1、Post-Combustion NOx Control for Fired Equipment in General Refinery ServicesAPI RECOMMENDED PRACTICE 536SECOND EDITION,DECEMBER 2006REAFFIRMED,SEPTEMBER 2013Copyright American Petroleum Institute Provided by IHS under license with API Not for ResaleNo reproduction or networking permitted without lic
2、ense from IHS-,-,-Copyright American Petroleum Institute Provided by IHS under license with API Not for ResaleNo reproduction or networking permitted without license from IHS-,-,-Post-Combustion NOx Control for Fired Equipment in General Refinery ServicesDownstream SegmentAPI RECOMMENDED PRACTICE 53
3、6SECOND EDITION,DECEMBER 2006REAFFIRMED,SEPTEMBER 2013Copyright American Petroleum Institute Provided by IHS under license with API Not for ResaleNo reproduction or networking permitted without license from IHS-,-,-SPECIAL NOTESAPI publications necessarily address problems of a general nature.With r
4、espect to particular circumstances,local,state,and federal laws and regulations should be reviewed.Neither API nor any of APIs employees,subcontractors,consultants,committees,or other assignees make any warranty or representation,either express or implied,with respect to the accuracy,completeness,or
5、 usefulness of the information contained herein,or assume any liability or responsibility for any use,or the results of such use,of any information or process disclosed in this publication.Neither API nor any of APIs employees,subcontractors,con-sultants,or other assignees represent that use of this
6、 publication would not infringe upon pri-vately owned rights.API publications may be used by anyone desiring to do so.Every effort has been made by the Institute to assure the accuracy and reliability of the data contained in them;however,the Institute makes no representation,warranty,or guarantee i
7、n connection with this publication and hereby expressly disclaims any liability or responsibility for loss or damage resulting from its use or for the violation of any authorities having jurisdiction with which this publi-cation may conflict.API publications are published to facilitate the broad ava
8、ilability of proven,sound engineer-ing and operating practices.These publications are not intended to obviate the need for applying sound engineering judgment regarding when and where these publications should be utilized.The formulation and publication of API publications is not intended in any way
9、 to inhibit anyone from using any other practices.Any manufacturer marking equipment or materials in conformance with the marking requirements of an API standard is solely responsible for complying with all the applicable requirements of that standard.API does not represent,warrant,or guarantee that
10、 such prod-ucts do in fact conform to the applicable API standard.All rights reserved.No part of this work may be reproduced,stored in a retrieval system,or transmitted by any means,electronic,mechanical,photocopying,recording,or otherwise,without prior written permission from the publisher.Contact
11、the Publisher,API Publishing Services,1220 L Street,N.W.,Washington,D.C.20005.Copyright 2006 American Petroleum InstituteCopyright American Petroleum Institute Provided by IHS under license with API Not for ResaleNo reproduction or networking permitted without license from IHS-,-,-FOREWORDNothing co
12、ntained in any API publication is to be construed as granting any right,by impli-cation or otherwise,for the manufacture,sale,or use of any method,apparatus,or product covered by letters patent.Neither should anything contained in the publication be construed as insuring anyone against liability for
13、 infringement of letters patent.The following definitions apply:Shall:As used in a standard,“shall”denotes a minimum requirement in order to conform to the specification.Should:As used in a standard,“should”denotes a recommedation or that which is advised but not required in order to conform to the
14、specification.This document was produced under API standardization procedures that ensure appropriate notification and participation in the developmental process and is designated as an API stan-dard.Questions concerning the interpretation of the content of this publication or comments and questions
15、 concerning the procedures under which this publication was developed should be directed in writing to the Director of Standards,American Petroleum Institute,1220 L Street,N.W.,Washington,D.C.20005.Requests for permission to reproduce or translate all or any part of the material published herein sho
16、uld also be addressed to the director.Generally,API standards are reviewed and revised,reaffirmed,or withdrawn at least every five years.A one-time extension of up to two years may be added to this review cycle.Status of the publication can be ascertained from the API Standards Department,telephone(202)682-8000.A catalog of API publications and materials is published annually and updated quarterly by API,1220 L Street,N.W.,Washington,D.C.20005.Suggested revisions are invited and should be submit