1、Designation:D32315aStandard Test Method forVapor Pressure of Petroleum Products(Reid Method)1This standard is issued under the fixed designation D323;the number immediately following the designation indicates the year oforiginal adoption or,in the case of revision,the year of last revision.A number
2、in parentheses indicates the year of last reapproval.Asuperscript epsilon()indicates an editorial change since the last revision or reapproval.This standard has been approved for use by agencies of the U.S.Department of Defense.1.Scope*1.1 This test method covers procedures for the determina-tion of
3、 vapor pressure(see Note 1)of gasoline,volatile crudeoil,and other volatile petroleum products.1.2 Procedure A is applicable to gasoline and other petro-leum products with a vapor pressure of less than 180 kPa(26 psi).1.3 Procedure B may also be applicable to these othermaterials,but only gasoline w
4、as included in the interlaboratorytest program to determine the precision of this test method.1.4 Procedure C is for materials with a vapor pressure ofgreater than 180 kPa(26 psi).1.5 Procedure D for aviation gasoline with a vapor pressureof approximately 50 kPa(7 psi).NOTE1Because the external atmo
5、spheric pressure is counteracted bythe atmospheric pressure initially present in the vapor chamber,the Reidvapor pressure is an absolute pressure at 37.8 C(100 F)in kilopascals(pounds-force per square inch).The Reid vapor pressure differs from thetrue vapor pressure of the sample due to some small s
6、ample vaporizationand the presence of water vapor and air in the confined space.1.6 This test method is not applicable to liquefied petroleumgases or fuels containing oxygenated compounds other thanmethyl t-butyl ether(MTBE).For determination of the vaporpressure of liquefied petroleum gases,refer t
7、o Test MethodD1267 or Test Method D6897.For determination of the vaporpressure of gasoline-oxygenate blends,refer to Test MethodD4953.The precision for crude oil has not been determinedsince the early 1950s(see Note 3).Test Method D6377 hasbeen approved as a method for determination of vapor pressur
8、eof crude oil.IP 481 is a test method for determination of theair-saturated vapor pressure of crude oil.1.7 The values stated in SI units are to be regarded as thestandard.The values given in parentheses are for informationonly.1.8This standard does not purport to address all of thesafety concerns,i
9、f any,associated with its use.It is theresponsibility of the user of this standard to establish appro-priate safety and health practices and determine the applica-bility of regulatory limitations prior to use.Specific warningstatements are given in Sections 7 and 18,and 12.5.3,15.5,21.2,A1.1.2,A1.1.
10、6,and A2.3.2.Referenced Documents2.1 ASTM Standards:2D1267 Test Method for Gage Vapor Pressure of LiquefiedPetroleum(LP)Gases(LP-Gas Method)D4057 Practice for Manual Sampling of Petroleum andPetroleum ProductsD4175 Terminology Relating to Petroleum,PetroleumProducts,and LubricantsD4953 Test Method f
11、or Vapor Pressure of Gasoline andGasoline-Oxygenate Blends(Dry Method)D6377 Test Method for Determination of Vapor Pressure ofCrude Oil:VPCRx(Expansion Method)D6897 Test Method for Vapor Pressure of Liquefied Petro-leum Gases(LPG)(Expansion Method)E1 Specification for ASTM Liquid-in-Glass Thermomete
12、rsE2251 Specification for Liquid-in-Glass ASTM Thermom-eters with Low-Hazard Precision Liquids2.2 Energy Institute Standards:IP 481 Test Method for Determination of the Air SaturatedVapour Pressure(ASVP)of Crude Oil33.Terminology3.1 Definitions:3.1.1 Bourdon spring gauge,npressure measuring deviceth
13、at employs a Bourdon tube connected to an indicator.3.1.2 Bourdon tube,nflattened metal tube bent to a curvethat straightens under internal pressure.1This test method is under the jurisdiction of ASTM Committee D02 onPetroleum Products,Liquid Fuels,and Lubricants and is the direct responsibility ofS
14、ubcommittee D02.08 on Volatility.Current edition approved June 1,2015.Published June 2015.Originallyapproved in 1930.Last previous edition approved in 2015 as D323 15.DOI:10.1520/D0323-15A.2For referenced ASTM standards,visit the ASTM website,www.astm.org,orcontact ASTM Customer Service at serviceas
15、tm.org.For Annual Book of ASTMStandards volume information,refer to the standards Document Summary page onthe ASTM website.3Available from Energy Institute,61 New Cavendish St.,London,WIG 7AR,U.K.,http:/www.energyinst.org.uk.*A Summary of Changes section appears at the end of this standardCopyright
16、ASTM International,100 Barr Harbor Drive,PO Box C700,West Conshohocken,PA 19428-2959.United States1 3.1.3 oxygenate,noxygen-containing ashless organiccompound,such as an alcohol or ether,which may be used asa fuel or fuel supplement.D41753.1.4 Reid vapor pressure(RVP),nresultant total pressurereading,corrected for measuring error,of a specific empiricaltest method(Test Method D323)for measuring the vaporpressure of gasoline and other volatile products.3.1.5 vapor pressure,npressure exerted by th
