1、关于英文版化学实验报告篇一：英文版化学实验报告Title: Preparation of Fe scrap from waste(NH4) 2SO4.FeSO4.6H2OThe purpose of the experimentLearn the method used scrap iron preparation of ferrous ammonium sulfate.Familiar with the water bath, filtered, and evaporated under reduced pressure and crystallization basic working.T
2、he experimental principle, the iron and sulfuric acid to generate reactive ferrous sulfate, ferrous sulfate and ammonium sulfate in an aqueous solution of equal molar interaction, becomes less soluble blue generate ferrous ammonium sulfate.Fe+H2SO4=FeSO4+H2 (gas)FeSO4+ (NH4)2SO4+6H2O=(NH4)2SO4.FeSO4
3、.6H2O Usually ferrous rocks are easily oxidized in air, but after the formation of relatively stable perfunctory, not to be oxidized.Experiment to use instruments, scales, constant temperature water bath, pumps, basins, cups, 10ml graduated cylinder, asbestos mesh, glass, tripod, alcohol lamp, funne
4、l.Iron pieces to a solid pharmaceutical use, use of acid ammonium sulfate and 3mol / l of sulfuric acid, concentrated sulfuric acid.The experiment was divided into four steps.The first step Said iron powder 4g into a beaker and then 50ml 10ml, 3mol / L H2SO4 was added to the same beaker. The second
5、step will be the beaker is heated to no more bubbles, and then filtered hot and the filtrate was then filled in 100ml beaker. The third step, called 4g (NH4)2SO4, and the resultingammonium sulfate and 5.3ml of water to form a saturated solution, and then add it to the ferrous sulfate solution, adjus
6、ted with concentrated sulfuric acid to PH = 1. A fourth step, the third step the solution was heated in a water bath to the surface until the film is crystallized, it was slowly cooled andthen filtered under reduced pressure to stand finally dried, weighed and the yield was calculated. The results o
7、btained 8.1g bluish powderycrystals. Have this result we can calculate yield, starting with the first step we tried to know the amount of iron, should this we can calculate the theoretical sulfate ferrous sulfate is 0.03mol, then ferrous sulfate obtained by the0.03molFeSO4 theoretical value of ammon
8、ium. FeSO4+NH42SO4+6H2O=FeSO4.(NH4)2SO4.6H2O 0.03molX molX=0.03molm=XM=0.03mol392g/mol=11.76gYield = the actual value of the formula is divided by the theoretical value by 100%.it will be calculated into the data obtained in a yield of 68.9%.篇二：英文版化学实验报告The preparation of alkali type copper carbonat
9、eThe first:the experiment purpose1.Master the methods of alkali type copper carbonate prepared and principle2.Through the design experiment to cultivate independent design ability and chemical research thinkingThe second:the experimental principleThe solubility of Cu(OH)2and CuCO3 are similar, With
10、Cu2(OH)2CO3 solid precipitation in the solution.2CuSO4+2Na2CO3+H2O=Cu2(OH)2CO3+2Na2SO4+CO2The third:the experimental steps1.Solution preparationDisposes 0.5 mole of each litre acid sour coppers and sodium carbonate solution each 100 milliliters.2.The feeding order and raw material compare the explor
11、ationAccording to 2:1.6,2:2,2:2.4,2:2.8 allocated proportion, is accepted after passing an examination the surface disposition acid sour copper and the sodium carbonate solution, joins in separately 8 test tubes, joins rapidly the sulfuric acid copper solutions in the sodium carbonate solution, vibr
12、ates about other constant temperature ten minutes as for 75 degrees Celsius water baths in, the inversion feeding order recreates one time, the observation has the precipitation speed, quantity how many and the color,discovers the optimum condition.3.Temperature explorationAccording to the above opt
13、imum condition, takes the acid sour copper solutions and the sodium carbonate solution separately under 50, 75 and 100 degrees Celsius responded that, discovers the optimum temperature.4.According to 2, 3 step exploration optimum condition prepares the final product, and with the distilled water lav
14、ation, finally dries and calls heavily.(Enlarges ten times with conical flask to do)The fourth:the experimental itemsInstrument and material: The balance, the beaker, the glass rod, the Volumetric flask, the test tube, the filter flask,the Buchner funnel, the Erlenmeyer flaskChemicals: Copper carbon
15、ate, sodium sulfateThe fifth:the experimental result1.By the step 2, the observation phenomenon optimum condition is equal to for the cupric sulfate compared to the sodium carbonate 2:2.4, the feeding order for joins the sulfuric acid copper solutions to the sodium carbonate solution in.2.By the ste
16、p 3, the observation phenomenon optimum temperature is 75 degrees Celsius3.According to the copper sulfate solution than sodium carbonatesolution is 2:2. 4, ten times magnification, alkali type copper carbonate was zero point five grams, according to the reaction equation calculation yield.2CuSO4+2Na2CO3+H2O=Cu2(OH)2CO3+2Na2SO4+CO22 10.5x0.02 X
