC technical committees collaborate in fields of mutual interest.Other international organizations,governmental and non-governmental,in liaison with ISO and IEC,also take part i
8、n the work.In the field of information technology,ISO and IEC have established a joint technical committee,ISO/IEC JTC 1.International Standards are drafted in accordance with the rules given in the ISO/IEC Directives,Part 2.The main task of the joint technical committee is to prepare International
9、Standards.Draft International Standards adopted by the joint technical committee are circulated to national bodies for voting.Publication as an International Standard requires approval by at least 75%of the national bodies casting a vote.Attention is drawn to the possibility that some of the element
10、s of this document may be the subject of patent rights.ISO and IEC shall not be held responsible for identifying any or all such patent rights.ISO/IEC 16353 was prepared by Ecma International(as ECMA-390)and was adopted,under a special“fast-track procedure”,by Joint Technical Committee ISO/IEC JTC 1
11、,Information technology,in parallel with its approval by national bodies of ISO and IEC.ISO/IEC 16353:2011(E)ISO/IEC 2011 All rights reserved v Introduction ISO/IEC 28361 specifies a two-wire interface for which this International Standard defines commands,responses and their transmission,allowing t
12、he exchange of control and state information between the transceiver and the front-end as specified in ISO/IEC 28361.Such exchange may include indication of the presence of the RF field and control information to change data rates and communication modes of the front-end.INTERNATIONAL STANDARD ISO/I
13、EC 16353:2011(E)ISO/IEC 2011 All rights reserved 1 Information technology Telecommunications and information exchange between systems Front-end configuration command for NFC-WI(NFC-FEC)1 Scope This International Standard specifies commands for the Near Field Communication Wired Interface(NFC-WI)spec
14、ified in ISO/IEC 28361.The commands allow exchange of control and state information between the transceiver and the front-end.2 Conformance To conform to this International Standard,an NFC-FEC device shall conform to all mandatory parts specified herein and all mandatory parts of ISO/IEC 28361(NFC-W
15、I).3 Normative references The following referenced documents are indispensable for the application of this document.For dated references,only the edition cited applies.For undated references,the latest edition of the referenced document(including any amendments)applies.ISO/IEC 28361:2007,Information
16、 technology Telecommunications and information exchange between systems Near Field Communication Wired Interface(NFC-WI)4 Terms and definitions For the purposes of this document,the terms and definitions given in ISO/IEC 28361 apply.5 Conventions and notations For the purposes of this document the conventions and notations given in ISO/IEC 28361 apply.6 Acronyms For the purposes of this document the acronyms given in ISO/IEC 28361 apply.7 States NFC-FEC extends the compound NFC-WI Command state
