1、Designation:D752420IP 568/08Standard Test Method forDetermination of Static Dissipater Additives(SDA)inAviation Turbine Fuel and Middle Distillate FuelsHighPerformance Liquid Chromatograph(HPLC)Method1This standard is issued under the fixed designation D7524;the number immediately following the desi
2、gnation indicates the year oforiginal adoption or,in the case of revision,the year of last revision.A number in parentheses indicates the year of last reapproval.Asuperscript epsilon()indicates an editorial change since the last revision or reapproval.1.Scope*1.1 This test method covers the determin
3、ation of staticdissipater additive(SDA)content of aviation turbine fuel andmiddle distillate fuels.1.2 The precision of this test method has been establishedfor aviation turbine fuel over the concentration range of1 mg L to 12 mgL.Higher concentrations can be determinedby dilution,but the precision
4、of the test method will not apply.NOTE1The SDA used to develop this test method was STADIS 4502for aviation fuels and STADIS 450 and 4252for middle distillates.1.3 The test method includes a procedure to concentrate thesulfonic acid component in the SDA prior to analysis.1.4 The test method only app
5、lies to SDAs that contain alkylsubstituted sulfonic acid.1.5 The values stated in SI units are to be regarded asstandard.No other units of measurement are included in thisstandard.1.6 This standard does not purport to address all of thesafety concerns,if any,associated with its use.It is theresponsi
6、bility of the user of this standard to establish appro-priate safety,health,and environmental practices and deter-mine the applicability of regulatory limitations prior to use.1.7 This international standard was developed in accor-dance with internationally recognized principles on standard-ization
7、established in the Decision on Principles for theDevelopment of International Standards,Guides and Recom-mendations issued by the World Trade Organization TechnicalBarriers to Trade(TBT)Committee.2.Referenced Documents2.1 ASTM Standards:3D4057 Practice for Manual Sampling of Petroleum andPetroleum P
8、roductsD4177 Practice for Automatic Sampling of Petroleum andPetroleum Products2.2 ISO Standards:4EN ISO 3696 Water for Analytical Laboratory UseSpecifications and Test Methods2.3 Energy Institute Standards:5IP 568/08 Determination of the Static Dissipater Additives(SDA)in Aviation Turbine Fuel and
9、Middle DistillateFuelsHPLC Method3.Terminology3.1 Definitions:3.1.1 middle distillate fuels,ngeneric refinery/supplierterm that usually denotes a fuel primarily intended for use incompression ignition/diesel engine applications,and also innon-aviation gas turbine engines and other non-automotiveappl
10、ications such as a burner fuel.3.2 Definitions of Terms Specific to This Standard:3.2.1 aviation turbine fuel,nfuel used for powering jetand turbo-prop engine aircraft.3.2.2 conductivity improver additive,nmaterial added to afuel in very small amounts to increase its electrical conductiv-ity and the
11、reby reduce relaxation time.3.2.2.1 DiscussionConductivity improver additives arealso known as static dissipater additives(SDAs)or antistaticadditives.1This test method is under the jurisdiction of ASTM Committee D02 onPetroleum Products,Liquid Fuels,and Lubricants and is the direct responsibility o
12、fSubcommittee D02.04.0C on Liquid Chromatography.Current edition approved Oct.1,2020.Published December 2020.Originallyapproved in 2010.Last previous edition approved in 2015 as D7524 10(2015).DOI:10.1520/D7524-20.2Stadis 450 and 425 are registered trademarks marketed by Innospec,Inc.,Innospec Manuf
13、acturing Park,Oil Sites Road,Ellesmere Port,Cheshire Ch65 4EY,UK.3For referenced ASTM standards,visit the ASTM website,www.astm.org,orcontact ASTM Customer Service at serviceastm.org.For Annual Book of ASTMStandards volume information,refer to the standards Document Summary page onthe ASTM website.4
14、Available from International Organization for Standardization(ISO),1,ch.dela Voie-Creuse,Case postale 56,CH-1211,Geneva 20,Switzerland,http:/www.iso.ch.5Available from Energy Institute,61 New Cavendish St.,London,WIG 7AR,U.K.,http:/www.energyinst.org.uk.*A Summary of Changes section appears at the e
15、nd of this standardCopyright ASTM International,100 Barr Harbor Drive,PO Box C700,West Conshohocken,PA 19428-2959.United StatesThis international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for theDevelo
16、pment of International Standards,Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade(TBT)Committee.14.Summary of Test Method4.1 A solid phase extraction procedure is used to concen-trate the sulfonic acid component of SDApresent in an aviationturbine fuel or middle distillate fuel sample prior to analysis.Afixed volume of the concentrated test fraction is injected into acalibrated high performance liquid chromatograph.An analyti-cal column is used to sep